Energy transfer by heat into the system

Assignment Help Mechanical Engineering
Reference no: EM13718992

A system consisting of 2 kg of water initially at 160 C, 10 bar undergoes an internally reversible, isothermal expansion during which there is an energy transfer by heat into the system of 2700 KJ. Determine the final pressure (in bar) and work (in KJ).

Reference no: EM13718992

Previous Q& A

  Inlet-outlet air temperature of centrifugal flow compressor

The inlet and outlet air temperature of a centrifugal flow compressor are 70oF and 120oF respectively (See Figure 1). The air flow steadily at a mass flow rate of 24 lbm/min. If the compressor is adiabatic, determine the rate of work at which the air..

  Turbine operated in two stages in series using steam

A steady-state, well insulated turbine operated in two stages in series using steam . The first stage has an efficiency of 85% and the second stage 90%. Steam enters the first stage at 400 C degree and 4 MPa and exits at 1.5 MPa.

  The entropy generation of the pump

Water enters a pump at 120 kPa and 25 C degree at a rate of 1.5 kg/sec and leaves at 4 MPa . The pump has an efficiency of 75% . Determine The actual power input in KW. The entropy generation of the pump.

  Find the compressor efficiency and the entropy generation

An adiabatic compressor is used to bring saturated water vapor at a pressure of 103 lbf/in^2 up to 1000 lbf/in^2 , where the actual exit temperature is 1000 F degree. Find the compressor efficiency and the entropy generation. is there an improvement ..

  Turbine surroundings maintain their temperature

Steam is expanded from 20 bars, 280 C to 100kPa through an adiabatic, steady flow turbine whose isentropic efficiency is 90%. The turbine surroundings maintain their temperature at 27 C. How much entropy is generated by this process and does this pro..

  Domestic how water supply

Steam at 500KPa 300 C is used to heat cold water at 15 C to 75 C for domestic how water supply. How much steam per kg liquid water is needed i the steam should not condense?

  Saturated liquid entering and saturated vapor exiting

A Carnot power cycle operates at steady state with water as the working fluid. The boiler pressure is 200lbf/in^2, with saturated liquid entering and saturated vapor exiting. The condenser pressure is 20lbf/in^2.

  Air flows with heat exchanger

Air at 600k flows with 3 kg/s into a heat exchanger and out at 100 C. How much (kg/s) water coming in at 100 KPA, 20 C can the air heat to the boiling point?

  Clockwise without slipping on the fixed horizontal surface

At the instant shown, the rigid body OA rolls counter clockwise without slipping on the fixed horizontal surface, and point O has a velocity 2 m/s to the left and an acceleration of 1 m/s2 to the right. Point O is at the center of the semi-circle reg..

  Cauldron of boiling liquid with a pulley system

A witch lifts her cauldron of boiling liquid with a pulley system. Once the cauldron is lifted, liquid issues from two identical holes of cross-sectional area 2,000 mm2 (each) with a velocity of 30 m/s. The liquid sprays 30o below the horizontal.

Reviews

Write a Review

 

Similar Q& A

  Tensile stress and compressive stress

How the tensile stress and compressive stress result in the moment about neutral axis when the beam fails

  Determine the required length l

Determine the required length L of each splice if a factor of safety is 2.75.

  The ambient conditions are p 100 kpa and t 25 degrees

a wind-turbine generator is designed to produce 3.5 x 106 kwhr per year with an annual plant factor of 0.40. the design

  At what rpm should the model be run what is the required

a 20 mw radial flow hydraulic turbine is to be designed with a head of 70 m and a speed of 90 rpm. a geometrically

  Determine the decrease in exergy of the steam

Steam is throttled from 9 MPa and 500V to a pressure of 7 MPa. Determine the decrease in exergy of the steam during this process. Assume the surroundings to be at 25C.

  At what location s will the combined moment of the weights

At what location s will the combined moment of the weights of the man and platform about point B be zero?

  The power input to the steam is known to be 500 w determine

a refrigeration system is designed to operate between temperture limits of -10 c and 25 c. the power input to the steam

  If half of these are coal-fired how many tons of coal will

the average electrical generating capacity of the united states was about 475000 mw in 2007. if trends continue this

  Determine the upward force the water will exert on the duct

an air-conditioning system requires a 20-m long section of 15-cm diameter duct work to be laid underwater. determine

  Tarzan king of the jungle mass 662 kg grabs a vine of

tarzan king of the jungle mass 66.2 kg grabs a vine of length 14.6 m hanging from a tree branch. the angle of the vine

  List three engineering components applications that in

1. list three engineering components applications that in your judgment need high stiffness and low weight. what

  Analyze the static stability of the floating cylinder

A uniform solid circular cylinder of density 0.5p floats in a liquid of density p with its axis upright. The radius and height of the cylinder are R and 2R, respectively. Determine the mecacentric height and analyze the static stability of the floati..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd