Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
The bearing supports A , B , and C exert only vertical reactions on the shaft. Determine these reactions, then draw the shear and moment diagrams. EI is constant. Use the moment-area theorems.
A concrete building has floor area 10 m by 20 m and is 4 m high. THe building has four windows with a height 1.6 m and a width 2 m. After 10 minutes gases in the room have an average temperature of 700 degree Celcius.
A 5-m wide rectangular channel is carrying a flow of 5 cubic meter per second. If the Manning n=0.013 and the bottom slope, So=0.0001, determine the normal depth using a converging iteration.
a) What was the discharge capacity andvelocity at full flow at the time of installation b) If the pipe presently carries a flow of15 cfs when full, determine the present velocity and present value of n.
a 15 kg mass attached to a cord that is wrapped around a pulley and released from rest. the pulley has mass of 5 kg but is frictionless. consider the cord as mass less, inelastic and frictionless.
A company near City X want's to know how much benzene they can release into River Y. City Z is 85.5 miles downstream from City X. City Z doesn't want to have Benzene levels higher than 0.0000015 g/L.
The current vertical stress at a point in a saturated clay is 181 kPa. This soil is to be covered with a 2.5m thick fill that will have a unit weight of 19.3 kN/ m^3. What will be the value of the vertical
Need to know how the equation for splitting tensile strength of a concrete cylinder f(ct) = 2P/pi*D*L is derived using mechanics of materials or linear elasticity approach.
A girder that carries a uniformly distributed dead load of 1.7 K/ft plus its self-weight and three concentrated live loads of 15 kips at quarter points of that 36 ft span is to be sized.
The ball is kicked so that it has a velocity of 0.5 m/s and the cord is pulled in at a rate of 0.2 m/s. Neglect friction so that the only important force on the ball is the tension in the cord. Find the tension in the cord when the radius is 0.25 ..
A 4-cm- diameter rod of aluminum 7075-T6 is to subjected to an axial tensile force such that the factor of safety based on the yield stress on 1.75. Find the maximum allowable tensile force.
The slope of the hill is such that for each mile (5280 ft) of horizontal distance, the change in elevation is Δz. Determine the maximum value of Δz if the flow is to remain laminar and the pressure all along the pipe is constant.
You are constructing an embankment of 250,000 cubic yards of material. The material has a shrink percentage of 18%. How many bank cubic yards will be required to complete this embankment
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd