Hot-air balloon achieves its buoyant lift with heating air

Assignment Help Physics
Reference no: EM13666815

1. A hot-air balloon achieves its buoyant lift with heating the air inside the balloon, which makes it less dense than the air outside. Suppose the volume of a balloon is 1600 m3 and the needed lift is 2200 N (rough estimate of the weight of the equipment and passenger). Compute the temperature of the air inside the balloon which will produce the required lift. Suppose that the outside air temperature is 0°C and that air is an ideal gas under these conditions.

What factors limit the maximum altitude attainable by this method for a given load? (Neglect variables like wind.)

2. An ordinary glass is full to the brim with 359.0 mL of water at 100°C. If the temperature decreased to 22°C, how much water could be added to the glass?

Reference no: EM13666815

Questions Cloud

Distance of the image from the center of the curved side : Light rays from a distant point source are incident perpendicular to the flat side of a semicircular glass plate of radius5.0 cm and index 1.5. Discover the distance of the image from the center of the curved side.
What is magnetic field strength midway among the two wires : Two long, straight, parallel wires carry the similar current in te same direction. (A) Use both the right-hand source and force rules to decide whether the forces on the wires are (1) attractive or (2) repulsive.
Produces sound with a frequency : Assume you are stopped in your car at a traffic light, and an ambulance approaches you from behind with a speed of 12 m/s. The siren on an ambulance produces sound with a frequency of 600 Hz. What frequency will you hear?
Block of certain material begins to slide on inclined plane : A block of a certain material begins to slide on an inclined plane when the plane is inclined to an angle θ = 5.71°. If a solid cylinder is fashioned from the same material, what will be the maximum angle at which it will roll without slipping on the..
Hot-air balloon achieves its buoyant lift with heating air : A hot-air balloon achieves its buoyant lift with heating the air inside the balloon, which makes it less dense than the air outside. Suppose the volume of a balloon is 1600 m3 and the needed lift is 2200 N (rough estimate of the weight of the equipme..
What is largest value of peak current that breaker can carry : A circuit breaker is rated for a current of 15A rms at a voltage of 120V rms. What is the largest value of peak current that the breaker can carry? What is the maximum average power that can be supplied by this circuit?
What was the speed of the block before it stopped : A 150-kg block slides across ice and comes to a stop in 12.50m. Coefficient of kinetic friction among ice and block is 1.800, what is the frictional force acting on the block? What was the speed of the block before it stopped?
Total mass of the passengers and elevator : An engineer is designing a spring to be placed at the bottom of an elevator shaft. If the elevator cable must happen to break when the elevator is at a height h above the top of the spring, compute the value that the spring constant k should have so ..
Horizontal platform in the shape of a circular disk rotates : "A horizontal platform in the shape of a circular disk rotates on a frictionless bearing about a vertical axle during the center of the disk. The platform has a radius of 1.10 m and a rotational inertia of 486 kg * m^2about the axis of rotation.

Reviews

Write a Review

Physics Questions & Answers

  What is the linear speed of a point on its edge

a grindstone has a radius of 6.00 cm and rotates at 7000 rpm. What is the linear speed of a point on its edge

  What is the total magneticflux through the surface

A 0.150 T magnetic field B crosses the xyplane perpendicular to the x axis and at an angle of45.0° to the y axis. A square surfacewith sides of length 7.00 m lies mainly in the xyplane, but a 1.50 m section of it at one end is bent 90°in the negat..

  Determine work done by net external force acting on skier

A water-skier is being pulled by a tow rope attached to a boat. As the driver pushes the throttle forward, the skier accelerates. A 61.3-kg water-skier has an initial speed of 5.5 m/s. Later, the speed increases to 11.3 m/s. Determine the work done b..

  Q1 in a photoelectric effect experiment 325 nm photons

q1. in a photoelectric effect experiment 325 nm photons strike a cathode that has a work function equal to 1.25 ev.

  Find the magnitude of the electric field in the wire

A copper wire has a square cross section 2.7 on a side. The wire is 3.8 long and carries a current of 4.0 . The density of free electrons is 8.5*10^28 m^-3.

  What is the speed of the ball at the bottom of the incline

A bowling ball of mass 2.7 kg and radius 9.5 cm rolls from rest, What is the speed of the ball at the bottom of the incline

  Determine what is the celsius temperature of the object

A "red-hot" object is measured to have a frequency of 1.0x 10^14 Hertz. Determine what is the Celsius temperature of the object

  What is his pitching speed problem

A baseball player friend of yours wants to determine his pitchingspeed. You have him stand on a ledge and throw the ballhorizontally from an elevation 7.00 m above the ground. The ball lands 30.0 m away.

  Capacitor of unknown capacitance

A capacitor of unknown capacitance C is charged to 100 V and then connected across an initially uncharged 60-μF capacitor. If the final potential difference across the 60-μF capacitor is 40 V, determine C.

  What is the gravitational potential energy of the system

A 3.0 kg mass is attached to a vertical spring hanging from the ceiling. The spring and mass are stationary. The spring constant for the spring is 250 N/m. What is the gravitational potential energy of the system

  What is the mass of the bag

A small bag of sand is suspended by a wire of length L=1.2 m. A bullet of mass m=8 gr, moving with speed v0=600 m/s in the horizontal direction, What is the mass of the bag

  Determine the acceleration of two blocks

A block of mass m1 = 1.75 kg and a block of mass m2 = 5.90 kg are connected by a massless string over a pulley in the shape of a solid disk having radius R = 0.250 m and mass M = 10.0 kg. These blocks are allowed to move on a fixed block-wedge of ..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd