Find the maximum number of totally dark fringes on screen

Assignment Help Physics
Reference no: EM13543559

Laser light of wavelength 632.8 nm falls normally on a slit that is 0.0250 mm wide. The transmitted light is viewed on a distant screen where the intensity at the center of the central bright fringe is 8.50 W/m2.

Find the maximum number of totally dark fringes on the screen, assuming the screen is large enough to show them all.

At what angle does the dark fringe which is most distant from the center occur?

Reference no: EM13543559

Previous Q& A

  Mathematical relationship between velocity and time

Write down the mathematical relationship between velocity (v) and time (t) for a coin tossed up into the air after it leaves the thrower's hand at t=0 with a velocity of +15.0 m/s. Assume that the positive direction is upward and the acceleration of ..

  What would the pressure be within the container

Consider 1cm³ of liquid nitrogen contained within a 5cm³ sealed container. If the temperature of the container is raised to 293 K and all of the liquid nitrogen were to subsequently evaporate, what would the pressure be within the container?

  Assume there is no friction on the ramp

A skier leaves the starting gate at the top of a ski jump with an initial speed of 4 m/s. the starting position is 120 m higher than the end of the ramp, which is 3 m above the snow. FIND THE FINAL SPEED of the skier if he lands 145 m down the 20 deg..

  No friction between cannon and the ground

A cannon with a mass of 115 kg shoots a cannonball with a mass of 8 kg .If the speed of the cannon ball as it leaves the cannon is 185 m/s,what is the speed of the cannon at that time??(assume cannon is initially at rest,not fastened down in any way,..

  What are the frequencies of the two modes of vibration

Two equal objects (of mass m) on effectively frictionless horizontal air track are held between rigid supports by three identical springs (spring constant k) in a set up of one spring attached to each of the supports and one of the masses and the thi..

  What is the angular speed of the rod and ball

A thin, cylindrical rod L = 20.6 cm long with a mass m = 1.20 kg has a ball of diameter d = 6.00 cm and mass M = 2.00 kg attached to one end. The arrangement is originally vertical and stationary, with the ball at the top as shown in the figure be..

  What is the rotational frequency of the iron core

If a iron core of a collapsing star initially spins with a rotational frequency of fo=3.4 per second and the core radius decrease during the collapse by a factor of 24. what is the rotational frequency of the iron core at the end of collapse

  Differentiate the amplitude of a forced oscillator

Differentiate the amplitude of a forced oscillator to find the frequency that yields the maximum amplitude. Under what conditions is the maximum driving amplitude close to the natural frequency?

  A pendulum is constructed by attaching a small metal ball

A pendulum is constructed by attaching a small metal ball to one end of a 1.25 m long string that hangs from the ceiling. the ball is released when it is raised high enough for the string to make an angle of 30.0 degrees with the vertical. how fast i..

  What is new pressure of gas relative to its initial pressure

A 4.0-kg rock is dropped from a height of 21.0 m. At what height is the rock's kinetic energy twice its potential energy? ?? m A cylinder of gas is at room temperature (20°C). The air conditioner breaks down, and the temperature rises to 49°C. Wha..

Reviews

Write a Review

 

Similar Q& A

  Find the angle that the hill makes with the horizontal

A child slides down a snow-covered slope on a sled. At the top of the hill, her mother gives her a push at a speed of 1.5 m/s to get her started. find the angle that the hill makes with the horizontal

  How does size effect fluorescence from quantum dots

How does size effect fluorescence or emission from quantum dots and what you know about single quantum dot experiments for Nitride based quantum dot materials - as outlined in the lectures

  Compute the speed of the ball just before it lands

A golfer hits a shot to a green that is elevated 3.00 m above the point where the ball is struck. find the speed of the ball just before it lands

  Find the momentum of the puck

Express the velocity of the puck in the unit vector(i,j) notation and in the magnitude and angle notation. Vx = 0.026m/s Vy = 0.053m/s And then find the momentum of the puck

  What fraction of energy would still be left

One design challenge for a capacitor-powered electric car is that the voltage would change with time as the capacitors discharge. what fraction of energy would still be left

  Determine the decay constant and half life of the sample

A count rate meter is used to measure the activity of a given sample. At one instant, the meter shows 4.750 counts/min. Five minutes later, it shows 2700 counts/min.

  Determine at what rate is energy now dissipated

An unknown resistor is connected between the terminals of a 7.50 V battery. Energy is dissipated in the resistor at the rate of 0.510 W. At what rate is energy now dissipated

  What is the magnitude of n at the lowest point

How does the magnitude of electrical force between a pair of charged objects change while the objects are moved twice as far apart? Three times as far apart.

  What should be the diameter of the wire

In order to fabricate a uniform wire of resistance 1.2 ?, out of m=1 g copper which has a density of 8.92×103 kg/m3, What should be the diameter of the wire

  What is the potential drop across the resistor

A resistor of 2 ? and another of 3 ? are connected in parallel, and this combination is joined in series with a 4-? resistor across a battery. what is the potential drop across the 3-? resistor

  Calculate the component of the earth magnetic field

One can not align the apparatus to eliminate entirely the effects of the Earth's magnetic field. calculate the component of the earth magnetic field perpendicular to the entering electron beam

  What amount of heat flowed into the water

Your new super power Heat-O-Matic insulated blender has both a violent chopping blade and a heating element, what amount of heat flowed into the water from the heating element

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd