Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Experimental tests performed on a TWT amplifier results in the data given in Table.
(a) Implement a simulation model for a TWT amplifier specified by the AMto-AM and AM-to-PM data given in Table.
(b) Simulate this model with a 64 QAM input for back offs of -10 and -20 dB and compare the distortion in the signal constellations.
(c) Repeat the simulations for the two-tone input described in Problem and observe the intermodulation components and their power levels as a function of back off.
Problem:-
Derive the complex lowpass equivalent (CPE) model for the cubic nonlinearity of the form
y(t) = x(t) - 0.25 x3(t)
For a two-tone input of equal amplitudes at f1 = 13 Hz and f2 = 15 Hz, find the first-zone output for the band pass case analytically and compute the power levels of the various output components. Simulate the band pass and the LPE models and compare the simulated power levels with the computed power levels. Do this for at least three different sampling rates and compare the results.
Write a function that asks a user it´s name, age and if the user has a spouse. If the user has a spouse, let the function then ask the spouses age. Then let it write out if the user is older, same age or younger then the spouse, and display the ag..
Determine the total entropy production rate for the heat exchanger shown in Figure.- In addition to the air-water heat transfer within the heat exchanger, the air also loses an unknown amount of heat to the surroundings while the water receives an ..
A 1000 MW(e) nuclear power plant has a thermal conversion efficiency of 33%. How much thermal power is rejected through the condenser to cooling water?
A tank of fluid employed in a chemical process is being monitoredwith three sensors. The sensors measure temperature, pressure andfluid level. If all the sensor measurements are in the normalrange, the sensor outputs are low.
Write a Gumnut subroutine that performs the function of the circuit described in Exercise 8.8. The subroutine takes an 8-bit unsigned binary amplitude value in r2 and outputs a corresponding value to an 8-bit register at port address 28, connected..
We wish to improve the speed of the rectifier shown in Fig. 8.22(b) by connecting a diode from node Y to ground. Explain how this can be accomplished.
A platinum resistance coil has a resistance at O0 C of 100 . Determine the change in resistance that will occur when the temperature rises to 30°C if the temperature coefficient of resistance is 0.0039 K-1.
aims of the project1. to determine the energy uses on farms in middle east .2. to determine the best solar cell the use
how much volume is taken up by the cooling system, inside the reactor and the concomitant reduction in reactor production,
What is the value of the capacitance that will give a unity power factor when connected to the load?
Are capacitors economical for releasing the amount of substation capacity?
A transistor amplifier has a midband gain of -120, a high cutoff frequency of 36KHz, and a bandwidth of 35.8 KHz. In addition, the actual response is also about -15 dB at f=50Hz. Write the transfer function Av for the amplifier.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd