How to select the lightest steel wide flange section

Assignment Help Civil Engineering
Reference no: EM13312011

A simply supported beam is to support a uniformly distributed load of 10 kips per linear foot over the full span. The span length is 32 feet. Total deflection is not to exceed span/240. Select the lightest (economical) steel wide flange section (W shape) with a yield stress of 50 ksi. Assume the beam weight to be 200 PLF

Reference no: EM13312011

Questions Cloud

Explain the enthalpies of bond formation to rationalize : Use the enthalpies of bond formation to rationalize why nitrogen forms a dimer and phosphorous a tetramer.
What is the speed of ambulance : As you stand motionless on the sidewalk, you hear an ambulance siren broadcasting a shrill 610hz sound while it is approaching, What speed is the ambulance
Calculate the total cost using a one-month planning : Calculate the total cost using a one-month planning horizon and calculate the total cost using a three-month planning horizon.
Explain what is the empirical formula of the phosphorus : A 46.2mg sample of phosphorus reacts with selenium to form 135mg of the compound. What is the empirical formula of the phosphorus selenide
How to select the lightest steel wide flange section : The span length is 32 feet. Total deflection is not to exceed span/240. Select the lightest (economical) steel wide flange section (W shape) with a yield stress of 50 ksi. Assume the beam weight to be 200 PLF
What is the maximum safe initial angle : Walking by a pond, you find a rope attached to a tree limb 6.0 m off the ground. You decide to use the rope to swing out over the pond. What is the maximum safe initial angle between the rope and the vertical so that it will not break during the swi..
Explain the equilibrium constant has been measured : When white phosphorous (P4) is heated above 1100 K, the following equilibrium is observed in the gas phase P4 ? 2P2 b. The equilibrium constant has been measured as a function of temperature for this reaction
Determine minimum resale price needed to make the challenger : A lumber company that cuts fine woods for cabinetry is evaluating if it should retain the current bleaching system or replace it with the new one. The relevant costs of each system are known or estimated.
What is the degrees north of west : two hockey players strike a puck of mass of .164kg, one from westward force of 1.10 x 10^3 Newtons, what is the degrees north of west

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine percent error in replacing sine and tangent angles

Determine the percent error n in replacing the sine and the tangent of an angle by the value of the angle in radians for angle values 5 degrees, 10 degrees, and 20 degrees. Explain the qualitative difference between the sine and tangent results

  What is the maximum acceleration that the car can achieve

A car is traveling at 30 mph on a good, dry pavement at sea level. The front-wheel-drive car has a drag coefficient of 0.35, a frontal area of 30 ft2 and a weight of 2500 lbs. The wheelbase is 120 inches and the center of gravity is 20 inches from..

  Determine the 2-year peak discharge prior to development

A development is being planned within a 250-acre watershed. The present land use is 120 acres of pasture, with soil type B(CN=61), and the rest soil type D (CN=80). The Tc is 54 min. and the 2-year, 24-hour storm depth is 4 in.

  Determine at what time does the minimum volume occur

The inflow to a small reservoir during a storm may be described by the equations Q=1000(1-e^-kt) where Q= flow in cfs k= runoff rate = 1.0 per hour t = time in hours The outflow through the dam gates is held constant at 800 cfs.

  Briefly explain reason for variation of water coefficient

A homogeneous coarse sand deposit has a water table at 10 m depth. The water coefficient of permeability of the sand is found to vary significantly with height above the water table even though the sand deposit is homogeneous.

  What is the coefficient of rolling resistance on the road

A bicyclist is riding a bicycle on a flat road. The combined mass of the bicyclist and bicycle is = 110kg, the radius of each wheel is = 32.5cm, and the coefficient of rolling resistance between the tires and the road is = 0.245 cm.

  How to formulate a set of constraints that will enforce

Given the binary variables x1,x2,x3,x4 and x5, formulate a set of constraints that will enforce x3,x4, and x5 to equal one if x1=1 and x2=0.

  How many kilograms each of pearlite

how many kilograms each of pearlite and preutectoid phase form? schematically sketch and label the resulting microstructure

  What is the stationing of the pt on the same highway

A crest vertical vurve and a horizontal curve on the same highway have the same design speed. The equal-tangent vertical curve connects a +3% initial grade with a +1% final grade and has a PVC at 101+78 and a PVT at 106+72

  Writing case study about bridge collapse

Writing case study about bridge collapse

  Determine what is the outlet air temperature

A total of 13,610 kg/h of air at 1 atm abs pressure and 15.6C is to be heated by passing over a bank of tubes in which steam at 100C is condensing. The tubes are 12.7mm OD, 0.61 m long, and arranged in-line in a square pattern with Sp=Sn= 19.05mm.

  Find how much does the student owe at the interest rate

The compound interest formula is F=P(1+i)n where F is the total amount due, P is the initial cost or amount of money, i is the interest rate, and n is the number of periods interest is computed. 1.A student purchases a $1400 laptop computer for sc..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd