Find the values of real and reactive power drawn from line

Assignment Help Electrical Engineering
Reference no: EM13249961

determine the current drawn from a 3 phase 220 V line by a 3 phase 15kW motor operating at half load, 85% efficiency and .8 pf lagging. Find the values of real and reactive power drawn from the line.

Reference no: EM13249961

Questions Cloud

Explain the production capacity for acrylonitrile : The production capacity for acrylonitrile (C3H3N) in the United States is over 2 billion pounds per year. Acrylonitrile, the building block for polyacrylonitrile fibers and a variety of plastics, is produced from a gaseous propylene, ammonia, and ..
Analyzes the changes to imc strategy : analyzes the changes to IMC strategy a company faces in light of the digital upheaval led by Google, Yahoo, Microsoft, and others.
Calculate the increase in speed in rpm during the interval : Suddenly there is a short-circuit on the electric grid, and the electrical output goes to zero for 2 seconds. Calculate the increase in speed in rpm during this interval. Assume that the shaft-torque remains constant
Differences between ordinary income and statutory income : What the differences between Ordinary Income and Statutory income and clarify what Capital Gains and CGT.
Find the values of real and reactive power drawn from line : determine the current drawn from a 3 phase 220 V line by a 3 phase 15kW motor operating at half load, 85% efficiency and .8 pf lagging. Find the values of real and reactive power drawn from the line.
Briefly trace the history of health insurance in America : Briefly trace the history of health insurance in America, from the beginnings with Blue Cross up to the Managed Care era.
Effectiveness of article conclusion and conclusion : Read the article You've got Jail by Connie Clem and write a 6-8 sentence summary of the article. Be sure to include introduction, 3-5 sentence body, effectiveness of article conclusion, and conclusion.
Find the system power gain in db and the system noise ratio : An amplifier with a power gain of 3dB is to be characterized. The test apparatus provides a SNR of 20dB at the input and measures a SNR of 15dB at the output. Find the amplifier's NF. Specifications for (2), (3), (4) and (5).
Define what mass of sucrose should be combined to solution : What mass of sucrose should be combined with 461g of water to make a solution with an osmotic pressure of 8.80 atm at 280 K

Reviews

Write a Review

 

Electrical Engineering Questions & Answers

  Find the value of peak amplitude in a constellation diagram

A constellation diagram has four points located at (2,2), (-2,2), (-2, -2), and (2, -2) on the I(in-phase)-Q(quadrature phase) plane. Find the value of peak amplitude and the type of modulation this diagram represents.

  What would be the current drawn by two bulbs

Consider the problem of using a low-voltage system to power a small cabin. Suppose a 12-V system powers a pair of 100-W lightbulbs (wired in parallel). a. What would be the (filament) resistance of a bulb designed to use 100 W when it receives 12 V

  Calculate the mutual inductance between all pairs of coils

Three identical constant pitch thin helical coils (having a pitch 3mm, axial length 450mm and inner diameter 20mm) are positioned along a common axis. The axial distance between the first and the second is 55mm

  Write down only the first three harmonics

Four frequencies are applied at the input of a non-linear amplifier. Write down all of the frequency components at the output of the non-linear device. Write down only the first three harmonics. Frequencies of 1205Khz, 1200Khz, 1195Khz

  Design limiter circuits using only diodes and resisters

Design limiter circuits using only diodes and 10-k ohm resistors to provide an output signal limited to the range: (a) -0.7V and above (b) -2.1V and above (c) ±1.4V Assume that each diode has a 0.7-V drop when conducting.

  Power also noise calculations using decibel conversions

A radio receiver has a noise power N = kTB watts, with T = 100 K and B = 1.0 MHz. The value of k is 1.38 x 10^-23 J/K. What is the noise power in dBW?

  Calculate the ohmic value and power of the series resistor

A 250hp, 500v dc shunt motor draws a nominal field current of 5A under rated load. The resistance is 90ohms. Calculate the ohmic value and power of the series resistor needed so that the field current drops to 4.5A

  How many pulses per minute are being applied per minute

A pacemaker is programmed to deliver pulses a certain times every minute for a patient with heart block. A 0.5µF capacitor controls the pulse discharges through a 2M resistor. One pulse is delivered every time the fully charged capacitor loses 50%

  Design a three mode pid controller

A liquid level system converts a 4-10 m level into a 4-20mA current. Design a three mode controller (PID im assuming) that outputs 0-5 volts with 50% PB, 0.03 min integration time, and 0.05 min derivative time. Fastest expected change time is 0.8 ..

  What is the indicated temperature at the times

A temperature sensor has a static transfer function of 0.15mV/C and a time constant of 3.3s. If a step change of 22 degrees to 50 degrees C is applied at t=0, find the output voltages at .5s, 2.0s, 3.3s, and 9s. What is the indicated temperature a..

  How many turns must the motor make for the encoder

1. What is the force on a 10 cm wire carrying 1.0 A in a uniform magnetic field of 500 gauss 2. In the above example, if the current is in a loop of width 6.0 cm and the coil lies in the plane of magnetic flux, what is the torque on the loop

  Write the analytical expression for the waveforms

What would be the initial value of v c (t) when switch is closed and determine the time constants in both cases (switch is open, switch is closed).

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd