Slant shear test is widely accepted for evaluating the bond

Assignment Help Physics
Reference no: EM13543471

The slant shear test is widely accepted for evaluating the bond of resinous repair materials to concrete; it utilizes cylinder specimens made of two identical halves bonded at 30°. For 12 specimens prepared using wire-brushing, the sample mean shear strength (N/mm2) and sample standard deviation were 19.06 and 1.74, respectively, whereas for 12 hand-chiseled specimens, the corresponding values were 24.6 and 3.96. Does the true average strength appear to be different for the two methods of surface preparation? Test the relevant hypotheses using a significance level of .05. (Give ? to exact integer and t to 2 decimal places.)

a.) ? = ?

b.) t (?wire - ?hand) = ?

Reference no: EM13543471

Previous Q& A

  Carpal tunnel syndrome problem

Quantitative noninvasive techniques are needed for routinely assessing symptoms of peripheral neuropathies, such as carpal tunnel syndrome (CTS). An article reported on a test that involved sensing a tiny gap in an otherwise smooth surface by prob..

  Find the velocity of each block after they have moved apart

Blocks A (mass 6.50kg ) and B (mass 15.00kg ) move on a frictionless, horizontal surface. Initially, block B is at rest and block A is moving toward it at 10.0m/s . The blocks are equipped with ideal spring bumpers. The collision is head-on, so al..

  Find the velocity of first glider after the collision

On an air track, a 398.0 g} glider moving to the right at 2.05 m/s} collides elastically with a 501.5 g} glider moving in the opposite direction at 3.20 m/ s} .

  Find the final kinetic energy of first glider

A 0.300 kg} glider is moving to the right on a frictionless, ­horizontal air track with a speed of 0.900 m/s} when it makes a head-on collision with a stationary 0.150kg} glider. Find the final kinetic energy of first glider.

  What was the initial speed of the bullet

A 4.50 g} bullet is fired horizontally into a 1.10 kg} wooden block resting on a horizontal surface. The coefficient of kinetic friction between block and surface is 0.200. The bullet remains embedded in the block, which is observed to slide 0.200..

  What is mechanical energy of system and spring constant k

A 1.00 kg block Is resting against a light, compressed spring at the bottom of a rough plane inclined at an angle of 30 degrees. Kinetic friction between box and plane is 0.100. Suppose the spring is compressed 10 cm from its equilibrium length.

  What was the speed of puck a before the collision

On a frictionless, horizontal air table, puck A (with mass 0.150kg} ) is moving toward puck B (with mass 0.350kg} ), which is initially at rest. After the collision, puck A has a velocity of 0.120m/s to the left, and puck B has a velocity of 0.650..

  Find the kinetic energy of momentum

Find the kinetic energy of a 3.70{\rm kg} cat that has 0.240 kg *m/s}} of momentum. Find the momentum of a 1.22{\rm kg} ball that has 16.0 J} of kinetic energy.

  How fast will the lighter one travel

Two figure skaters, one weighing 625N and the other 775N , push off against each other on very smooth ice. If the heavier skater travels at 1.60m/s , how fast will the lighter one travel?

  Fired directly upward at speed-direction of electric field

A charge of +2?C and 6 mg is fired directly upward at a speed of 500 m/s. The charge reaches the top of its trajectory at 30 m. Ignoring gravity, find the magnitude and direction of the electric field necessary to accomplish this.

Reviews

Write a Review

 

Similar Q& A

  What will be the crate''s speed

Six mass pieces of 100g each are placed on a mass holder of 140g which is hung from a string. Analyse the tension in the string.

  What is the depth of the well

A student uses an audio oscillator of adjustable frequency to measure the depth of a water well. What is the depth of the well

  What would be the magnitude of its acceleration

The loaded cab of an elevator has a mass of 3x10^3 kg and moves 177m up the shaft in 23 s at constant speed. At what average rate does the force from cable do work on the cab.

  Find the resultant force of a tank

Find the resultant force of a tank that is entirely filled with an incompressible fluid and has a piston at end. Side going into take F=100N

  Find what should be the transmission voltage

A transmission line that has a resistance of 0.5omega per km of length is used to transmit 200 MW across 300 miles. what should be the transmission voltage

  What is the speed of the hoop

A hoop and a disk, both of 0.72- m radius and 4.0- kg mass, are released from the top of an inclined plane 2.5 m high and 8.9 m long. What is the speed of the hoop

  Calculate the speed of the hoop

A hoop and a disk, both of 0.48- m radius and 3.0- kg mass, are released from the top of an inclined plane 3.3 m high and 8.3 m long. What is the speed of the hoop

  Calculate final temperature of the water

A 25.0g sample of copper at 363 K is placed in 100g of water at 293 K. Calculate final temperature of the water

  Find what is the maximum mass can be

A 68.0 patient is suspended in a raised hospital bed (angle is 50 degrees). What is the maximum mass can be without the patient sliding up the bed

  Calculate the current at point a in a circuit

A total charge of 100 coloumbs flows past point A in a circuit in 4 seconds. calculate the current at point A

  The skateboarder at the bottom of the ramp

Draw a free body diagram for the skateboarder at the bottom of the ramp

  Find the magnitude of the velocity of the heavier fragment

A 10.0- shell is traveling horizontally to the right at 25.0 relative to the ground when it explodes into two fragments, Find the magnitude of the velocity of the heavier fragment relative to the ground just after the explosion

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd