What are the critical properties that allow for the function

Assignment Help Civil Engineering
Reference no: EM13300751

Consider the components that are required for an automobile. List 5 components and identify the class of material that is used for each component. What are the critical properties that allow for the function of the material in that application?

Reference no: EM13300751

Questions Cloud

State must be the velocity in m/s of a beam of electrons : What must be the velocity, in m/s, of a beam of electrons if they are to display a de Broglie wavelength of 1 nm? (the mass of an electron is 9.109x10 -28 g)
Determine the elastic and plastic section modulus of i-beam : Determine the elastic and plastic section modulus of the I-beam. The axis runs through the center of the beam on both x and y axis (completely symmetrical). Beam properties: h= 12inches tf= 0.5 inches bf= 6 inches tw= 0.25 inches
What value of charge is on each capcitor : A 10-uF, a 20-uF, and a 50-uF capacitor are connected in series across a 160 volt source. What value of charge is on each capcitor
Low birth weight infants : Low birth weight (LBW) infants: Which of the following is true, all else the same.
What are the critical properties that allow for the function : Consider the components that are required for an automobile. List 5 components and identify the class of material that is used for each component. What are the critical properties that allow for the function of the material in that application
Compute the critical angle for liquid when surrounded by air : A beam of light is incident from air on the surface of a liquid. find the critical angle for the liquid when surrounded by air
Little of an essential nutrient or exposure to toxins : What term is given to the time period during which irreversible damage to the fetus may occur from specific events such as too little of an essential nutrient or exposure to toxins?
Compute the percent ionization of arsenous acid : Calculate the percent ionization of arsenous acid (H3AsO3) in solutions of each of the following concentrations (Ka = 5.1e-10.) (a) 0.217 M % (b) 0.598 M % (c) 0.726 M %
Calculate the stress at failure of a concrete test cylinder : Calculate the stress at failure of a concrete test cylinder with a measured diameter of 152.4 mm and a recorded load of 371,426N. Units of ksi.

Reviews

Write a Review

 

Civil Engineering Questions & Answers

  Calculate air velocity and mass flow rate through the slit

the room described in problem 8.1 gas a 1 m wude door with a 1 cm high slit at the floor level. THe oil spill has a rectagular area of sides 0.5 m by 0.5 m. (a) calculate the pressure increase, the air velocity, and the mass flow rate throug the sl..

  Convert all quantities to si units then convert it to mph

Assume the plane is flying at an altitude of 32,810 ft (10 km), where the temperature is -8 C and the pressure is 250 mb. The Pitot-static tube measures a piezometric pressure difference corresponding to 1.206 psi. What is the airspeed in both m/s..

  Calculate the ifov corresponding to the spatial resolution

LANDSAT as a spatial resolution of 15m and an altitude of 700km. IKONOS has a spatial resolution of 1m and an altitude of 680km. Calculate the IFOV corresponding to the spatial resolution for sensor.

  Value of the kinetic energy correction coefficient

Assuming that the velocity variation within the main channel and the floodplain subsections is much smaller than the change in mean velocities between subsections, find the value of the kinetic energy correction coefficient.

  Concentration and precipitate

AGNO 3 is added to a solution containing 0.001 mol Cl - amd 0.001 mol Br- per liter.What are the concentrations of Cl - and Br- remaining when AgCl just begins to precipitate?

  Determine the horizontal spacing of the vertical drain

determine the horizontal spacing of the vertical drains if the drains are installed in triangular grid to reach 90% of primary consolidation in 1.5 years after the commencement of fill placement

  What is value of combined detention and interception storage

During a 108 minute long storm, the precipitation rate over a 100 acre area is 1.65 in/hr. The phi index is 0.42 in/hr. The average outflow from the area is 92 cfs during the storm. What is the value of combined detention and interception storages ..

  Find dry unit weight of the sample and water content

An undisturbed soil sample was collected in a sampling tube of internal diameter 5cm. The length of the extracted sample was 10.2 cm and its mass was 360 g. After oven drying the mass reduced to 326.5 g.

  Derive eq for reaction force associated with conversation

Derive an equation for the reaction force (Rx) associated with conservation of momentum in a straight length of pipe of uniform diameter. Approximate the velocity as steady and uniform at each cross-section, and the fluid as constant density.

  Two immiscible fluids are in contact

Two immiscible fluids are in contact. Fluid I is denser and is also well mixed. The concentration of species a is cao everywhere within this fluid and the temperature in fluid I is held constant at To.

  Estimate the area of circle using the lower and upper bounds

Write a simple MATLAB program that will estimate the area of a circle using the lower and upper bounds (using triangles). The user will input the diameter of the circle and the desired accuracy (relative error ) and the program must run

  Calculate the factor of safety and deformation

A 1 cm diameter, 0.4 m long steel rod is to be used in an application where it will be subjected to an axial tensile force of 15kN. The factor of safety based on yield stress must be at least 1.5, and the axial deformation must not exceed 2 cm.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd