Evaluate the heat transfer per unit mass and work per unit

Reference no: EM13545534

A quality of water within a piston-cylinder assembly executes a Carnot power cycle. During isothermal expansion, the water is heated from saturated liquid at 50 bar until it is a saturated vapor. The vapor then expands adiabatically to a pressure of 5 bar while doing 364.31 kJ/kg of work.

a. Sketch the cycle on p-v coordinates.

b. Evaluate the heat transfer per unit mass and work per unit mass for each process in kJ/kg.

c. Evaluate the thermal efficiency.

Reference no: EM13545534

Questions Cloud

When the axial load p is applied show that the axial : The steel shaft of diameter D is cemented to the thin rubber sleeve of thick-ness t and length L. The outer surface of the sleeve is bonded to a rigid support.

What are the velocity and flow rate in the prototype : A dam spillway is to be tested using kinematic similitude (Froude scaling) with a 1:20-scale model. The model flow has an average velocity of 0.7 m/s and a flow rate of 0.06 m3/s.

How far upstream is the depth within 100mm : A dam located in a channel of rectangular cross-section which carries water flowing at a rate of 8.75m3/s. The depth of water upstream of the dam is 2.5m

Prepare two pages about photorefractive material : Prepare two pages about photorefractive material with references - Two wave mixing

Evaluate the heat transfer per unit mass and work per unit : A quality of water within a piston-cylinder assembly executes a Carnot power cycle. During isothermal expansion, the water is heated from saturated liquid at 50 bar until it is a saturated vapor. The vapor then expands adiabatically to a pressure of ..

Find the stress induced in the aluminum rod : Find the stress induced in the aluminum rod if, after the gap is closed, the two segments are welded together, and then a leftward force is applied of the same magnitude needed to close the gap. Assume the rod segments remain aligned during loading.

Design the pins so that the ledge can support doug : Assume the ledge has the dimensions shown and is attached to the building with a series of equally spaved pins around the circumference of the building.

Calculate the axial stress in each bar : The bottom bar is made up of an aluminum bar and a steel bar, each 10 in. long placed in the parallel configuration at 70 F. That is also heated to 300 F.

Plot the shear-force and bending-moment diagrams : Plot the shear-force and bending-moment diagrams for the beam and derive equations for the shear force V and the bending moment M for any location in the beam

User Account

All Pages