Inside air temperature when outside air temperature

Assignment Help Mechanical Engineering
Reference no: EM13947531

In Chapter 3 we assumed that, whenever fins are attached to a base material, the base temperature is unchanged. What in fact happens is that, if the temperature of the base

(a) Assuming that the occupants' body heat provides a continuous source of 320 W within the igloo, calculate the inside air temperature when the outside air temperature is Too  = -40 C. Be sure to consider heat losses through the floor of the igloo.

(b) Using the thermal circuit of part (a), perform a parameter sensitivity analysis to determine which variables have a significant effect on the inside air temperature. For instance, for very high wind con- ditions, the outside convection coefficient could double or even triple. Does it make sense to con- struct the igloo with walls half or twice as thick?

Reference no: EM13947531

Questions Cloud

Suppose a change in expectations regarding future : Suppose a change in expectations regarding future U.S. inflation causes the expected future spot rate to decline to $1.52:£1. What should happen to the U.S. interest rate?
What is the projects net present value : The firm has a 75% chance if it invests -$1,500 a return of $500 for 7-years, and a 25% chance of returning $25 for 7-years. Based on the above data, what is the project's net present value?
Create the files named below : Also please check what I wrote in the Short Account and if you think that something else is required in the Short Account, please change it or suggest what should be changed.
What is the accounting rate of return : What is the accounting rate of return? Compute the accounting rate of return for an investment that requires an initial outlay of $300,000 and promises an average net income of $100,000.
Inside air temperature when outside air temperature : Assuming that the occupants' body heat provides a continuous source of 320 W within the igloo, calculate the inside air temperature when the outside air temperature is Too  = -40 C. Be sure to consider heat losses through the floor of the igloo.
What was the real u.s. dollar cost : At the same time, the exchange rate changes from FF 1 = $0.15 on January 1 to FF 1 = $0.10 on December 31. What was the real U.S. dollar cost of borrowing francs for the year?
Is this search for intelligent life a scientific mission : The SETI project and other efforts to contact or listen for messages from extraterrestrial life were once funded by our government. Should the government support this endeavor? Is this search for intelligent life a scientific mission
Explain the relationship between npv and a firms value : Explain the relationship between NPV and a firm's value. What is the cost of capital? What role does it play in capital investment decisions?
Atomic layer deposition process : A nanolaminated material is fabricated with an atomic layer deposition process, resulting in a series of protecting the heat-generating devices to which they are attached by conducting thermal energy away from the devices to surrounding, cooler re..

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Coefficient of friction at the tool and chip interface

A cutting tool (0.250in wide, rake angle 5 degrees) is used to machine in orthogonal mode. the depth of cut is 0.010in and the chip thickness is 0.027in. Calculate the shear angle and coefficient of friction at the tool and chip interface?

  If the plate moves through the mid plane between the

a thin plate moves between two parallel horizontal stationary flat plates at a constant velocity of 5 ms.the two

  For one-dimensional steady state conduction in

for one-dimensional steady state conduction in cylindrical or spherical shell without heat generation is the radical

  Design a chain drive for a steam turbine driving a

design a chain drive for a steam turbine driving a centrifugal pump. the input speed is 2200 rpm and output is around

  The airplane travels before hitting the slope

A paper airplane is thrown up a hill with slope theta = 16.26 deg during a rainstorm. The airplane has an initial speed of 10 ft/s and is fired at an angle of phi=32.52 deg from the horizontal. Rain accumulation on the wings results in a vertical acc..

  Determine the total power output of the turbine

Super-heated water steam at 6 MPa and 400C enters a turbine with a velocity 50 m/s. It leaves the turbine at 70 kPa and 90% quality with a velocity of 200 m/s. The mass flow rate of steam is 20 kg/s. The rate of heat loss from turbine to surroundings..

  Shetch the free body diagram for the frisbee during level

a frisbee in flight has lift and drag coefficients of cl and cd respectively where the reference area a is the frisbee

  Air expands through a turbine operating at steady state

Air expands through a turbine operating at steady state on a test stand. At the inlet, p=50 psia, T=1500 degrees R, and at the exit , p=14.5 psi. The volume flow rate of air entering the turbine is 2000 ft^3/min, and the power developed is measured a..

  A rigid insulated vessel is divided into two compartments

a rigid insulated vessel is divided into two compartments connected by a valve. initially one compartment occupying one

  The african elephant has developed the pinna or external

the african elephant has developed the pinna or external ear that functions as a radiator-convector. the pinna can be

  Assuming the corrosion rate of this metal in saltwater is

a corroded metal plate was found in a submerged ocean vessel. the original dimensions of the plate were 25 x 10 x 5 cm.

  Determine the minimum required wire diameter

a large tower is to be supported by a series of steel wires.it is estimated that the load on each wire will be 11100N. determine the minimum required wire diameter assuming a factor of safety of 2 and a yield strength of 1030MPa.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd