Fire truck draws water from an open constant-level reservoir

Assignment Help Mechanical Engineering
Reference no: EM13711596

A fire truck draws water from an open constant-level reservoir through a hose of 0.2 ft2 cross section. The water is discharged from the pump through another 0.2 ft2 hose to a surge tank pressurized to 120 psig with air at the top. The pump adds 970 ft lbf/slug of energy to the fluid. The water level in the surge tank is 3 ft above the pump centerline. From the surge tank the water flows steadily through a hose of 0.04 ft2 area to a nozzle of 0.01 ft2 area. The nozzle exit is held at the same level as the water free surface in the surge tank. Neglect all frictional losses and sketch the system.

Find the:

a) speed of the water leaving the nozzle

b) elevation of the pump relative to the reservoir

c) power required to drive the pump if it has an 80 % efficiency

d) maximum height above the reservoir that the stream of water exiting the nozzle can reach

Hint: You will need to define more than one CV to solve this problem!

Reference no: EM13711596

Questions Cloud

What is coefficient of restitution needed for good ammo : A "pumpkin chucker" designed for the annual pumpkin competition held near Millsboro, delaware every fall (first week of November) uses a pneumatic launcher (air cannon) to throw its pumpkin. It is important to know if your "ammunition", the pumpkin, ..
Difference between causes and effects in the swot analysis : Difference between causes and effects in the SWOT analysis.Causes are important, not effects. Once the SWOT Analysis is created, each group needs to construct the SWOT Bivariate Strategy Matrix.
Shell-and-tube heat exchanger is used to cool flow of steam : A shell-and-tube heat exchanger is used to cool a flow of steam using a stream of cooling water. The steam enters the heat exchanger at 0.1 bar and a quality of 91% (state 1), and exits as a saturated liquid at the same pressure (state 2). The mass f..
Briefly explain how gmos are created : Briefly explain how GMOs are created in your own words.
Fire truck draws water from an open constant-level reservoir : A fire truck draws water from an open constant-level reservoir through a hose of 0.2 ft2 cross section. The water is discharged from the pump through another 0.2 ft2 hose to a surge tank pressurized to 120 psig with air at the top. The pump adds 970 ..
Determine volume and height of cooling tower-effectiveness : A counter flow cooling tower cools 2000 gal/min water from 104 F to 85 F with 210,000 ft^3/min of air at 90 F Dry bulb Temperature and 76 F WBT . The Mass transfer coefficient -surface area product is hA= 123lbm/hr ft^3. Air mass flow rate per unit c..
Strained juice is concentrated in a vacuum evaporator : In a process for concentrating 1000kg of freshly extracted orange juice containing 12.5 wt% solids, the juice is strained, yielding 800kg of strained juice and 200kg of pulpy juice. The strained juice is concentrated in a vacuum evaporator to give an..
Consider a mixing chamber into which cold air enters : An air-conditioning system, streams of cold and warm air are mixed to get air with the right temperature. Consider a mixing chamber into which cold air enters at 8C and 100 kPa at a rate of 0.55 m^3 /s and warm air enters at 300C and 100 kPa. The rat..
What statistical method can you apply using this data : What statistical method can you apply using this data?

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  How to calculate the adiabatic flame temperatures

how to calculate the adiabatic flame temperatures from the injection pressures during choked conditions.

  Write down the continuity equation navier-stokes equations

a wire of radius ri is coated by a process described above. it is fed to a reservoir filled with a newtonian fluid with

  The work input is measured to be 4854 kjkg knowing the

steam is compressed by a compressor from 120oc and 150 kpa to 200oc and 1.5 mpa. the work input is measured to be 485.4

  Investigating a dynamic movement in polar coordinates

Investigating A Dynamic Movement in Polar Coordinates

  Block b is attached to the 20mm inner diameter block a

block a is dropping at a velocity of 600mmsec and acceleration of 100mmsec2. it is attached directly to an inner

  The speed limit on a country road is 70 kmhr the radius of

the speed limit on a country road is 70 kmhr. the radius of curvature for a bridge on the road is 50 meters. a corvette

  Determine the final temperature

determine the final temperature °R, and the final pressure in lbf/in^2. Rair = 53.33 ft·lbf/lb·°R. Assume ideal gas behavior and solve problem using.

  A hollow steel shaft 6 ft long has an outer diameter of 25

a hollow steel shaft 6 ft long has an outer diameter of 2.5 in. and an inner diameter of 1.5 in. the shaft is

  Find the acceleration relative to the ground of the highest

the acceleration of a particle in a fixed coordinate system in terms of its position in a translating and rotating

  At the nozzle exit the pressure is 147lbfin2 and the

steam enters a well insulated nozzle operating at steady state at 1000?f and 500lbfin2 and velocity 10fts. at the

  Derive equations for shear and moment

Design a wide flange, simply supported beam below so that the stress due to bending does not exceed that allowed by AISC for A36 steel and calculate the shear stress where the parts join as indicated. Maximum V = 10,000 lb.

  Fnd the compressibility factor using a the generalized

1 given water vapor at 200 bar and 470oc.find the compressibility factor using a the generalized compressibility chart

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd