Give properties to find the fourier transform of the signal

Assignment Help Electrical Engineering
Reference no: EM13270099

The fourier transform of the triangular pulse x(t) is expressed as: X(w) = 1/w^2(e^jw - jwe^jw - 1) Use this information, and the time-shifting and time-scaling properties to find the fourier transform of the signal: y = x, -1

Reference no: EM13270099

Questions Cloud

Calculate the amount of money to spend each month : Consider a square house 40 ft on a side, 10 ft high, with a flat roof on top and walls/roof that is 8 inches thick. The thermal conductivity for an un-insulated wall or roof is 1.6 W/Km, while with fiberglass insulation its 0.04 W/Km.
What is the maximum monthly mortgage payment : what is the maximum monthly mortgage payment for which he can qualify? Monthly Gross Income $5,000 Car payment 800 Other installment debt 500.
Explain when ethane (c2h6) reacts with chlorine : You may want to write out the reaction)When ethane (C2H6) reacts with chlorine (Cl2) the product is C2H5Cl and HCl. In a certain experiment 165 g of C2H6 reacts with 255 g of Cl2.
What maximum debt burden per month can she assume : Lindsey has a job with monthly take-home pay of $3,500. Using the suggested maximum debt safety ratio of 20%, what maximum debt burden per month can she assume?
Give properties to find the fourier transform of the signal : The fourier transform of the triangular pulse x(t) is expressed as: X(w) = 1/w^2(e^jw - jwe^jw - 1) Use this information, and the time-shifting and time-scaling properties to find the fourier transform of the signal: y = x, -1
What is the total dollar amount they will need at closing : They will make a 20% down payment, and they must pay 2 points on the loan. Closing costs should be 3% of the purchase price. What is the total dollar amount they will need at closing?
What is the spacing between points : Two in-phase loudspeakers are some distance apart. What is the spacing between points where constructive interference occurs? The speed of sound in air is 343 m/s
What is the power recieved in the rr-ll and rl polarizations : If a particular radar reciever can detect the target using HH polarization at a maximum distance of 10km, find the maximum distance at which the target can be detected using VV polarization. Assume a standard radar equation.
How many grams bromine reacted and how do you know : In a lab experiment, 7.75g of phosphorus reacts with bromine to form 67.68g of phosphorus tribromide, How many grams bromine reacted and how do you know

Reviews

Write a Review

 

Electrical Engineering Questions & Answers

  Determine the sending end quantities and voltage regulation

The ABCD constants of a three-phase, 345-kV transmission line are A = D = 0:98182 + j0:0012447. The line delivers 400 MVA at 0.8 lagging power factor at 345 kV. Determine the sending end quantities, voltage regulation, and transmission efficiency.

  Determine the voltage required to establish a flux density

Excitation is provided by a 140-turn, 30 ohm coil. Determine the voltage required to establish a flux density of 1.56T. The reluctance of the magnetic circuit, when operating at this flux density is 768 A-t/Wb.

  Compute the polar form of the impedances in rectangular form

Compute the polar form of the impedances shown below in rectangular form in parts a and b, and compute the rectangular form of the impedances shown below in polar form in parts c and d

  What is minimum bandwidth necessary to support the signals

If a 250 us period clock signal must be transmitted with a 10 kHz data signal on the same link, then what is the minimum bandwidth necessary to support both signals.

  Find the efficiency of the motor and ifla of the motor

A 20-Hp, 240VDC, 4-pole Shunt motor operates at rated load and 1700rpm and an efficiency of 88%. It has armature resistance of 0.2Ω and field resistance of 240Ω. Find: a)Power input to the motor b)IFLA of the motor

  Find the rms input noise power level

When the amplifier is operating with a bandwidth first of 10MHz, find? 1) The RMS input noise power level? 2) The audio output power level? 3) The RMS output noise power level?

  Design a bus with 3 bits in the address of the source

Design a bus with 3 bits in the address of the source, 4 bits in the address of the destination and 2 bits of data to be transmitted. Use gates only. Hint: good solution should be based on 2-dimensional decoding.

  Design lawn sprinkler system to water the lawn of residence

Assume that this whole system is linear, so that, if the pressure on a sprinkler is halved, the area covered (as well as the flow rate) will be halved. This is true until the pressure is reduced below 20psi, at which it does not work at all.

  Sketch the b-mode image

Assume the z0 is in the far field and derive an expression for the strength to return as a function of angle. Make approximations where appropriate and do not forget the sidelobes.

  What is the output impedance of the amplifier

Suppose that without a 1k-ohm load an amplifier's output voltage is 5Vpp but when the 1k-ohm load is attached, it drops to 3Vpp. What is the output impedance of the amplifier

  What is speed and developed torque when drawing current

A series connected DC motor has R_F + R_A = 11.5 ohm and draws 1 A of current from a DC voltage source with V_T = 18 V while running at 1000 rpm. What is the speed and developed torque when drawing 0.75 A of current

  What is meant by the term propagation delay

What voltage levels typically define a logic 0 and a logic 1 in the newer logics today.  What are the major semiconductor technologies used in making integrated circuits today. What is the difference between sinking current and sourcing current.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd