Find and plot the first 4 samples of the output

Assignment Help Electrical Engineering
Reference no: EM13264526

Given an input signal x[n] whose sample values are given in the table below. Find and plot the first 4 samples of the output that results when this input is applied to the two filters below: (Use n=0, 1, 2,3)
A: Filter 1 Equation: y[n] = x[n] - 0.5 x[n-1]
B: Filter 2 Equation: y[n] = 2y[n-1]+x[n]

Table 1: Input signals x[n] values
X[0]=1, x[1]=0, x[2]=3, x[3]=2

Reference no: EM13264526

Questions Cloud

What should be the price of abcs bonds : You also know that bonds with similar risk are selling at YTM of 15%. What should be the price of ABCs' bonds?
Determine the average-peak and rms inductor currents : A buck converter has an input of 6 V and an output of 1.5 V. The load resistor is 3 , the switching frequency is 400 kHz, L 5 H, and C 10 F. (a) Determine the duty ratio. (b) Determine the average, peak, and rms inductor currents.
How far from the cliff must the ship be : A ship at sea has its radio transmitting antenna at a 10 m height above the surface of the water. how far from the cliff must the ship be
How to draw a virtual trail map in processing : How to draw a virtual trail map in Processing? with camera view and able to make an object running?walking to a specific location. Then by using mousepressed,can click the specific location,in order to provide more information on that specific locati..
Find and plot the first 4 samples of the output : Given an input signal x[n] whose sample values are given in the table below. Find and plot the first 4 samples of the output that results when this input is applied to the two filters below: (Use n=0, 1, 2,3) A: Filter 1 Equation: y[n] = x[n] - 0.5..
Mtv networks-the arabian challenge : Experts felt that one of the biggest challenges faced by MTV while launching MTV Arabia was the prevalent culture in the Arab world. Discuss the Arab culture. What challanges does the culture pose to MTV?
At what rate is entropy generated : Fluid is flowing through a pipe at a rate of 100 gal/min. The inlet pressure is 20 psig and the outlet pressure is 0 psig. At what rate [Btu/(hR)] is entropy generated
Which project should be accepted : Boston Chicken is considering two mutually exclusive projects with the following cash flows. What is the crossover rate? If the required rate of return is lower than the crossover rate, which project should be accepted?
What is the total transportation cost : What is the total transportation cost if each of the four sites should be selected - White site should be selected to locate the next cannery?

Reviews

Write a Review

 

Electrical Engineering Questions & Answers

  Which should be the signal power in the given case

A cable technician tested the signal-to-noise ratio on the curb as 20 dBm. This means, if the noise power is at 1 mW, then the signal power should be 20 dB higher then that. If the noise power is 20 mW

  Show k-maps that reduce the total number of gates needed

F(A,B,C,D)=Σ(0,2,3,4,6,7,10,11) and G(A,B,C,D)=Σ(0,4,8,9,10,11,12,13) Consider that the functions are to be implemented as part of the same circuit. Show k-maps that reduce the total number of gates needed. How many gates are required

  How much stator referred external resistance per phase

How much stator referred „external? resistance per phase should be connected in the rotor

  Find group delay between the highest modes

Parallel plate waveguide has plate seperation of 2cm, filled with dielectric material with an index refration of n=3, lenght of wavelengh guide z=50m opertaing at 10 Ghz. a) find the cutoff frequency

  Calculate conversion factor for converting voltage output

Through the data sheet the power meter is 4.5 HP. Find the hp range for PH-3A-HG in hp. The power meter measures the power and outputs a 0 - 10 voltage signal. Calculate the conversion factor for converting the voltage output from the sensor into ..

  Determine what is the maximum zener current allowed

For an ideal Zener, is the Zener voltage is 15v and the power rating is 750mW, what is the maximum zener current allowed What is the relationship between base current and collector current called

  Find what is the input power to the transmitter

A collector modulated transmitter has a supply voltage of 48 V and an average collector current of 600 mA. What is the input power to the transmitter. How much modulating signal power is needed to produce 100 percent modulation.

  Determine what is the frequency of oscillation

For a Wien-bridge oscillator Given R = 20Kohm and C = 10nF what is the frequency of oscillation Given a required frequency of oscillation of f = 3kHz and R = 5kohm, what should the value of C be

  Detect whether a pattern of at least three adjacent 1s occur

Design a combinational circuit that can detect whether a pattern of at least three adjacent 1s occur anywhere in an 8-bit input, and that outputs a 1 in that case. The inputs are a , b, c, d, e, f, g, and h, and the output is y.

  Find the slip at the maximum developed torque

(a) Find the slip at the maximum developed torque. (b) If we would like to get the maximum torque at starting (s=1), a method is to add more resistance to the rotor, R2,new=R2,old + Rextra, while the rotor reactance X2 stays the same.

  Why sinusoidal wave is chosen for ac fundamentals

why sinusoidal wave is chosen for AC fundamentals rather than a simple curve such as square or triangular wave?

  What is the electric field for r- inside the sphere

A sphere has a radius d and contains a non-uniform charge density of Pv=Po(1-r/d) C/m^3. (a). What is the enclosed Charge for r d (c). What is the electric field for r

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd