Throttled from saturated liquid state

Assignment Help Mechanical Engineering
Reference no: EM13711528

Refrigerant-134a is throttled from saturated liquid state at 7 bar to a pressure of 1.4 bar. Determine the temperature drop during this process and the final specific volume.

Reference no: EM13711528

Questions Cloud

Determine the change in internal energy : 1 /2kg of a liquid-vapor water mixture in a rigid tank initially at 2 bar is heated by 120V heater for 5 minutes until it becomes a saturated vapor at 4 bar. Changes in kinetic and potential energies can be ignored.
Contribution of grain boundary strengthening in an alloy : Nan crystalline materials have grain sizes ranging from 0.01 to 0.1 microns. If the contribution of grain boundary strengthening in an alloy with grains of 0.1 microns is 20 MPa, what would you expect it to be if the grain size were reduced to 0.01 m..
Calculate the density and approximate modulus : A volume fraction f = 0.2 of silicon carbide (SiC) particles is combined with an aluminium matrix to make a metal matrix composite. The modulus of particle reinforced composites lies very close to the lower bound of Young's modulus for a composite.
Determine the mixture temperature leaving the mixing chamber : In air-conditioning systems, streams of cold and warm air are mixed to get air with the right temperature. Consider a mixing chamber into which cold air enters at 8C and 100 kPa at a rate of 0.55 m^3 /s and warm air enters at 300C and 100 kPa. The ra..
Throttled from saturated liquid state : Refrigerant-134a is throttled from saturated liquid state at 7 bar to a pressure of 1.4 bar. Determine the temperature drop during this process and the final specific volume.
Calculate the coefficient of performance of the heat pump : A heat pump supplies 40 kW of heat to maintain the inside of a house at 250C in cold winter months when the ambient temperature is 00C. Power required to operate the heat pump cycle is provided by a heat engine cycle which receives 10 kW of heat from..
What is the volume occupied by each gas at equilibrium : An insulated rigid container is separated into two parts using a partition that is free to move and the partition allows heat transfer without any energy storage by itself. Initially 2 kg of air at 5 bar and 350 K is contained on one side of the part..
The pressure is maintained constant in the cylinder : A piston-cylinder device contains 12 kg of saturated R-134a vapor at 3.2 bars. An electric source supplies 8 A current to a resistor within the cylinder for 4 minutes and there is heat transfer of 400 kJ to the system. During these energy interaction..
Velocity of the fluid at the nozzle exit : Show that the thrust developed by a stationary rocket motor is F = rho*A*U^2 + A(p- p_atm) where p_atm is the atmospheric pressure, and p, rho, A, and U are, respectively, the pressure, density, area, and velocity of the fluid at the nozzle exit.

Reviews

Write a Review

 

Mechanical Engineering Questions & Answers

  A man is driving his classic 1957 corvette on a circular

a man is driving his classic 1957 corvette on a circular path of radius r. the corvettes distancealong the paths

  Steam enters diffuser operating steady state with pressure

Steam enters a diffuser operating at steady state with a pressure of 14.7 psi, a temperature of 300F, and a velocity of 500ft/s. Steam exits the diffuser as a saturated vapor with negligible kinetic energy. Heat transfer occurs from the steam to its ..

  Refraction of a light beam at the interface of two media

The following is a diagram shows refraction of a light beam at the interface of two media. The incidence and refraction angles are measured to be 45 deg and 30 deg respectively. Will total reflection happen when the light beam shins from the top to t..

  Explain the stage efficiency

Steam at 15 bar and 350 degrees C is expanded through a 50% reaction turbine to a pressure of 0.14 bar. The stage efficiency is 80% for each stage and the reheat factor is 1.05.

  Determine a the maximum temperature in the cycle b the net

a four-cylinder four-stroke 2.8-liter compression-ignition engine operates on the ideal dual cycle with a compression

  What is the force acting on the penny in this case assume

a 2011 penny is thrown into a pool of water for luck. what is the force acting on the penny if it lands horizontally on

  State the final form and the constants of the controller

1.find an example of a feedback control system from suggested textbooks. some of the examples can be given belowbulldc

  A privately owned summer camp has the following data for a

a privately owned summer camp has the following data for a 12-week sessioncharge per camper 480 per weekfixed costs

  For operation at steady state determine the net power input

a refrigeration cycle has a coefficient of performance equal to 75 of the value for a reversible refrigeration cycle

  A 03 kg softball has a velocity of 15 ms at an angle of

a 0.3 kg softball has a velocity of 15 ms at an angle of 35deg below the horizontal just before making contact with the

  Is there a good calculation model for the material flow

Is there a good calculation model for the material flow through a combine harvester related to the harvesting speed?

  In an orthogonal cutting operation the chip velocity was

in an orthogonal cutting operation the chip velocity was determined using a laser doppler velocimeter ldv as 80 of the

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd