Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A point source with effective stack height of 50 m emits 80 g/s of on a clear summer day with surface winds at 4 m/s. Winds at 50 m are 5 m/s. An inversion layer starts at an elevation of 250 m.
(a) Estimate the ground- level concentration at a distance of 4 km downwind from the stack.
(b) If there had been no inversion layer, estimate the concentration 4 km downwind.
what would be the estimated total annual dollar savings of a company with an annual direct labor payroll of 2,500,000 and a fixed overhead rate of 150 percent of direct labor , if the company initiated a methods and standards program
Vehicles begin to arrive at a toll booth at eight vehicles per minute from 9 A.M. to 10 A.M. The booth opens at 9:10 A.M. and services at a rate of ten vehicles per minute until 9:40 A.M. From 9:40 A.M. until 10 A.M.
You try to freeze one liter of water at 10 degrees Celsius in ice trays in your freezer. Your freezer has a coefficient of performance of 5.5 and a power rating of 550 Watts, though only 10% of the power will go into freezing the ice.
A constant-head test was conducted on a sample of soil 15cm long and 60 cm^2 in cross-sectional area. The quantiities of water collected was 50 cm^3 in 20 seconds undera a head difference of 24 cm.
Suppose a specialty steel company receives an order for 200 tons of steel containing at least 3 percent nickel and 2 percent manganese, with a carbon content not exceeding 3.5 percent. The steel will sell for $25 a ton.
A section of a road has a superelevation of .6% and a curve of 600ft radius. What speed limit will you recommend at this section of the highway
While designing a shock absorbing bumper for a 5-Mg rail car, the spring used for the bumper follows a nonlinear relationship of F = ks2 where F is the force in Newtons and s is the compression distance in meters.
Near the point (x, z) =(3,2) in a flow with a zero y-component (v=0), the velocity component are described by u =3x-3z, and w = 6-4z+ x. The velocities u and w are in m/s and are in the x- and z- directions, respectively.
a component in a packaging machine is subjected to a tensile load of 36.6 KN which will be repeated several times over the life of the machine. The cross-section of the component is 12 mm thick and 20 mm wide.
Long Line: the slope distance and zenith angle measured from point a to point b were 17,685.20 ftand 93degrees 13' 46" . The instrument and reflector heights were equal. If the elevation of the point A is 1854.43 ft above the MSL Datum
Determine the unfactored dead load and live load on a typical interior roof beam, sketch the loading on the beam, and draw the shear and moment diagrams for the beam assuming the beam is simply-supported.
A glass tube with inside diameter of 2-mm is inserted vertically into a dish of mercury at 20°C. Determine the difference in mercury levels inside and outside the tube.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd