Temperature and pressure are introduced to the pipleline

Assignment Help Chemical Engineering
Reference no: EM13895082

Problem 2: Methane containing 4 mol% N2 is flowing through a pipleline at 105.1 kpa and 22 °C. To check this flow rate, N2 at the same temperature and pressure are introduced to the pipleline at the rate of 2.83 m3/min. At the end of the pipe (where the mixing has completed), N2 concentration is found to be 4.82 mol%. What is the volumetric flow rate of the original feed (before the addition of N2) in m3/min? 

Reference no: EM13895082

Other gases by preferential absorption into amine solution

Carbon dioxide can be separated from other gases by preferential absorption into an amine solution. The carbon dioxide can be recovered by heating at atmospheric pressure. Sup

Who should make the decision

If the family of a patient in the intensive care unit submits the individual's living will document, should it be honored immediately or should there be a discussion between

Fragility versus loads and fire explosion safety issues

Risk Analysis and Management: Fragility versus Loads and Fire Explosion Safety Issues, 1. A propane tank is located 100 m away from the nearest buildings. The fragility to exp

A heat pump that takes in 256 kw

You have a heat pump that takes in 256 kW of heat and puts out 604 kW of heat. What is the coefficient of performance (C.O.P.) of the system ( express this value as a fraction

Determine which material of construction would be used

A process for sulfonation of phenol requires the use of a 3000-gal storage vessel. It is desired to determine the most suitable material of construction for this vessel. The

Find the width of the rankine oval

Find the width (in the x-direction) of the Rankine oval created by the flow, and the pressure difference between a point at infinite distance upstream and the point of coord

Estimate the plate thickness required at the base of tank

The maximum liquid level in the tank will be at 16 m. Estimate the plate thickness required at the base of the tank. Take the allowable design stress for aluminum as 90 N/mm

Calculate the magnetic flux density at the center of gravity

Magnetic flux density due to filamentary currents. A current I flows in a conductor shaped as an equilateral triangle (Figure 8.27). Calculate the magnetic flux density at t

Reviews

Write a Review

 
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd