Volume operating at steady state with a volumetric flow rate

Assignment Help Mechanical Engineering

Reference no: EM13708850

Steam at 120 bar and 520 ?C enters a control volume operating at steady state with a volumetric flow rate of 460 m3/min. Twenty-two percent of the entering mass flow exits at 10 bar, 220 ?C and a velocity of 20 m/s. The rest exits at another location with a pressure of 0.06 bar, a quality of 86.2 % and a velocity of 500 m/s. determine the diameters of each exit in m, assuming they are circular.

Reference no: EM13708850

Questions Cloud

Determine the maximum mass flow rate of the steam : A turbine uses steam at 25MPa and 650°C at the turbine inlet to generate 17.5MW of power. The steam enters the turbine at a rate of 90000kg/h. A portion of the steam passing through the turbine is removed for the purposes of feedwater heating (Figure..

Actual rate of heat extraction from the outside air : A heat pump uses refrigerant-134a to extract heat from the outside air at -10°C to maintain a house at 15°C.The refrigerant enters the condenser at 600kPa and 25°C at a rate of 45L/min and leaves as a saturated liquid at 600 kPa. The compressor consu..

Material of the spine and the heat transfer coefficient : A spine attached to a wall maintained at a uniform temperature Tb has the shape of a circular cone with base diameter b, height L and a concave parabolic profile, and it is exposed to a fluid at a uniform temperature T?.

Explain the impact of culture on business practices : Explain the impact of culture on business practices in an international organization and evaluate the challenges of doing business in another culture - Describe different meanings and dimensions of culture and analyze how people ,groups, and societ..

Volume operating at steady state with a volumetric flow rate : Steam at 120 bar and 520 ?C enters a control volume operating at steady state with a volumetric flow rate of 460 m3/min. Twenty-two percent of the entering mass flow exits at 10 bar, 220 ?C and a velocity of 20 m/s. The rest exits at another location..

Dry-bulb temperature of the air as it exits the heating coil : In a heating/humidifying system moist air first flows through a heating coil and then through an air washer. The air enters the system at 55 °F dry-bulb temperature and 40 % relative humidity. The air exits the system at 90 °F dry-bulb temperature an..

Determine the final temperature for this adiabatic process : An insulated piston cylinder device contains the R-134a at 600 KPa with quality 95%, the volume at this state is 0.3 m^3. The piston then expands until it is a saturated vapor. During that process, 100 KJ of work is done. Determine the final temperat..

What is the final total enthalpy of the water : A liquid/vapor water mixture with 2.7 lbm and a pressure of 1000 psia is heated at constant pressure until the temp is 600ºF. What is the final total enthalpy of the water, in BTUs?

What is the local heat flux : Laboratory measurements of water flowing across a flat plate indicate a local shear stress of 2.3 Pa. the free-stream velocity of the water is 5 m/s. If the free-stream & plate temperature are 15 C & 60 C, respectively, what is the local heat flux?

User Account

All Pages