Determine which is a better site for wind power generation

Assignment Help Civil Engineering
Reference no: EM13533375

1.Two sites are being considered for wind power generation. In the first site, the wind blows steadily at 7 m/s for 3000 hours per year, whereas the second site the wind blows at 10m/s for 2000 hours per year. Assuming wind velocity is negligible at other times for simplicity, determine which is a better site for wind power generation. Hint: note that the mass flow rate of air is proportional to wind velocity.

2.An apple“weighs” 60 grams and has a volume of 75cm3 in arefrigerator that has a constant temperatureof 8 C. What is the apple’s approximate density. List three intensive and two extensiveproperties of this apple. (2.197thS)

Reference no: EM13533375

Questions Cloud

Dynamic viscosity of the liquid between the plates : The relative velocity of two infinitely wide parallel plates thatare 1cm apart is 10cm/s. If the dynamic viscosity of the liquid between the plates is 0.001 N s/m2 what is the shear stress between the plates?
Calculate the consolidation settlement expected : For the profile shown, the initial ground water table is 5 ft belowthe surface. A proposed dewatering project will cause the watertable to drop 10 ft from the original level. Consolidation tests performed on clay samples produced the following result..
Find the normal strains in these two directions : If the normal stresses in the x and y direction are given byσx and σy, find the normal strains in these two directions.
Determine the rate of evaporation of water : Water is to be boiledat sea level in a 30 cm diameter stainless steel pan on top of a3-kW electric burner. If60% of the heat generated by the burner is transferred to thewater during boiling, determinethe rate of evaporation of water.
Determine which is a better site for wind power generation : Two sites are being considered for wind power generation. In the first site, the wind blows steadily at 7 m/s for 3000 hours per year, whereas the second site the wind blows at 10m/s for 2000 hours per year
Four forces act on a small airplane : The slope distance and zenith angle measured from point P to pointQ were 1876.253m and 87.33'24 degrees, respectively. The instrumentand rod target heights were equal. If the elevation of point P is227.965m, above datum, what is the elevation of poin..
How long will it take him to reach the same velocity the : For the free-falling patachutist with linear drag, assume a firstjumper is 70 kg and has a drag coefficient of of 12 kg/s. If a second jumper has a dragcoefficient of 15 kg/s and a mass of 75 kg, how long will it take him to reach the same velocity t..
Provide your code for completing curve fitting : Plot ω vs t, marked by red stars. Label the x-axis, t,and the y-axis, ω. Give the plot a suitable title. Add a legend to the plot describingthe relationship between ω and t. Change the y-axis scale to show the plotfrom estimate ω is -100 to 1100.
Balance the following acid base neutralization reaction : Balance the following acid base neutralization reaction. Identifythe acid and the number of equivalents per mole. Identify the baseand the number of equivalents per mole.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Calculate the number of gas transfer units

The gas flow rate is 1 kg m-2 s-1 of and the water entering is 1.6 kg m-2 s-1. For this system Henry's law holds and ye=1.75x, where ye is the mol fraction of A in the vapour in equilibrium with a mole fraction of x in the liquid.

  What is the direction and magnitude of the magnetic field

A proton feels a force of 2.0 micro-Newtons in the negative x-direction when it is moving in the positive y direction with a speed of 2.0 x 107 meters per second.

  Strength to operate the pulley

If the difference in weight between the two baskets must greater than 15 lb they will not have the strength to operate the pulley. The King weighs 195 lb, the princess weighs 105 lb, and the prince weighs 90 lb.

  Calculate kg per day of sludge process if sludge is solid

The effluent contains 20 mg/L of solids and 20 mg/L of BOD the biological treatment process produced .32 kg of bacterial solids per kg of BOD removed

  Calculate the decay rate of radon in units of hr-1

Indoor Air quality is greatly affected by Radon, which can cause lung cancer. When we moved to Colorado, we tested the house for Radon and installed a radon mitigation system.

  Determine the maximum allowable tensile force

An aluminum link is subjected to axial tension. The loading is limited by the conditions of not yielding and not elongating excessively. The yield limit is satisfied if the stress remains below 50%of the 325M Payield stress.

  Determine what is the standard deviation in w given the fact

You arrive at your bus stop at some random point in the cycle, what is your expected wait time, w(t), to board a bus. Be sure to show your work or you will lose points. What is the standard deviation in w(t) given the fact that there is no bus wait..

  What is the equilibrium concentration of elemental mercury

Biota can uptake and bioconcentrate compounds through vapor phase absorption. For example, leaves exposed to elemental mercury vapors will absorb the mercury into the aqueous phase and the lipid phases of the leaves. Kow for mercury = 4.17.

  Determine the amount of oil and money saved per year

The maximum flow rate of a standard shower head is about 3.5 gpm and can be reduced to 2.75 gpm by switching to a low-flow shower head that is equipped with flow controllers. Consider a fam- ily of four, with each person taking a 6-minute shower e..

  What force must be applied at each connection

A concentrated downward force of 2000 lb. is located 6' from the left support, and a uniformly distributed load of 200 lbs./lin. ft. begins 6' to the right end of the member. What force must be applied at each connection to maintain equilibrium?

  Find an expression for the diameter of the droplet

find an expression for the diameter, D, of the droplet, in terms of the specific weight and surface tension, assuming the contact angle just before seperating is zero.

  Determine the minimum volume flow rate needed to tip

a 10 mm diameter jet of water is deflected by a homogeneous rectangular block (15 mm by 20 mm by 100 mm) that weighs 6 N. Determine the minimum volume flow rate needed to tip the block over

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd