Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Steam is produced at 70 bar and some unknown temperature. A small amount of steam is bled off just before entering a turbine and goes through an adiabatic throttling valve to atmospheric pressure. The temperature of the steam exiting the throttling valve is 400C. The unthrottled steam is fed into the turbine, where it is adiabatically expanded to atmospheric pressure.
A) What is the temperature of the steam entering the turbine?
B) What is the maximum work per kilogram of steam that can be obtained using the turbine in its present mode of operation?
C) Tests on the turbine exhaust indicate that the steam leaving is a saturated vapor. What is the efficiency of the turbine and the entropy generated per kilogram of steam?
D) If the ambient pressure is 25 C and the ambient pressure is 1 bar, what is the maximum possible work that could be obtained per kilogram of steam in any continuous process?
a piston-cylinder assembly contains propane initially at 27degc 1 bar and a volume of 0.2 m3. the propane undergoes a
a fluid with a specific volume of 0.0012 m3kg flows at a velocity of 400 mmin through a 6 cm diameter pipe. further
air enters the duct of an air-conditioning system at 15 psia and 50f at a volume flow rate of 450 ft3min. the diameter
a 2-kg block of ice with an initial temperature of -20f is dropped into an insulated tank containing 10-kg of liquid
helium gas is compressed reversibly from 16 psia and 85 degree f to 120 psia. the helium enters the compressor with a
air enters the compressor of a regenerative gas-turbine engine at 300 k and 100 kpa where it is compressed to 800 kpa
water at atmospheric pressure boils on the surface of a large horizontal copper tube. the heat ?ux is 90 of the
A cylindrical oil-storage tank, whose diameter is 120 ft, is 60 ft deep when it is fully filled with an oil of density 55lbm/ft³. Its top is open to the atmosphere. What is the gauge pressure (psig) at the bottom of this tank?
A 1 foot long cylindrical rod with a diameter of 0.25 inch is subjected to a tensile load of 1,500 lbs. Suppose the rod was elongated 0.01 inch under this load, what is the stress and strain created by the load? What is the Young’s Modulus of the mat..
cooling water circulates through a water jacket enclosing a housing filled with electronic components. at steady state
an 8-in. id 20.32 cm pipe is connected by means of a reducer to a 6-in id pipe. kerosene flows throught the system at
in a cogeneration scheme a diesel engine-generator is used. the diesel engine-generator is rated at 2000 kwe. the
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd