First tubes and on the tubes deep in teh array

Assignment Help Mechanical Engineering

Reference no: EM13702497

Air at 20C flows over a very large bank of 2 cm OD tubes that are kept at 100C. the air approaces at an angle of 15 degress off normal to the tubes. the tube array is staggered, with SL= 3.5 CM and ST= 2.8 cm. Find Average h on the first tubes and on the tubes deep in teh array if the air velocity is 4.3 m/s before it enters the array (Average h deep = 118 W/m squared K)

Reference no: EM13702497

Questions Cloud

Evaluate the riskiness of a security : Discussion question: How would you evaluate the riskiness of a security? It has to be a 1400 - to 1700 words and 5 references not from blog, wiki, etc

Dsm options and techniques : Analyse the months and times of peak and off-peak energy use. Using some of the DSM options and techniques discussed in this week, provide a proposal for the management of peak and off-peak energy consumption for existing rooms in a 1980s concrete..

Calculate the pressure at this point on the wing : A Boeing 747 is flying at M = 0.7 at an altitude where the temperature is 223.15 K. The density is 0.41268 kg/m3, and the pressure is 26429.7 Pa. The pressure coefficient on a point of the wing is -2. a) Calculate V0. b) Calculate the pressure (in Pa..

Which are denominated in dollars : Home's currency is the peso and trades at 1 peso per dollar. Home has external assets of $200 billion, all of which are denominated in dollars. It has external liabilities of $400 billion, 75% of which are denominated in dollars.

First tubes and on the tubes deep in teh array : Air at 20C flows over a very large bank of 2 cm OD tubes that are kept at 100C. the air approaces at an angle of 15 degress off normal to the tubes. the tube array is staggered, with SL= 3.5 CM and ST= 2.8 cm. Find Average h on the first tubes and on..

Calculate the ratio of the turbulent h to the laminar : Water at 24 degree C flows at 0.8 m/s in a smooth, 1.5 cm I.D. tube that is kept at 27 degree C. The system is extremely clean and quiet, and the flow stays laminar until a noisy air compressor is turned on in the laboratory. Then it suddenly goes tu..

Two copper slabs problem : Two copper slabs, 3cm thick and insulated on the outside are suddenly clamped tightly together. The one on the left side is initially at 100 C and the one on the right side at 0c. Determine the left-hand adiabatic boundary's temperature after 2.3s ha..

Steam condenses-what is the mass rate of condensation : Steam condenses in a 2cm I.D. thin walled tube of 99% aluminium at 10atm pressure. There are circular fins of constant thickness, 3.5cm in diameter, and every 0.5 cm on the outside. The fins are 0.8mm thick and the heat transfer coefficient from them..

Maximum shear stress developed in the shaft : The 60-mm diameter shaft rotates at 300 rev/min. this motion is caused by the unequal belt tensions on the pully of 800 N and 450 N. Determine the power transmitted and the maximum shear stress developed in the shaft.

User Account

All Pages