Find the width of the central bright fringe

Assignment Help Physics
Reference no: EM13251738

in a single-slit diffraction experiment, a beam of monochromatic light of wavelength 630 nm is incident on a slit of width 0.4 mm. if the distance between the slit and the screen is 1.8 m, what is the width of the central bright fringe?

Reference no: EM13251738

Questions Cloud

How much work is done by the tension in the cable : The concepts in this problem are similar to those in Multiple-Concept Example 4, What is the tension in the cable? How much work is done by the tension in the cable
What is the main drawback of reducing the supply voltage : The system has total capacitance CT = 1.0 muF (10 ^ 6 Farad) and average frequency in use at 10kHz. The transformation of battery power to power inn the microcontroller and additional components occurs with virtually no losses.
Preventive medicine and traditional medical care : New Century Health Clinic offers preventive medicine and traditional medical care. In your role as an IT consultant, you will help New Century develop a new information system.
What is the process specification : Studies on a bottle filling machine indicates it fill bottles to a mean of 16 ounces with a standard deviation of 0.10 ounces. What is the process specification, assuming the Cp index of 1?
Find the width of the central bright fringe : in a single-slit diffraction experiment, a beam of monochromatic light of wavelength 630 nm is incident on a slit of width 0.4 mm. what is the width of the central bright fringe
Calculate the armature current-total losses in the machine : A 240kW 500 Volt 1750rpm separately excited dc generator has an overall efficiency of 94%. The shunt field resistance is 60ohms, and the rated current is 5amps. The I^2R loss in the armature is 0.023pu.
Which one does a project manager have least control over : Which metric does a project manager have most control over: cost variance, schedule variance, cost performance index, and schedule performance index? Explain how so. Which one does a project manager have least control over?
Voltage clamp experiment : A sea urchin egg is used in a voltage clamp experiment; that is, the value of the transmembrane voltage is set by the experimenter, not by the properties of the membrane. The transmembrane voltage is held at +10 mV for one minute
Communicate the status of quality during a project : While cost and time are critical components of projects, how would you define the quality of a project? Provide some examples of project reporting metrics a project manager could use to measure and communicate the status of quality during a projec..

Reviews

Write a Review

Physics Questions & Answers

  How to use the energy in this candy bar to climb stairs

The label on a candy bar says 480 Calories. Assuming a typical efficiency for energy use by the body, if a 62 person were to use the energy in this candy bar to climb stairs, how high could she go?

  What is the average power of the motor

The rotor in a certain electric motor is a flat, rectangular coil with 88 turns of wire and dimensions 2.33 cm by 4.20 cm, What is the average power of the motor

  Imagine that a large cargo truck needs to cross a bridge

A movie stuntwoman drops from a helicopter that is 29.0 above ground and is moving with a constant velocity whose components are 8.00 upward and 18.0 horizontal and toward south. You can ignore air resistance.Where on the ground (relative to the p..

  Find the charge-to-mass ratio

Find the charge-to-mass ratio of an unknown point charge that is repelled strongly enough from a single electron to be suspended motionless against its own weight

  At what time did it stop

At t=0 a grinding wheel has an angular velocity of 24.20 rad/s. It has a constant angular acceleration of 24.2 rad/s^2 until a circuit breaker trips at t = 1.2 seconds.

  An automobile starter rated at 2hp draws

A 1,200 W hair dryer is operated on a 120 V circuit for 15 minutes. If electricity costs $0.10/kW h, what was the cost of using the blow dryer.

  What is the mass of the puck

A rubber ball is bouncing along the lever floor. after each bounce it only goes back up to half of the height that it just fell from. make a proportional sketch displaying this ball bouncing six times.

  The coefficient of kinetic friction

The coefficient of kinetic friction

  Elucidate the momentum change

One ball is perfectly inelastic and stays on the wall after collision andsecond ball is elastic and bounces of the wall. Elucidate the momentum change

  Show the sum of the positive and negative charges

A coffee filter of mass 1.2 grams dropped from a height of 3 m reaches the ground with a speed of 0.7 m/s. How much kinetic energy Kair did air molecules gain from the falling coffee filter.

  Why is the normal force of an object zero

Why is the normal force of an object zero at the top of a hill (such as the hill of a roller coaster)? I'm doing a circular motion unit and I found a few problems where this is the case, and I was wondering how it works.

  What are the original speeds of father and son

Suppose two kids get on a 4 meter long teeter-totter. The one on the right creates a CW torque of 350 Newton-meters (Nm). Quite by coincidence, when the other kid sits at 1 meter from his end they balance perfectly. How much does second kid weigh.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd