Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
1. (a) What are the rated current and internal generated voltage of this generator?
(b) What field current does this generator require to operate at the rated voltage, current, and power factor?
2. What is the voltage regulation of this generator at the rated current and power factor?
3. If this generator is operating at the rated conditions and the load is suddenly removed, what will the terminal voltage be?
4. What are the electrical losses in this generator at rated conditions?5. If this machine is operating at rated conditions, what input torque must be applied to the shaft of this generator? Express your answer both in newton-meters and in pound-feet.
For PID control, what are roles of integral term and derivative term. Given KP=10, KI=3, and KD=4, write down this PID controller function.
The counter must stop at a value which is defined by using the 8 slide switches. Use the discrete LEDs as the output to validate the counter. The counter should run when a push button ‘run' is being pressed.
A sequential circuit hast two inputs (X1 and X2) and one output (Z). The output begins as 0 and remains a constant value unless one of the following inputs sequences occur: (a) The input sequence X1X2 =01,00 causes the output to become 0
In doing so, they learned through laboratory studies that the maximum growth rate of the bacteria will be 0.66 day -1 and that the half-saturation constant will be 64.5 mg L-1.
The address field of the instruction (stored at W + 1) is designated by the symbol Y. The operand used during the execution of the instruction is stored at the effective address symbolized by Z. An index register contains the value X.
Two identical CS amplifiers are connected is cascade. First stage is fed with a source Vsig having a resistance Rsig = 100k Ohm. A load resistance Rl = 10k Ohm is connected to the drain of the second stage.
The toggle switch has been closed for two minutes. During the first 15 seconds after the closing of the toggle switch, pushbutton I2 was pressed four times. Describe what the status of the motor and the pilot light (PL) will be at the two minute m..
What is the minimum number of pins required for a socalled dual-op-amp IC package, one containing two op amps What is the number of pins required for a so-called quad-opamppackage, one containing four op amps
Write a program for the dragon 12 so you can manipulate all four 7-segment LEDs:You will be able to enter any number or any sequence and be able to display them on the LED's each for one digit, and when you enter a sequence of 4 specific numbers
Write an assembly language program that initialize data X to 0, and then when input device inputs data it is added to X and when output device asks for data the value of X is output. a) Use Programmed I/O Mode of data transfer for inputting and out..
You will find the Oscilloscope and Current Probe instruments in the Simulate menu. To save on ink, click Reverse on the oscilloscope output window. Cut and paste your circuit diagram and oscilloscope output into a document
All FSMs have an initial state and the FSM must be forced in to that initial state prior to processing any data inputs. Suppose you want to implement a 5-state FSM in a PAL16R4. Briefly describe how you would force the FSM into its initial state.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd