What additional power can be saved

Assignment Help Other Engineering
Reference no: EM131019463

A collection of logic gates for which the static power dissipation is zero, and the dynamic power dissipation is 10 mW is operating at 50 MHz with a 5-V supply. By what fraction could the power dissipation be reduced if operation at 3.3 V were possible? If the frequency of operation is reduced by the same factor as the supply voltage (i.e., 3.3/5), what additional power can be saved?

Reference no: EM131019463

Questions Cloud

What is the maximum number of units of butter macroland : Suppose Macroland is currently producing 40 guns. What is the maximum number of units of butter Macroland can produce if it continues to produce 40 guns
What reductions in maximum operating frequency : To reduce its dynamic power dissipation, operation at 1.8 V is considered. It is found, however, that the currents available to charge and discharge load apacitances also decrease. If current is (a) proportional to VDD or (b) proportional t V2 D..
Discuss the various ways that hazardous chemicals can enter : List the six major categories of occupational illnesses,m and give three examples of each. What are some methods that can ve used to control potential exposures in the workplace?
Calculate the corresponding delay-power product : A particular logic gate has tPLH and tPHL of 30 ns and 50 ns, respectively, and dissipates 1 mW with output low and 0.6 mW with output high. Calculate the corresponding delay-power product (under the assumption of a 50% duty-cycle signal and negle..
What additional power can be saved : A collection of logic gates for which the static power dissipation is zero, and the dynamic power dissipation is 10 mW is operating at 50 MHz with a 5-V supply. By what fraction could the power dissipation be reduced if operation at 3.3 V were pos..
Graph line containing given pair of points and find slope : Graph the line containing the given pair of points and find the slope. Is the system consistent or inconsistent? Are the equations dependent or independent?
Find equivalent capacitance at the output node of inverter : In a particular logic-circuit technology, operating with a 3.3-V supply, the basic inverter draws (from the supply) a current of 60 μA in one state and 0 μA in the other. When the inverter is switched at the rate of 100 MHz, the average supply cu..
Describe a few symptoms of the disease : Describe an autoimmune disorder, other than multiple sclerosis, colorectal cancer, psoriasis, asthma, respiratory syncytial virus infections, Crohn's disease, and rheumatoid arthritis.
What is the power dissipated in the chip : If the inverter is operated from a 1.8-V power supply, find the energy needed to charge and discharge the load capacitance. If the IC chip has 2 million of these inverters operating at an average switching frequency of 1 GHz, what is the power dis..

Reviews

Write a Review

Other Engineering Questions & Answers

  Determining the average convection coefficient

Consider the effects of radiation, as well as convection, and express your result in terms of the velocity, thickness, and properties of the sheet (V, d, p, cp, e), the average convection coefficient hw associated with the cross flow, and the envi..

  Developing the solar energy

RENEWABLE ENERGY RESOURCES in general and why it start used and its developing after that choose the solar energy and make it like case study and give full technical data about.

  Find in the epidural space along the vertebral column

Find in the epidural space along the vertebral column?the inner and longer of the two bones of the forearmthe structure of the vertebrate skeleton supporting the lower limbs

  What does the transfer function become

The high-frequency response of a direct-coupled amplifier having a dc gain of -1000 V/V incorporates zeros at ∞and 104 rad/s (one at each frequency) and poles at 103 rad/s and 105 rad/s (one at each frequency). Write an expression for the amplifier..

  Find the worst-case values of the noise margins

Assuming that the inverter is in the logic-1 state 50% of the time and in the logic-0 state 50% of the time, find the average power dissipation in a typical circuit. The power supply is 5 V.

  What is the total development airflow

Determine the required airflow for diesel dilution at the face of the heading if the requirement is for 0.05 m3/s of air per kW of diesel power and what is the total development airflow

  What is the optimal production plan for jumbo

What is the optimal production plan For Jumbo. assuming no promotion by either Jumbo or Shrimpy'? What are the annual profits for Jumbo?

  Write a proposal for a design of a new technological system

Designing Media Project: You will write a proposal for a design of a new technological system, or new application of an old system. The proposal will describe the system, and the reason for the system

  Determine angular velocity of crate

Assuming that the impact is perfectly plastic, determine the angular velocity of the crate and the velocity of its mass center immediately after the cable becomestaut.

  Write a literature review on electrical conductivity

Write a Literature review on Electrical Conductivity as a Function of Nanoadditive (Carbon Based) in Biopolymer. The paper should be 5-6 pages, APA, double spaced, with at least 30-40 sources.

  Configurations for controlled and uncontrolled rectification

Understand common configurations for controlled and uncontrolled rectification and understand common configurations for controlled and uncontrolled rectification

  Define stripping ratio and give three examples

Define stripping ratio and give three examples of the units it may be expressed in.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd