Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A sample of dry sand with a specific gravity total of 16.49 kN/m3 and a relative density of 2.67 grains, is placed outdoors. During a rainy period, the sample volume remains constant but the degree of saturation increases to 40%. Determine the specific weight and total moisture content of the sample after the rain.
A tape is calibrated and found to measure 100.04ft between the 0- and 100-ft marks. What measurements should be laid out to establish a horizontal distance of 682.25ft?
A log that is 2 ft in diameter is to be cut into a rectangular section for use as a simply supported beam. The material is wood select structural grade (Douglas Fir) with a specific gravity of 0.017 lb/in3.
What are the annual runoff coefficient (Runoff/Rainfall ratio) for the sub areas and for the total watershed taken as whole Sub-area Area (m2)/ Annual Precipitation (mm)/ Annual Evaporation (mm) A 10.7 1030 530 B 3.0 830 438 C 8.2 900 430 D 17...
A constant head permeability test was conducted on a clean sand sample. The diameter and length of the test specimen were 10 cm and 12 cm respectively.
A catchment has an area of 150 ha and a runo/rainfall ratio of 0.40. If due to a 10 cm rainfall over the catchment a stream flow at the catchment outlet lasts for 10 hr, what is the average stream flow in the period
a cantilevered bean has a lenght of L, a cross section area of A, and a flecural rigidity of EI. The free end is free to rotate and displace due to bending. derive the stiffnes of the cantilevered bean. Assume small deformations.
A 3000-lb car has a maximum speed (at sea level and on a level, paved surface) of 140 mi/h with 16" radius wheels, a gear reduction of 3.5 to 1, and a drivetrain efficiency of 92%. It is know that at the car's top speed the engine is producing 220..
An aluminum rod (1) (E=80 GPa, d=24.5 x 10-6/oC) and a brass rod (2) (E=115 GPa, d=22.0 x 10-6/oC) are connected to rigid supports. The cross-sectional areas of rod (1) and (2) are 4,000 mm2 and 5,000 mm2
a). Determine the state of stresses in the walls and indicate these stresses (including arrows to denote the direction of the stresses) on the element below. b). Then, determine the maximum in-plane shear stress on the wall of the pipe using Mohr's..
A 1.5 m diameter culver (concrete barrel, well - rounded entrance) that is 20m long is installed on a slope of 2 percent. The design discharge is 9.5 m^3/sec and the inlet will be submerged but not the outlet.
A 6-ft range pole is set over a station on which a sight is to be made with a the odolite. If the sight is made to the center of the rod 4-ft up from the ground, and the center of the top of the pole is out of plumb 0.12 feet in a direction normal..
Set up life cycle diagram for both alternatives and calculate net present value (NPT) and annual cost for the life time.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd