Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
An American 6-ft diameter multiblade HAWT is used to pump water to a height of 10 ft through 3-in-diameter cast iron pipe. If the winds are 12 mi/h, estimate the rate of water flow in gal/min
A saturated clay deposit is vane-tested in-situ. A torque of 30Nm is required to shear the clat. The vane is 40mm wide by 100mm long.What is the undrained shear strength of the clat in kPa?
Tank A has a volume of 100 liters and contains saturated vapor r-134 at 30C. With the valve open slightly flow enters cylinder B. a pressure of 200kpa is required to lift piston in b. the process ends when the pressue at A drops to 200kPa.
A piston-cylinder device contains helium gas initially at 150 kPa, 20 degrees C, and 0.5 m^3. The helium is now compressed in a polytropic process (PV^n = constant) to 400 kPa and 140 degrees C. Determine the heat loss or gain during this process.
The structure consists of a wood frame with plywood roof deck, wall sheathing and floor deck. general form of the building construction is to be determined by the designer.
How much of a reduction in the automobile emission rate would be required to achieve the maximum eight-hour average NAAQS for CO at steady state 9 ppmv ( (10.3 mg/m^3)?
What are the structural systems that the building uses? What challenges and opportunities will there be in replicating the structure? What are the challenges and opportunities offered by the site?
A watershed has four sub-areas. The annual precipitation and evaporation from each of the sub-areas are given in Table(below). Assume that there is no change in groundwater storage on an annual basis and calculate for the whole catchment the value..
If the detention storage on the paved section is increasing at the rate of 60 m3/hr, what is the runoff rate into the inlet grate?
A rod consisting of two cylindrical portions AB and BC is restrained at both ends. Portion AB is made of steel (E=29x10^6 psi, α=6.5x10^-6) and portion BC is made of aluminum (E=6.5x10^-6 psi, α=13.3x10^-6).
if a manometer incline at 45 degrees containing a fluid with specific gravity of a 2.0 using it to measure the pressure in a system, and the fluid levels rise 30 inches. What is the pressure in the system in Lbf/In^2 and H2O
An equal-tangent crest vertical curve has a 50 mi/h design speed. The initial grade is +3%. The high point is at station 33+37.43 and the PVT is at station 37+18.26. What is the elevation difference between the high point and the PVT
The bar is released from a position which gives it an angular velocity ω = 2 red/s as it passes the position θ = 45° Calculate the forces FA and FB exerted by the guide on the rollers for this instant.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd