Find the power received at the mobile using two-ray ground

Assignment Help Electrical Engineering
Reference no: EM13276304

Assuming a receiver is located 10 km from a 50W transmitter. The carrier frequency is 1900 MHz. Assuming system gains of Gt = 0 dB, Gr = 3 dB, find the power received at the mobile using the two-ray ground reflection model assuming the transmitter antenna height to be 50 m, and the receiving antenna is 1.5 m above the ground with a path loss gradient index n= 4.

Reference no: EM13276304

Questions Cloud

Calculate the impedance of the combination in polar form : A 100µF capacitance is connected in parallel with the series combination of 10-mH inductance and a 1 ohm resistance. Calculate the impedance of the combination in polar form for angular frequencies of 500, and 1000 radians per second?
What impulse was applied to the ball during the collision : A rubber ball of mass 27.5 g is dropped from a height of 1.85 m onto a floor. What impulse was applied to the ball during the collision
What is the speed of sound in air : A tuning fork with a frequency of 440 Hz is held just above the top of a uniform glass tube containing water. What is the speed of sound in air
What interest deduction can the company take on these bonds : what interest deduction can the company take on these bonds in the first year? In the last year?
Find the power received at the mobile using two-ray ground : Assuming system gains of Gt = 0 dB, Gr = 3 dB, find the power received at the mobile using the two-ray ground reflection model assuming the transmitter antenna height to be 50 m, and the receiving antenna is 1.5 m above the ground with a path loss..
What is the effective annual interest rate : Costs of Borrowing: Come and Go Bank offers your firm a discount interest loan at 9% compensating balance against the amount borrowed. What is the effective annual interest rate on this lending arrangement?
Explain the troposphere from most abundant : Order these five gases that occur in the troposphere from most abundant to least abundant: Rn, CO2, CO, N2, Ar and O2.
Why were the irr and the pi revised : Second, the Profitability Index (PI) has been revised giving a Modified Profitability Index (MPI). Why were the IRR and the PI revised? When are these measures appropriate to use?
Working capital fund operations : Estimate is in constant FY 1995 dollars, while the SPANIEL program cost estimate is in constant FY 1999 dollars. Which one of the following is the most valid way of comparing the costs of these two programs?

Reviews

Write a Review

 

Electrical Engineering Questions & Answers

  Design a circuit that takes an input signal that can swing

For input signal voltages between these limits, the input should pass unaltered to the output. The peak current drawn from the input source may not exceed 1mA. You may use any circuit component we've studied except opamps.

  What effect would signal source impedance have on amplifier

How high of a signal source impedance can exist and still provide an output signal from an inverting amplifier circuit. What effect would the signal source impedance have on the non-inverting amplifier.

  Find energies for two lowest states for an electron in well

A quantum well has a finite-height barrier on one side and an infinitely high barrier on the other. Find the energies for the two lowest states for an electron in the well. The width of the well is L = 1 nm and the height of the finite step is Uo ..

  Detrmine amplitude and phase angle of each component

a) Detrmine Frequency response of a 3rd order high-pass filter having a cutoff freq at 150hz. b) Detrmine freq response function of 4th order low-pass filter ahving cutoff freq at 600hz.

  Determine the maximum deflection of the outer spring

An 8-kg plunger is released from rest in the position and is stopped by two nested springs; the constant of the outer spring is k1 = 4 kN/m and the constant of the inner spring is k2 = 12 kN/m. If the plunger is released from the height

  Determine the flux per pole in the machine

A permanent magnet dc motor has two poles and a simplex lap winding of 18 loops and 3 turns per loop. The armature radius is 4 cm and the armature length is 15 cm. The flux density under the poles is 0.74 T.

  What is the power supplied by the current source

e) What is the value of C such that the energy stored in the capacitor equals the energy stored in the inductor f) How much energy is stored in the 3.9?F capacitor Use the formula for the energy. g) What is the power dissipated in the resistors

  What does shift register contains after three clock pulses

An 8 bit shift register is configured so that the output of the least significant bit is fed back to the input of the most significant bit. If the register has an initial state of 11010001, what does the shift register contains after three clock p..

  Determine the power at the 7-ohm resistor

determine the initial condition on the capacitor voltage if you assume the Vc(0)=20V, determine the capacitor voltage at t=0.75s assuming Vc(0)=20V, determine the power at the 7ohm resistor.

  How z axis field reduces to point charge at large value of z

Given the surface charge density,ρs =2μ c/m2 , exsisting in region ρ=0.2m, z=0, find E at (a) PA(ρ=0, z=0.5); (b) PB(ρ=0, z=-0.5). Show that (c) the field along the z axis reduces to that of an infinite sheet charge at small values of z

  Explain what can be deduced about b and why

A 2-input NOR gate has inputs A and B. If the output of the gate remains LOW independent of the state of input A, what can be deduced about B

  Design a plc program if motor ol contacts are hardwired

Design a PLC program and prepare a typical I/O connection diagram and ladder logic program for the following motor control specifications:1) A motor must be started and stopped from any one of three start/stop pushbotton stations.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd