Find what depth of aggregate is needed at the angle theta

Assignment Help Civil Engineering
Reference no: EM13305237

A 2000-lb wheel load is to be supported by aggregate over soil with a maximum bearing pressure of 1000 lb/sqft. What depth of aggregate is needed if the angle theta is 40 degrees?

Reference no: EM13305237

Questions Cloud

Determine the required detention time and required volume : A dispersed plug chemical reactor has an influent flow with concentration of 150 mg/L of A and a flow rate of 100 gal/min (380 L/min). The reaction is first order, The rate equation : - dC/dt = kC= -r , and the rate constant is 0.4 h^-1 .
What is the value of the energy stored in the inductor : Consider the following circuit with emf = 12 V, C = 2 microF, L = 6 microH, and R = 6ohms. What is the value of the energy stored in the inductor
Find the length of the studs in a rake wall with base height : Find the length of the studs in a rake wall with a 5:12 pitch, a half span of 9'4", 16" OC and a base height of 7'3".
Calculate the separation of the two slits : Young's experiment is performed with light of wavelength 502nm from excited helium atoms. What is the separation of the two slits
Find what depth of aggregate is needed at the angle theta : A 2000-lb wheel load is to be supported by aggregate over soil with a maximum bearing pressure of 1000 lb/sqft. What depth of aggregate is needed if the angle theta is 40 degrees
Find what is the pressure on the soil if theta is 45 degrees : A pipe is to be installed under the ground on a bed of aggregate 6 in. thick. The entire weight on the aggregate from pipe and soil above the pipe is 1800 lbs. per linear foot of pipe. What is the pressure on the soil if theta is 45 degrees
Compute the wavelength of the light that falls on the slits : Coherent light from a sodium-vapor lamp is passed through a filter that blocks everything except for light of a single wavelength. compute the wavelength of the light that falls on the slits
Calculate the compacted cubic yards per hour over 10-inch : Calculate the compacted cubic yards per hour if a compactor with a 5-ft drum width travels at 3 mph over a 10-in. lift of aggregate base course with 4 passes required to meet density specifications under average operating conditions.
Obtain the self-induced emf in the solenoid : A 0.10 m long solenoid has a radius of 0.05 m and 15000 turns. The current in the solenoid changes at a rate of 6.0 A/s. Determine the self-induced emf in the solenoid

Reviews

Write a Review

Civil Engineering Questions & Answers

  Compute the max acceptable tensile service load for angle

The service live load is three times the dead load. The 4-in leg contains a single line of 7/8 inch diameter bolts, and the 6 inch leg contains a double gage line of 7/8 inch diameter bolts.

  Find the absolute-gage and vacuum pressures in the jar

A glass jar is heated in an oven and sealed when the air pressure is 103 kPa and the temperature is 105 C. Find the absolute, gage, and vacuum pressures in the jar when it cools to 20 C.

  Determining the velocity of motor having constant power

A constant power of 1.5 hp is supplied to the motor while it operates with an efficiency of ε = 0.8. Determine the velocity of the 200-lb crate in 15 seconds, starting from rest. Neglect friction.

  Find the uniform flow depth of concrete trapezoidal channel

Find the uniform flow depth (in feet) of a concrete trapezoidal channel with a bottom width of 30 ft. and side slopes of 2:1. The channel is laid at a slope of 0.05% and carries a design discharge of 1000 cfs.

  How many kilograms each of pearlite

how many kilograms each of pearlite and preutectoid phase form? schematically sketch and label the resulting microstructure

  What is the allowable minimum length of the ramp

Using the ADA code, what is the allowable minimum length of the ramp base if base if it is 2 ft high and the code is 1:12

  Density specifications under average operating conditions

Calculate the compacted cubic yards per hour if a compactor with a 5-ft drum width travels at 3 mph over a 10-in. lift of aggregate base course with 4 passes required to meet density specifications under average operating conditions.

  Calculate both volumetric molar and mass afr

Compare the stoichiometric air/fule ratios (AFR) for complete combustion of Benzene (C6 H6), Octane (C8 H8), and Ethanol (C2 H5 OH) in air (O2 + 3.76 N2). The only products should be CO2, H2O and N2.

  Determine the force at its bottom needed for equilibrium

If it is subjected to the load of 20kN and the soil provides a frictional resistance that is uniformly distributed along its sides of w = 3kN/m , determine the force at its bottom needed for equilibrium. Neglect the weight of the post.

  Explain lift charts in direct marketing

Lift Charts in direct marketing, The mass-mailing business is often used to illustrate the use of lift charts. Another real world application where the lift charts can be used

  Determine the compositions and quantities of gas and liquid

Determine the compositions and quantities of gas and liquid when 1 lb mole of a mixture of 30 mole percent methane and 70 mole percent ethanol is brought to equilibrium at 0 F and 500 psia.

  Determine the minimum length of curve that can be designed

you are designing a highway to AASHTO guidelines on rolling terrain where the design speed will be 65 mi/hr. At one section, a +1.25% grade and a -2.25% grade must be connected with and equal tangent vertical curve.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd