Find line to-neutral and line-to-line voltage phasors

Assignment Help Electrical Engineering
Reference no: EM13269914

A balanced positive-sequence wye-connected 60-Hz three-phase source has line-to-line voltages of VL = 208V rms. This source is connected to a balanced wye-connected load. Each phase of the load consists of an impedance of 30 + j40 *. Find the lineto- neutral voltage phasors, the line-to-line voltage phasors, the line-current phasors, the power, and the reactive power delivered to the load. Assume that the phase of Van is zero.

Reference no: EM13269914

Questions Cloud

What is the weighted-average flotation cost for the firm : If your firm follows the practice of incorporating flotation costs into the project's initial investment, what is the weighted-average flotation cost for the firm?
What is the operating cash flow : Chevelle, Inc., has sales of $41,500, costs of $19,600, depreciation expense of $1,800, and interest expense of $1,000. If the tax rate is 35 percent, what is the operating cash flow, or OCF?
The great leap forward : History of Modern Asia - You need prepare paper on The Great Leap Forward
What is the resonant absorption wavelength : Consider an optical gain medium that has two levels at E 1=1.50 eV and E 2=3.50 eV. What is the resonant absorption wavelength
Find line to-neutral and line-to-line voltage phasors : A balanced positive-sequence wye-connected 60-Hz three-phase source has line-to-line voltages of VL = 208V rms. This source is connected to a balanced wye-connected load. Each phase of the load consists of an impedance of 30 + j40 *
What was the reduction in the mechanical energy : A 62 g Frisbee is thrown from a point 1.3 m above the ground with a speed of 15 m/s. What was the reduction in the mechanical energy of the Frisbee-Earth system because of air drag
What is the expected change in net income : The interest rate on the notes payable is 10%, and the tax rate is 40%. If the firm implements the plan, what is the expected change in net income?
What minimal bandwidth is necessary for the monitor : A chest radiograph of 43cm x 35cm is to be viewed on a v monitor wih a resolution of 3 lp/mm. what minimal bandwidth is necessary for the monitor if the image is displayed at 60Hz non-interlaced
What is the increase in thermal energy of the floor : A horizontal force of magnitude 34.5 N pushes a block of mass 4.09 kg across a floor where the coefficient of kinetic friction is 0.609. During that displacement, the thermal energy of the block increases by 39.3 J. What is the increase in thermal ..

Reviews

Write a Review

Electrical Engineering Questions & Answers

  What is the magnetic dipole moment of each cobalt atom

determine that the total field B within the sample is one tesla. Calculate M and determine what percentage of the volume now consists of domains with magnetization parallel to the field.

  Determine the resistance range for resistors with color code

1) Determine the resistance range for resistors with the following color codes: a. Red-Orange-Orange-Silver b. Gray-Red-Red-Gold c. Yellow-Purple-Yellow-Gold 2) Determine the color code for the f..

  Determine the slope of the bh curve

For most low reluctance materials currently available and used in practical magnetic devices such as transformers, the slope of the BH curve may be always be considered constant over the possible range of operation of the device.

  Calculate proper amount of voltage would need to achieve

Suppose you have a 2 kW electric heater rated for 220 volt operation, which you intend to operate at a reduced power dissipation of 1kW. Calculate the proper amount of voltage you would need to achieve this reduced power dissipation

  What is the effective data rate

What is the effective data rate of this transfer (not counting the time for reading or writing the DVDs)?

  Find the total dissipated power when the resistor is same

The power dissipated in the resistor is 62 W when connected to a 10V source. Find the total dissipated power when the same resistor is connected to a 5V source.

  Why the power factor of the motor changes as rotor speed

Write at least one paragraph explaining why the power factor of the motor changes as the rotor mechanical speed changesin the induction motor. evaluate when the machine is operating in motor mode or generator mode.

  Develop an expression for the time to drain the tank

The stepped cylindrical tank is initially filled with liquid water at STP to a height H1. Subsequently, a plug at the bottom of the tank is removed to allow water to flow from the small hole of diameter d. The velocity v of the flowing water

  Develop an approach using the ite-operator

In other words, your approach should be able to answer the question whether two BDDs are complements of each other, without using the complement operation.

  Find the inductance of the inductor with n turns

Suppose that an inductor is formed by N turns of a conductive wire wound around a magnetic material. The magnetic material forms a circular cylinder of radius r = 10 cm, and height h = 5 cm. The inductance of the inductor turns of N is defined as:..

  Does arrangement violate osha standards for fall protection

the worker's safety harness D-ring is attached to a 12-foot shock absorbing lanyard that is securely fastened to the structure at a point 40 feet above ground level. Does this arrangement violate OSHA standards for fall protection? Explain.

  Determine the rms generated voltage of an alternator

Determine the RMS generated voltage of an alternator used for a 50 Hz system if it has a flux per pole of 0.015 Wb, 72 turns per phase and a winding constant of 0.96

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd