Estimate the irradiance on the pv module facing south

Assignment Help Electrical Engineering
Reference no: EM13229562

The global radiation at the solar noon on a summer solstice in Albuquerque, New Mexico (latitude 35° N) is 60mw/cm^2. Assume that (a) 30 % of this irradiance is diffuse radiation and (b) the ground surrounding a PV module is non-reflecting and (c) the diffuse radiation is uniformly distributed across the sky. Estimate the irradiance on the PV module (flat surface) facing south at 45° to the horizontal

Reference no: EM13229562

Questions Cloud

What will be the output voltage from the bridge for a change : What will be the output voltage from the bridge for a change in temperature of 20o C The supply voltage to the bridge is 6.0 V and the temperature coefficient of resistance of the platinum is 0.0039 K-1.
Complete and balance the equations and the oxidizing agents : Complete and balance the following equations, and identify the oxidizing and reducing agents. (Recall that O atoms in hydrogen peroxide, H2O2, have an atypical oxidation state.)
Explain what is the physical significance of air mass : The sun is at an altitude of 30 degrees to the horizontal. What is the corresponding air mass What is the physical significance of air mass Mars has a very thin atmosphere containing primarily CO_2 and dust particles.
Write a brief explanation about why the directors : Write a brief explanation about why the directors' duty to prevent insolvent trading exists and the circumstances and consequences of the ‘veil of incorporation' being lifted for insolvent trading.
Estimate the irradiance on the pv module facing south : The global radiation at the solar noon on a summer solstice in Albuquerque, New Mexico (latitude 35° N) is 60mw/cm^2. Assume that (a) 30 % of this irradiance is diffuse radiation and (b) the ground surrounding a PV module is non-reflecting
State oxidized to an optically inactive dicarboxylic acid c : With aqueous H2CrO4, compound A was oxidized to an optically inactive dicarboxylic acid C, C6H10O4. Give structures for compounds A, B, and C; do not specify stereochemistry.
Design full-wave bridge rectifier circuit to deliver 10volts : Design a full-wave bridge rectifier circuit to deliver 10 volts de with less than 0.1 volt (pp) ripple into a load draWing up to 10mA. Choose the appropriate ac input voltage. assuming 0.6 volt diode drops.
Explain heating a with hydrazine in base gave hydrocarbon c : When optically active B was treated with CrO3 in pyridine, an optically inactive sample of A was obtained. Heating A with hydrazine in base gave hydrocarbon C, which, when heated with alkaline KMnO4, gave carboxylic acid D. Identify compounds A, B..
Explain causes of difference between the emitted radiation : Compare this spectral distribution with that of the radiation received on the surface of the earth at AM1.5. Briefly explain the causes of the difference between the emitted radiation of the core of the sun and the received radiation at the earth'..

Reviews

Write a Review

 

Electrical Engineering Questions & Answers

  Find the overall gain gv and the equivalent circuit

Two amplifiers(CS) connected in cascade. The input voltage to the first stage has a source voltage Vsig and Rsig= 100KOhm. Rv=10KOhm AND IS CONNECTED TO THE DRAIN OF THE SECOND STAGE. BOTH TRANSISTORS HAVE Id=.25mA and Vov=.25V

  Find speed of an electron beam coming from an electron gun

The axis of the cylinder is along the z axis, and the electrons are moving with a velocity vector v in the positive z direction. The velocity of the electrons is 0.1c where c is the speed of light (2.99792458 ´ 108 [m/s]). The magnitude of the cur..

  Calculate the armature voltage va at the instant

At some instant, it goes into regenerative braking. Calculate the armature voltage va at that instant, if the current ia is not to exceed 10A in magnitude. Assume that the inertia is large and thus the speed changes very slowly.

  Explain telephone channels and pcm analysis

Telephone channels and PCM analysis, The analog to digital converter (ADC) used in a telephone system outputs 8 bit words. The digital words are transmitted as a serial stream to form a PCM voice signal

  Finding out coding gain of a dsss-cdma transmitter

Evaluating Coding Gain, CNR, and BER of a DSSS-CDMA Transmitter, a. A DSSS-CDMA transmitter sends message signals at a rate of 5.0 kbps using a long chip sequence with a rate of 1 M chips per second. In the receiver, what is the processing gain (a..

  What are three advantages of using ac power

3)What factors started the decline in the nuclear power industry, and what events essentially ended new construction of nuclear power plant 4)What are three advantages of using AC power over using DC power

  Determine the current drawn from a three-phase line

Determine the current drawn from a three-phase 440 V line by a three-phase 15-hp motor operating at full load, 90% efficiency, and 80% power-factor lagging. Find the values of P and Q drawn from the line. (Hint: 1hp = 746W)

  What is the current through the resistor

A 1.0 dc voltage source is connected across a 10 ohm resistor. What is the current through the resistor if (a) the voltage source is ideal (b) the voltage source has internal resistance 0.1 ohm (c) internal resistance 1.0 ohm

  Define the outputs of two nand

Can you confirm-The outputs of two"NAND" gates are connected to the inputs of an "EXCLUSIVE OR" gate.Each of the "NAND" gates has one input at logic high level and the other input

  Define the transmission line has an impedance

The transmission line has an impedance of 600 ohms and is terminated in a load of 600 ohms. The transmitter delivers an average power of 0.1 W to the input of the line.

  Give empirical equations relating saturation temperature

Make a table showing Temperature as a function of pressure for Psat from 20 to 600 psia every 20 psi, and another table showing pressure as a function of temperature from 150 degrees to 350 degrees every 20 degrees.

  Design a three mode pid controller

A liquid level system converts a 4-10 m level into a 4-20mA current. Design a three mode controller (PID im assuming) that outputs 0-5 volts with 50% PB, 0.03 min integration time, and 0.05 min derivative time. Fastest expected change time is 0.8 ..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd