Performing both an energy balance and an entropy analysis

Assignment Help Mechanical Engineering
Reference no: EM13712625

By performing both an energy balance and an entropy analysis, calculate the change in entropy when 1 mole of saturated ethanol vapor condenses at its normal boiling point.

Reference no: EM13712625

Questions Cloud

Determine the modulus of composite for inclusion fraction : Consider an isotropic composite in which the spherical particles are silica with an elastic modulus of 80 GPa and a polymer matrix with an elastic modulus of 4 GPa. Determine the modulus of the composite for an inclusion fraction of 20% by volume as ..
Explain how would steel strength be affected : We are concerned about carbon content in steel. It has a direct effect on the yield and tensile strength of what is formed in what is called a hot rolled condition directly from the steel production facility. 1010 steel has a yield strength of 180MPa..
What are the critical contemporary issues : What are the critical contemporary issues related to consumer buying behavior and perceptions?
The diameter of largest solid sphere for lumped behaviour : For plain carbon steel, with properties at 300K in the Appendix and convection (h=50 W/m^2 K) to air at 500K. the diameter of largest solid sphere for lumped behaviour (2 part- show equivalent length is D/6 and that D for Bi
Performing both an energy balance and an entropy analysis : By performing both an energy balance and an entropy analysis, calculate the change in entropy when 1 mole of saturated ethanol vapor condenses at its normal boiling point.
Assume the entire mass within the house : A heat pump with a COP of 3.0 is used to heat an air-tight house. When running, the heat pump consumes 5 kW of power. If the temperature in the house is 5 degrees C when the heat pump is turned on, how long will it take for the heat pump to raise the..
Membrane made of an isotropic material whose elastic modulus : There is a membrane made of an isotropic material whose elastic modulus and Poisson's ratio is E and v, respectively. When this membrane is elongated along x-direction with no lateral deformation in y-direction, the apparent elastic modulus (E') dete..
Find the indicial equation and its roots : Find the indicial equation and its roots. Find the recurrence relation. Use the recurrence relation to find the first three terms of the power series solution corresponding to one root of the indicial equation
Silicon rubber drain hose for surgical procedure : Silicon rubber has a Poisson’s ratio of 0.4. Consider a silicon rubber drain hose for a surgical procedure; the hose has an outer diameter of 4 mm and a wall thickness of 0.5 mm. How much does the lumen (interior space) of the catheter constrict if t..

Reviews

Write a Review

 

Mechanical Engineering Questions & Answers

  Determine the power requirement w and volumetric flow rate

a refrigerator uses a compressor that employs r-134a as the refrigerant. determine the power requirement w and

  Determine torque and power required to rotate inner cylinder

The space between two 6 in. long concentric cylinders is filled with glycerin (viscosity = 8.5X10-3 lb s/ft2). The inner cylinder has a radius of 3 in. and the gap width between the cylinders is 0.1 in. Determine the torque AND power required to rota..

  Assuming the process is adiabatic is this process possible

a vortex tube is used to separate an ideal gas at 10 bar and 375 k such that half the gas is collected in a cool stream

  Determine the exergy transfer accompanying heat and the

air initially at 1 atm and 500degr with a mass of 2.5 lb is contained within a closed rigid tank. the air is slowly

  A solid object of aisi 302 steel at a temperature of 850c

a solid object of aisi 302 steel at a temperature of 850?c is quenched in mineral oil at a temperature of 25?c. the oil

  A heat engine supposedly receives 500 kjs of heat from an

a heat engine supposedly receives 500 kjs of heat from an 1100-k source and rejects 300 kjs to a low-temperature sink

  The products of combustion leave the engine at 750 k and

a gasoline engine delivers 150 kw . the fuel used in c8h18 liq and it enters the engine at 25 c . 150 of theoretical

  Completely drill out the crack with hole

A long rectangular bar 20 mm wide and 10 mm thick made of hot-rolled 4340 carbon steel (Sy = 860 MPa, K1c = 99 MPaÖm), is found to have a centrically located through-thickness crack 8mm wide. Is it best to a) leave the crack alone, b) drill a 5 mm di..

  The initial temperature of the calorimeter is 201 degrees

in the following experiment a constant-pressure calorimeter containing 100 ml of h20 is used.the initial temperature of

  There is no heat transfer between the heater and the

a contact feedwater heater operates on the principle of mixing steam and water. steam enters the heater at 100 psia and

  R-134a is contained in a sealed glass vessel at 50oc as it

r-134a is contained in a sealed glass vessel at 50oc. as it is cooled droplets are noted condensing on the sidewalls at

  A window-mounted room air conditioner removes energy

A window-mounted room air conditioner removes energy by heat transfer from a room and rejects energy by heat transfer to the outside air. The air conditioner cycle requires a power input of 0.434 kW and has a coefficient of performance of 6.22.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd