Find its first-law and its second-law efficiencies

Assignment Help Civil Engineering
Reference no: EM131233633

1. Find the isentropic efficiency and the second-law efficiency for the compressor in Problem 8.26.

Problem 8.26

A compressor in a refrigerator receives R-410a at 150 kPa, -40?C and brings it up to 600 kPa, using an actual specific work of 58.65 kJ/kg in adiabatic compression. Find the specific reversible work.

2. A steam turbine has inlet at 4 MPa, 500?C and actual exit of 100 kPa, x = 1.0. Find its first-law (isentropic) and its second-law efficiencies.

Reference no: EM131233633

Questions Cloud

Homogeneous or nonhomogeneous : For the equations below, z(t) is the unknown function. Determine whether these equations are (i) linear or nonlinear, (ii) first, second or third order, (iii) homogeneous or nonhomogeneous, (iv) ODEs or PDEs:
Develop a blast design for the project : Develop a blast design for the project. - what is the cost per cubic of rock if the ANFO is $0.166 per Ib, and dynamite $1.272 per lb?
Find the second-law efficiency for the compressor : A steam turbine inlet is at 1200 kPa, 500?C. The actual exit is at 300 kPa, with actual work of 407 kJ/kg. What is its second-law efficiency?
Station in rockport at the same time : Two freight trains leave the station in Rockport at the same time. The first train is headed due south at a speed of 22 miles per hour. In comparison, the second train is going due north at 32 miles per hour. In how long will the trains be 140 mil..
Find its first-law and its second-law efficiencies : A compressor in a refrigerator receives R-410a at 150 kPa, -40?C and brings it up to 600 kPa, using an actual specific work of 58.65 kJ/kg in adiabatic compression. Find the specific reversible work.
Why and when will it reoccur : Most venture capitalists say: There is too much money chasing too few deals. Why is this so? When does this happen? Why and when will it reoccur?
Find the second-law efficiency for the compressed air system : Find the second-law efficiency for the compressed air system in Problem 8.65. Consider the total system from the inlet to the final point of use.
Determine the number of tons per hour produced : A jaw crusher, with a closed setting of 3 in., produces 200 tph of crushed stone. -Determine the number of tons per hour produced.
In how long will the planes pass each other : Two planes are flying directly towards each other. The first plane is traveling at 1,100 kilometers per hour, and the second plane is traveling at 1,300 kilometers per hour. Currently, they are 1,600 kilometers apart. In how long will the planes p..

Reviews

Write a Review

Civil Engineering Questions & Answers

  What is the thickness in mm of the paint on the wall

one gallon of paint(volume=3.78 x 10^ -3) covers an area of 25 m^2. what is the thickness in mm. of the paint on the wall

  Determine the pressure in the tank indicated by a strain

A single strain gage forming an angle B = 18 degrees with a horizontal plane is used to determine the gage pressure in a cylindrical steel tank. The cylindrical wall of the tank is 6mm thick, has a 600mm inside diameter

  Determine the moment of the l6-n force about point b

A foot valve for a pneumatic systemis hinged at B. Knowing that a=28degrees, determine the moment of the l6-N force about point B by resolving the force into horizontal and vertical components

  Determine the acceleration of the rod

A rectangle commercial building must be laid out 200.00 ft wide and 300.00 ft long. if the steel tape used is 100.02 ft long under standard conditions, what distances would be laid out?.

  Determine the speed at which the ball is kicked

The ball at A is kicked such that theta=30 degrees. If it strikes the ground at B having coordinates x=15 ft, y= -9ft, determine the speed at which it is kicked and the speed at which it strikes the ground.

  Determine what is the stationing of the pt

A crest vertical curve and a horizontal curve on the same highway have the same design speed. The equal-tangent vertical curve connects a +3% initial grade with a +1% final grade and has a PVC at 101+78 and a PVT at 106+72

  Determine the shear force and bending moment diagrams

a 200 lb divers stands on the end of the diving board. determine the shear force and bending moment diagrams

  How much caco3 is produced per hour

A slurry containing 20 percent by weight of limestone (CaCO3) is processes to separate pure dry limestone from water. If feed rate is 2000kg/h, how much CaCO3 is produced per hour?

  Calculate the required diameter of steel tie rods

CALCULATE THE REQUIRED DIAMETER OF STEEL TIE RODS NECESSARY TO SUPPORT A BALCONY. EACH ROD, SUSPENDED FROM A ROOF TRUSS, SUPPORTS A FLOOR AREA OF 7.0m^2. THE COMBINED BALCONT FLOOR LOAD IS 10.5 kPa

  What additional factors should terry consider when deciding

Terry wants to purchase a used car for $8000. The dealer offered to finance the deal at 8.5% APR for 4 years with 10% down payment. Terry's bank will provide a loan at 7.8% for 3 years

  Location and magnitude of the maximum vertical deflection

Find the location and magnitude of the maximum vertical deflection - Find the deflection under the load using the Moment-Area Method

  Determine the 50-kg crates velocity when t is given

If the force exerted on cable AB by the motor is F =(100^3/2) N, where t is in seconds, determine the 50-kg crates velocity when t = 5s. The coefficents of static and kinetic friction between the crate and the ground are u(s) =.4

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd