Two spheres are hanging from cords

Assignment Help Mechanical Engineering
Reference no: EM13707356

Two spheres are hanging from cords. The distance from the ceiling to the center of each sphere is 2m, and the coefficient of restitution is 0.75. If sphere “A” (mA = 2kg) is drawn back 60o and released from rest, determine:

a) The maximum angle? B, that sphere “B” (mB = 3kg) will swing through as a result of the impact.

b) The angle? A, that sphere “A” will rebound as a result of the impact.

Reference no: EM13707356

Questions Cloud

Calculate delta velocity-semi-major axis for transfer orbit : Calculate the change in velocity required in changing the position of a satellite in an orbit by 90 degrees. The initial and final orbit is circular around the Earth with a 15000 km radius. Calculate the delta velocity, semi-major axis and period for..
What cooling capacity is provided per kg-propane circulated : An ordinary vapor compression cycle using propane operates at temperatures of 240 K in the cold heat exchanger, and 280 K in the hot heat exchanger. How much work is required per kg of propane circulated in the compressor is 80% efficient? What cooli..
Determine the equation for the streamlines : The x and y components of velocity for a two-dimensional flow are u = 5y ft/s and v = 4 ft/s, where y is in feet. Determine the equation for the streamlines. Use C as constant. Round all numbers in answer to 3 significant digits.
Kevlar canoe of the same size carrying the same load : How much extra water does a 147-lb concrete canoe displace compared to an ultra-lightweight 40-lb Kevlar canoe of the same size carrying the same load?
Two spheres are hanging from cords : Two spheres are hanging from cords. The distance from the ceiling to the center of each sphere is 2m, and the coefficient of restitution is 0.75. If sphere “A” (mA = 2kg) is drawn back 60o and released from rest,
What is the gain required for the same situation : The voltage output from a 0–50 psi pressure transducer will vary from 0–5 mV. The input/output relationship is linear. The signal will be recorded with a 12-bit A/D converter with a 0-10 V input range. The voltage output needs to be amplified before ..
Determine horizontal-vertical components of reaction at vpin : The device is used to hold an elevator door open. If the spring has a stiffness of k = 50N/m and it is compressed 0.17m, determine the horizontal and vertical components of reaction at the pin A and the resultant force at the wheel bearing B.
Determine the changes in the enthalpy and entropy of steam : Steam at 500oF and 50 psi is fed at the rate of 1 lbm/sec to an adiabatic compressor where its pressure is raised reversibly to 650 psia. Use data from the steam table to determine the changes in the enthalpy and entropy of the steam in the compressi..
Determine the minimum molar flow rate of the cooling water : A total condenser is to be designed for condensing saturated 2-butanol vapor to form saturated 2-butanol liquid at 1 atm at the rate of 0.72 kmol/h. The saturation temperature of 2-butanol vapor at 1 atm is 99.6C. Cooling water at 25C and 1 atm is av..

Reviews

Write a Review

 

Mechanical Engineering Questions & Answers

  In the refrigeration cycle the evaporator operates at 10oc

a rankine cycle is used to generate electricity with a total plant capacity of 65 mw. heat from the condenser is

  Determine l in cm if the manometer liquiud is mercury with

a if the pressure in the tank is 1.5 bar and atmospheric pressure is 1 bar determine l in m for water with density of

  External effects other then gravitational force cont

How can we rotate a disc hanged with weights freely without external effects other then gravitational force cont?

  Determine mud height at which blocks will overcome friction

Mud is stopped using a wall made from 1.2 m high x 0.25 m wide rectangular concrete blocks as shown in figure below. Blocks density is 2700 kg/m3, mud density is 1800 kg/m3, and friction coefficient between ground and concrete blocks is f = 0.3.

  Find mass flow rate through the boiler power produced by

a steam rankine cycle operates between pressure limits of 2500 psia in the boiler and 1psia in the condenser. the

  A golfer hits a golf ball with an initial velocity of 160

a golfer hits a golf ball with an initial velocity of 160 fts at an angle of 25deg with the horizontal. knowing that

  Calculate number of vacancies per cubic meter in some metal

Calculate the number of vacancies per cubic meter in some metal at 763°C. The energy for vacancy formation is 0.79 eV/atom, while the density and atomic weight for this metal are 4.77 g/cm3 and 88.45 g/mol, respectively.

  Determine the vertical component of the average impulsive

why do we not take into account the normal forces or the frictional forces acting on the jumper when determining the

  Determine the fraction of the throttle mass flow that

consider a regenerative rankine cycle with a 600c and 4-mpa throttle a 5-kpa condenser and an open feedwater heater at

  If the velocity varies linearly from one plate to the other

consider two flat plates seperated by a distance of 0.25 in. in this application castor oil is used as a lubricant. the

  Two suppliers manufacture a plastic gear used in a laser

two suppliers manufacture a plastic gear used in a laser printer. the impact strength of these gears is measured in

  An air conditioner running with r-134a on a cycle executed

an air conditioner running with r-134a on a cycle executed under the saturation dome between the pressure limits of 0.8

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd