### Illustrate the operation of demodulator

Assignment Help Chemical Engineering
##### Reference no: EM13877532

Figure shows the block diagram of a zero-crossing detector for demodulating an FM signal, its consist of a limiter, a pulse generator for producing a short pulse at each zero-crossing of the input, and a low-pass filter for extracting the modulating wave.

(a) Show that the instantaneous frequency of the input FM signals is proportional to the number of zero crossings in the time interval t - (T1/2) to t + (T1/2), divided by T1, Assume that the modulating is essentially constant during this time interval.

(b) Illustrate the operation of this demodulator, using the saw-tooth wave of Figure as the modulatingwave.

#### Uniform quantizer of the mid-tread type

A sinusoidal signal, with amplitude of 3.25 volts, is applied to a uniform quantizer of the mid-tread type whose output takes on the values 0, ±1, ±2, ±3 volts. Sketch the w

#### Calculate atomic packing

The unit cell for Cr2O3 has hexagonal symmetry with lattice parameters a = 0.4961 nm and c = 1.360 nm. If the density of this material is 5.22 g/cm3, calculate its atomic pa

#### Microstructural products of eutectoid iron-carbon

Name the microstructural products of eutectoid iron-carbon alloy (0.76 wt% C) specimens that are first completely transformed to austenite, then cooled to room temperature a

#### Name the micro structural products

Name the micro structural products of 4340 alloy steel specimens that are first completely transformed to austenite, then cooled to room temperature at the following rates:

#### Chemical formula for nonstoichiometric material

Under these conditions, name one crystalline defect that you would expect to form in order to maintain charge neutrality. How many Cu+ ions are required for the creation of ea

#### Determining the range of compositions

For the MgO-Al2O3 system, what is the maximum temperature that is possible without the formation of a liquid phase? At what composition or over what range of compositions wi

#### Approximate percentages of the microconstituents

For parts (a), (c), (d), (f), and (h) of Problem 10.20, determine the approximate percentages of the microconstituents that form. (a) Rapidly cool to 250(C (480(F), hold for

#### Compute the dipole moment

If an externally applied electric field produces a 5% expansion of the lattice, compute the dipole moment for each Na+-Cl- pair. Assume that this material is completely unpo

### Write a Review 