What concentration of ozone is sometime used

Assignment Help Civil Engineering
Reference no: EM13555136

What concentration of Ozone is sometime used as a disinfectant for drinking water. Ozone is highly reactive it will react benign species found in water, as well as the pathogens it is intended to kill. It found that ozone reaction in water nearly follows first-order kinetics in ozone concentration, such as that its concentration decreases by 50 percent in 12 minutes (t1/2 = 12 min). A water supplier wants to inject ozone into a piper bringing water to the water treatment plant to predisinfect the influent. The 3.0-ft diameter piper is 3,400 feet long with a steady flow rate of 10,000 gal/minozone (in mg/L) should be Injected at the head of the piper so what there will be an ozone concentration of 1.0mg/L at the piper’s exit into the plant? The piper may be realistically assumed to act as an ideal PFR.

Reference no: EM13555136

Questions Cloud

How long will it take for consolidation of a similar clay : A clay specimen, 1 in thick (drained on top and bottom), was tested in the laboratory. For a given load increment, the time for 50% consolidation was 5 min 20 sec. How long will it take for 50 % consolidation of a similar clay layer in the field that..
Compute the gravimetric water content : A sample of clay was obtained from a point below the water table. An oven-drying test performed on this sample resulted in the following data:
Calculate air-dry moisture content : The weight of a sample of coarse aggregate was measured under various conditions with the following results:
What would be the difference in average annual water require : If 100 acres of farmland were developed for urban housing (four houses per acre), what would be the difference in average annual water requirements after the change over? Assume that the irrigation requirement is 2.5 acre-ft of water for a growing se..
What concentration of ozone is sometime used : What concentration of Ozone is sometime used as a disinfectant for drinking water. Ozone is highly reactive it will react benign species found in water, as well as the pathogens it is intended to kill. It found that ozone reaction in water nearly fol..
What features might you look for on the fracture surfaces to : Manufacturing process that unintentionally introduces cracks to the surface of a part was used to produce load-bearing components. The design requires that the component be able to withstand a stress of 450 MPa. The component failed catastrophically ..
What is the maximum weight of the paddlers and other gear : A simple "box-like" canoe has outer dimensions of 15.0 ft in length, 2.0 ft in width, and 1.0 ft in depth. The canoe shell is made of concrete with a specific weight of 58.0 lbs/ft^3 and contains 15.0 lbs of steel reinforcement with negligible volume..
Estimate the average hourly average daily and minimum hour : Estimate the average hourly, average daily, and minimum hourly residential sewage flows from an area serving a population of 1500 people. Assume that the lenghth of sewer and house drains equals 3.0 km and that infiltration occurs
Compute the monthly payment for the loan : Your company is considering the purchase of new earth moving equipment. The total purchase is $240,000 and we pay with $100,000 cash and borrow the rest. (12% per year nominal, compounded monthly for 5 years). The machines last for 7 years and will b..

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine what is the overflow rate of each tank

two sedimentation tanks operate in parallel. The combined flow to the two tanks is .1 m^3/s. the depth of each tank is 2 m and each has a detention time of 4 h.

  Calculate the distance between two successive crests

A photograph is taken of a transverse wave travelling along a length of rope. At this instant the shape of the wave is described by y = (2 m) sin ((0.8 rad.m-1)x+0.8 rad). The speed of the wave is 2 m/s. Calculate the distance between two successi..

  Determine all components at the reactions at the pin support

The compound beam assembly shown is made up of 4 members connected by pins and is supported by hinges/pins at A and E. L= 2.6m (L is the lengthD to E) , and w= 60 (w is the load-lines) .

  Determine the gram molecular weight of air

The partial pressure of the gasses in a 22,414-L volume of air at STP are: oxygen, 21,224 kPa; nitrogen, 79,119 kPa; argon, 0.946 kPa; and carbondioxide, 0.036 kPa. Determine the gram molecular weight of air.

  Determine what is the magnitude and direction of the force

what is the magnitude and direction of the force of the water n the nozzle, if the nozzle is held steady/2- what is the FORCE if the fire fighter is running towards the fire, with the hose at a velocity of 1.5 m/s

  What is the difference in water levels between reservoirs

A wrought iron water line connecting two reservoirs at 20°C has a length of 1500 m, a diameter of 75 cm, two elbows (90º, long-radius, flanged), a fully open gate valve, and a reentrant pipe entrance.

  Use dynamic programming to determine an optimal production

An electronics firm has a contract to deliver the following number of ratios during the next three months; month 1, 200 radios; month 2; 300 radios; month 3, 300 radios. For each radio produced during months 1 and 2, a $10 variable cost is incurred; ..

  How much was the initial investment at an interest rate

A company that manufactures regenerative thermal oxidizers made an investment 10 years ago that is now worth $1,300,000. How much was the initial investment at an interest rate of 15% per year (a) simple interest and (b) compound interest?

  Find the velocity of the air downstream of the restriction

Find the velocity of the air downstream of the restriction, and show that the enthalpy is essentially the same before and after the throttling process. Also find the change of entropy.

  How many inches should the channel drop in 350feet of length

design a concrete (n = 0.013) channel that will convey 50,000 GPM. It is to be a trapezoidal in cross section with a bottom width of 7.5 feet. The side slopes are to be 1.33:1 (H:V) and it is desired to have the depth of flow constant at 2.0 feet.

  What is the maximum external pull in each of the 4 gears

If a tractor with 23-hp, a max speed of 3.6 mph in 1st gear and an effieiciency of 92% is operated operated down a 4% slope and the rolling resistance is 80 lb/ton, what is the maximum external pull in each of the 4 gears.

  What is the runoff rate into the inlet grate

If the detention storage on the paved section is increasing at the rate of 60 m3/hr, what is the runoff rate into the inlet grate?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd