Is the thermal diffusivity of the ceramic of the mug

Assignment Help Mechanical Engineering
Reference no: EM13701715

You notice that the ceramic coffee mugs in the office get too hot to hold about 10 seconds after pouring in the hot coffee. The wall thickness of the cup is 2mm. What, approximately, is the thermal diffusivity of the ceramic of the mug? According to the solutions manual the answer is thermal diffusivity a ? 5 x 10-7 m2/s, I have no idea how they got this.

Reference no: EM13701715

Questions Cloud

Device creates or destroys energy or destroys entropy : The Acme Company claims to have designed an adiabatic turbine that will produce 126.2 BTU per pound of steam. The operating conditions are labeled on the diagram below. Is this company's claim valid or is this a perpetual motion machine? Hint: Determ..
Linear impulse-momentum equation is obtained by integrating : The linear impulse and momentum equation is obtained by integrating the ______ with respect to time. Which parameter is not involved in the linear impulse and momentum equation?  The internal impulses acting on a system of particles always. Select th..
Vibrations engine mount are to be monitored by accelerometer : The vibrations of an engine mount are to be monitored by an accelerometer which can be treated as a second-order system. It is expected that the vibrations will not exceed 1 kHz. If you have an accelerometer that has a ringing frequency of 20 kHz and..
What is the speed at which the load will be lifted : A pump delivers 40 litres/min to a 90 mm bore/30 mm rod cylinder to lift a load of 200 kg. What is the pressure exerted on the piston? What is the speed at which the load will be lifted? How much power is required to lift the load at this speed?
Is the thermal diffusivity of the ceramic of the mug : You notice that the ceramic coffee mugs in the office get too hot to hold about 10 seconds after pouring in the hot coffee. The wall thickness of the cup is 2mm. What, approximately, is the thermal diffusivity of the ceramic of the mug? According to ..
Estimate the average wall temperature : The weather channel reports that it is a hot, muggy day with an air temperature of 90°F, a 10 mph breeze out of the south west, and bright sunshine with a solar insulation (i.e. the solar heat source) of 400 W/m2.
Dell computer trades at a market-to-book ratio : Dell Computer trades at a market-to-book ratio of 15.86. The industry M/B ratio is 9.5. Even though Dell's M/B ratio is high relative to the industry, this ratio may tell us nothing about whether Dell's stock will outperform or underperform i..
Firm needs to raise $20 million for a new project : Your firm needs to raise $20 million for a new project. You forecast that earnings per share next year will be $1.65 if the firm issues new equity, but $ 1.55 if the firm issues new debt. Therefore equity is a better source of financing?
What is the flow rate that the pump delivers : A 4 kW motor is driving an oil pump with an efficiency of 95% down a 10 mm diameter pipe. If the velocity of the fluid downs the pipe is 1.8 m/s, What is the flow rate that the pump delivers? What is the pressure that the pump can deliver?

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  It is then reheated to 440c before entering the 2nd stage

steam is working fluid in rankine cycle with super heat amp reheat and steam is entered in 1st state turbine 8mpa amp

  The second shaft is hollow with an outside diameter of 3 in

two steel shafts are made of cold-drawn steels having ultimate tensile strengths of 185 kpsi and 240 kpsi respectively.

  A man climbing a staircase of height 10m carries a brief

a man climbing a staircase of height 10m carries a brief case weighing 100n he placed a briefcase on each step before

  It bums in a steam generator with 115 percent theoretical

a gaseous fuel has the following volumetric analysis 90 methane ch4 5.0 ethane c2h6 and 5 nitrogen. it bums in a steam

  Estimate the minimum runway length and time needed to reach

a fully loaded boeing 777-200 jet transport aircraft weighs 325000 kg. the pilot brings the 2 engines to full takeoff

  Air within a piston-cylinder assembly initially at 175psi

air within a piston-cylinder assembly initially at 175psi 660of undergoes an isentropic expansion to 20 psi. what is

  In an accelerator protons emerge with velocity of 25 x 108

in an accelerator protons emerge with velocity of 2.5 x 108 ms. the accelerator is 0.8km long.a if the acceleration is

  A particle moving in the x-y plane has a position vector

a particle moving in the x-y plane has a position vector given by r 1.31t2i 1.43t3j where r is in inches and t is in

  Determine values of the specific volume of the saturated

at room temperature 25 c what pressure in both kpa and psi is required to liquefy propane c3h8? b determine values of

  Take cut off ratio 2 find the temperature after the end

a diesel cycle works on compression ratio of 18 and temperature at the start of compression is given as 300k. take cut

  A piston-cylinder device initially contains 06 m3 of water

a piston-cylinder device initially contains 0.6 m3 of water vapor at 250 kpa. the specific volume and specific internal

  What is the maximum number of break failures that can be

three coupled street cars are moving at a speed of 32 kmhr down a 7 degree incline. each car has a weight of 198 kn.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd