Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A pile group consist of four piles in cohesive soil. Each pile's diameter is 0.4 m, and center to center spacing is 1.2 m. The ultimate capacity of each pile is 300 kN. Estimate the design capacity of the pile group, using a factor of safety of 2 and the criteria suggested by Coyle and Sulaiman.
We know that the part has an intial crack of length 0.02 mm, and that the fracture toughness is 55 MPA(m)^1/2If the part is subject to cycle loading of 300 Mpa in tension and compression, calculate (assuming Y1.2, n = 3.4 and C = 2x10^-11 in units ..
determine the maximum wind load that the cavity wall , bothe wythes are fully grouted but unreinforced ,and type S mortar portland cement is used . prism strength is equal to 2666psi for the concrete block wythe and 5333 psi for the brick wythe.
Assume that the width of the intersection in 24 ft and the car is 20 ft long. If the driver's perception-reaction time is 0.75 seconds, determine if he can clear the intersection safely for the following conditions
Calculate the largest tolerable internal crack length for a 7075-T651 aluminum alloy component that is loaded to a stress one-half of its yield strength without catastrophic fracture.
The vehicle was estimated to hit the light pole at 30 mph. The skid was 650 feet long. How fast was the car traveling before applying the brakes
A 4 X 8-ft solar collector has water circulating through it at the rate of 1.0 gallon per minute (gpm) while exposed to sunlight with intensity 300 Btu/ft2-hr. Fifty percent of that sunlight is captured by the collector and heats the water flowing..
A steady flow of refrigerant 134a enters a throttling valve in a refrigeration unit as a satrurated liquid with a pressure of 150 psia. The refrigerant is discharged with a pressure of 40 psia.
Using the ADA code, what is the allowable minimum length of the ramp base if base if it is 2 ft high and the code is 1:12
A 4-cm- diameter rod of aluminum 7075-T6 is to subjected to an axial tensile force such that the factor of safety based on the yield stress on 1.75. Find the maximum allowable tensile force.
An SAE steel wire (1mm diameter) is coated with another cover to form a composite material with diameter of 2 mm. a) determine the elastic modulus of the composite material;
The average rate of flow measured in a gage at the outlet of the watershed was 30 m^3/sec. Estimate the water losses due to the combined effects of evaporation, transpiration, and infiltration due to ground water.
Suppose a specialty steel company receives an order for 200 tons of steel containing at least 3 percent nickel and 2 percent manganese, with a carbon content not exceeding 3.5 percent. The steel will sell for $25 a ton.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd