Find angle cde

Assignment Help Civil Engineering
Reference no: EM13561492

Fred and Mary, a survey crew with pressure to get data quaickly,came back to the office with the data described below:

They surveyed a 5-sided closed loop traverse with corners A-E.

The azimuth of AB = 332º07’00”

At A, Mary sighted on point B and measured angle BAE by turning an angle to the right. The angle BAE is 113º42’00”. Then, they measured distance AB as 300.11 ft.

Mary then set up a B and sighted back to A and turned an angle to the left of 95º44’00” to point C. The distance BC was recorded as 412.54 ft.

At point C, they backsighted to B and turned an angle to the left of 109º58’00” to point D. The distance CD was recorded as 369.12 ft.

At point D, Fred measured the distance to point E, the final point, to be 405.27 ft. The noon whistle sounded (you may have to have a little “small town” in you to appreciate the noon whistle), so they left in a hurry without measuring the angle CDE or setting up at point E. They thought they could just compute the missing values

Question

1) Find angle CDE

2) Find angle DEA

3) Find length EA

Reference no: EM13561492

Questions Cloud

Compute the tax npv : Assume that the before-tax required rate of return for Deer Valley is 14%. Compute the before-tax NPV of the new lift and advise the managers of Deer Valley about whether adding the lift will be a profitable investment. Show calculations to support y..
What is the minimum amount of carbon needed : You are assined the task of process design for a fixed-bed carbon adsorber system. You are given the following data: the inlet airstream flows at 5000 acfm (at 95 degrees F and 1 atm) and contains .2% n-pentane by volume; the proper operating carbon ..
Estimate the bed dimensions : Estimate how much carbon (in pounds) must be purcahsed for a typical 2-bed carbon adsorption system to treat 5000 cfm of air at 95 degrees F and 1 atm. The air contains 600 ppm of styrene.
Discuss all the advantages disadvantages and considerations : A flocculation/sedimentation combination basin in a conventional drinking water treatment plant is to be constructed of cast-in-place reinforced concrete. The horizontal flow rectangular basin will be located in New Jersey, USA
Find angle cde : At A, Mary sighted on point B and measured angle BAE by turning an angle to the right. The angle BAE is 113º42’00”. Then, they measured distance AB as 300.11 ft.
Specify the horsepwoer of the fan motor : A fixed-bed carbon adsorption system consisting of two 3-foot-deep beds containing 6 x 16 mesh carbon operates at a superficial gas velocity of 60 ft/min
Compare two conflict resolution techniques : Compare two conflict resolution techniques. Explain the advantages and disadvantages as they relate to work situations, and provide an actual example of one method in action
Find how far up the incline do the monkey and sled move : In a circus performance, a monkey is strapped to a sled andboth are given an initial speed of 5.0m/s up a 16.0° inclined track. How far up the incline do the monkey and sled move
Compute the velocityat various points across the channel and : The pressuregradient is 60 kPa/m, and is negative.  Compute the velocityat various points across the channel and show the results on aplot.  Assume laminar flow.

Reviews

Write a Review

 

Civil Engineering Questions & Answers

  Calculating sand shear strength

Estimate the effective friction angle for the sand (assume c' = 0). Calculate the sand's shear strength (τf) on a horizontal plane at depths of the 20 ft and 50 ft.

  Describe the changes in phases and its structure

Consider a steel (iron) with 0.2 wt% C. Describe the changes in phases and its structure as it is heated under equilibrium conditions to 850 (deg C).

  What will be the final chemical composition and weight of

If a tank contains 1000 kg of the dilute acid and the concentrated acid is added at a rate of 100 kg/min, how long will it take to bring dilute acid strength to 75 wt% H2PO4? What will be the final chemical composition and weight of the final mixture..

  Determine what is the pore water pressure at that level

A river is 6m deep. The riverbed material has a saturated unit weight of 19.5kN/m3. What is the effective vertical stress 12m below the water surface. Assume the water is static and assume a datum at the water surface.

  Is change in z dependent upon the specific weight or density

If a large pool of water was rotating the same speed as an amusement ride, how far would the surface of the water rise, between the where the chairs are hanging when the ride stopped- which is 15ft from the center support column, and where the chairs..

  Determine the fraction of h at ph 6 and ph 8

Hydrogen sulfide (H2S) is an odorous gas that can be stripped from solution by gas stripping. The efficiency of the process will strongly depend on the pH of the solution. The equilibrium reaction is: in a pocess similar to ammonia.

  What is the critical state angle of friction of the soil

The soil undergoes shear failure and reaches critical state on this plane when the pore-water pressure is increased to 120 kPa while keeping the total normal and shear stresses constant.

  What fraction of chemical would you predict to reach ocean

The pesticide methyl parathion is leached into a stream from an abandoned disposal site. Is photolysis likely to be a significant sink for this chemical. If the travel time to the ocean is 5 days

  Determine the maximum speed of the block in the subsequent

A block of mass m is attached to two springs as shown. Knowing that in each case the block is pulled through a distance x from it's equilibrium postition and released, determine the maximum speed of the block in the subsequent motion.

  At what rate must pac be added to meet the proposed standard

A municipal drinking water treatment plant discovers that it has an unacceptably high level of the pesticide carbofuran and must develop a treatment technique to reduce the concentration to satisfy the relevant water quality standard.

  Determine the distance that a particle on the rim moves

The flywheel of a prototype car engine is under test. The angular position of the flywheel is given by x = (3.0rad/s3)t3 and the diameter of the flywheel is 36cm.

  Determine minimum resale price needed to make the challenger

A lumber company that cuts fine woods for cabinetry is evaluating if it should retain the current bleaching system or replace it with the new one. The relevant costs of each system are known or estimated.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd