### Detrmine amplitude and phase angle of each component

Assignment Help Electrical Engineering
##### Reference no: EM13256730

a) Detrmine Frequency response of a 3rd order high-pass filter having a cutoff freq at 150hz

b) Detrmine freq response function of 4th order low-pass filter ahving cutoff freq at 600hz

c) Apply the signal to high-pass filter followed by the low-filter. Detrmine amplitude and phase angle of each component

#### Detrmine the phase angles of the two frequency components

The output/ input of a system is 30dB. detrmine the ratio Express x(t)=4*cos(100*t-45)+ 2*cos(250*t+30) in terms of exponential functions Then Detrmine the phase angles(in d

#### Calculate the output for each system for given input

The signal x(t)=10cos(t)+10sin(10t) is input into the following systems: a) \(H(s)=100/(s^{2}+10s+100)\) b) \(H(s)=s^{2}/(s^{2}+10s+100)\) calculate the output for each system

#### Design a sequential circuit that continuously computes

design a sequential circuit that continuously computes the function 2X + 3 or 3X + 1 where the variable X is a three-bit unsigned integer available on a serial interface. A

#### Create an hla program to perform two data conversions

Using Floating Point Unit and the switch statement Create an HLA program to perform the following: -Two data conversions (decimal,binary,hex) -Two measurement calculations (mi

#### Simplify the equations using a k-map and draw final circuit

Write the full equations to light the bottom segment of a 7-segment display. INLCUDE the hexadecimal digits too ( b, c, d, and E ). Then simplify the equations using a k-map

#### Find the induced emf and the armature current of generator

In a 120V compound generator, the resistances of the armature shunt and series windings are 0.06 ohm, 25 Ohm, and 0.04 Ohm respectively. The load current is 100A at 120V, fi

#### Determine the total armature power developed when working

A 25KW, 250V dc shunt generator has armature and field resistances of 0.06 ohm and 100 ohm respectively, determine the total armature power developed when working (1) as a g

#### Find the average power delivered the resistor

when an AC source is connected accross a 12.0 resistor,the rms current in the resistor is 8.00 A find (a) the rms voltage accross the resistor,(b) the peak voltage of the s