+1-415-670-9189
info@expertsmind.com
Lithium ion battery technology
Course:- Electrical Engineering
Length: 8
Reference No.:- EM13199




Assignment Help
Expertsmind Rated 4.9 / 5 based on 47215 reviews.
Review Site
Assignment Help >> Electrical Engineering

The paper discusses about the Lithium air battery in which detailed reactions of Lithium with air including nonaqueous as well as aqueous are given. Li- ion technology including Li-ion battery model in simulink and Sim power systems is discussed in detailed.

This paper inhibits:

I. INTRODUCTION

II. ADVANTAGES AND LIMITATIONS OF LITHIUM ION BATTERY

III. LITHIUM AIR BATTERY

IV. LI-ION BATTERY MODEL IN SIMULINK AND SIM POWER SYSTEMS

V. A DETAILED LOOK OF THE MODEL

VI. CONCLUSION

VII. REFERENCES




Put your comment
 
Minimize


Ask Question & Get Answers from Experts
Browse some more (Electrical Engineering) Materials
A binary pulse counter can be constructed by interconnecting T -type flip-flops in an appropriate manner. Assume it is desired to construct a counter which can count up to 1
The mutual inductance between two coils is 0.15 H. Determine the emf induced in one coil when the current in the other decreases uniformly from 5 A to 3 A, in a time of 10 m
Assume that your application has 600 data reads for each 4000 instructions. For the same number of instruction the application has 400 data writes. The cache used has an ins
The ac voltage that is supplied from a wall plug to the incandescent light is 170V sin[(377 rad/s)t]. If the current flowing through the light is 350 mA sin[(377 rad/s)t], d
Use as few 2x2 MUXes as possible to design the following circuit. Your circuit outputs Z, which is the square root of the input, X if and only if X is a power of two, otherw
A 120 Veff motor draws 1.5 kVA at a lagging power factor of .85. Determine the size of the capacitor that must be placed in parallel with the motor for a power factor of 1.
1. There are 4 main classes of network topologies, what are they 2. In communications over a network, protocols are required. What is the framework or reference model that mak
Draw a block diagram for the synchronous receiver, including a counter. (Note: A state machine is not necessary, but generation of control signals Load and Shift is required