Tube material and compressive load

Reference no: EM1385592

Given that E for the tube material is 70 GN/m2 and the stool legs are 75cm long, how much will each leg shorten under the applied compressive load (take g = 9.8m/s2)

Reference no: EM1385592

Questions Cloud

Establishing a horizontal distance : A tape is calibrated and found to measure 100.04ft between the 0- and 100-ft marks. What measurements should be laid out to establish a horizontal distance of 682.25ft?

Write set of token types returned by lexical analyzer : Write down the set of token types to be returned by your lexical analyzer. Describe regular expressions for this set of token types.

Physician assisted death : Is physician assisted death (i.e. Oregon's Death with Dignity Act) morally different from many forms of euthanasia? If so, what makes it ethically different from the various forms of euthanasia?

What distance downstream-water contaminated by fatal levels : For what distance (in km) downstream is the water contaminated by fatal levels of the pesticide by the time the container is empty?

Tube material and compressive load : Given that E for the tube material is 70 GN/m2 and the stool legs are 75cm long, how much will each leg shorten under the applied compressive load (take g = 9.8m/s2)

Bombing of hiroshima and nagasaki : In 1945, Japan: a. surrendered before the Soviet Union declared war on it. b. was not warned that it might be destroyed if it did not surrender. c. finally agreed to terms of unconditional surrender. d. showed no sign of surrendering unconditionally ..

Calculate the vertical displacement : The radius of the arch is 10m and it is subjected to a vertical load of 10kN at the point C. Ignoring both axial and shear deformations and using the unit force method, calculate the vertical displacement of joint B.

Force maintain to maintain equilibrium : is located 6' from the left support, and a uniformly distributed load of 200 lbs./lin. ft. begins 6' to the right end of the member. What force must be applied at each connection to maintain equilibrium?

Determine the normal and shear stresses : The grains of wood in the board make an angle of 20 degrees with the horizontal as shown. Determine the normal and shear stresses that act perpendicular and parallel to the grains if the board is subjected to an axial load of 250 N.(Dimensions l=3..

User Account

All Pages