Determine what is the discharge of each hole

Assignment Help Civil Engineering
Reference no: EM13320039

a water of 20 c temprature pupped at 75 kpa to a perforated pipe 5 cm dia. contain 10 hole with the same diameter. the distance between two adjacent hole is 20 cm. what is the discharge of each hole?

Reference no: EM13320039

Questions Cloud

Calculate the first-excited state energy : Calculate the first-excited state energy (in eV) for an electron in a box (an infinite well) having a width of 0.050 nm
Explain percentage of the calorie content of the food is fat : a) A particular chip snack food is composed of 11% protein, 10.% fat, and the rest carbohydrate. What percentage of the calorie content of this food is fat in%? b) How many grams of protein provide the same fuel value as 40. g of fat in g?
What is the potential difference across the third resistor : A 9.0 V battery and three resistors are all connected in series. What is the potential difference across the third resistor
What is the average induced emf in the loop : Consider a rectangular loop of wire 6.8cm by 7.8cm in a uniform magnetic field of magnitude 1.4T. What is the average induced emf in the loop
Determine what is the discharge of each hole : a water of 20 c temprature pupped at 75 kpa to a perforated pipe 5 cm dia. contain 10 hole with the same diameter. the distance between two adjacent hole is 20 cm. what is the discharge of each hole
Determine elevation of point b from the elevation of a point : To determine the elevation of a point B from the elevation of a point A, which is 511.6 ft. When the transit was set up over the point A, the height of the transverse axis above that point was 4.92 ft.
Find ratio of velocities : Threshold freq. of metal isf0. When the light of freq. 2f0 is incident on the metal max velocity of electrons is v1 and v2
What is the half-life of the material : In 2.8 days the number of radioactive nuclei decreases to one-eighth the number present initially
How to calculate the value of the ksp : A saturated solution of magnesium hydroxide in equilibrium with undissolved solid is prepared at 25C. The pH of the solution is 11.03. Calculate the value of the Ksp

Reviews

Write a Review

Civil Engineering Questions & Answers

  How long did take for the rocket to reach that max height

At that time, there is no more fuel in the rocket engine and the rocket continues upwards in free fall (g=0 ft/sec/sec). (a) How high will the rocket reach before it begins to fall back to the campus

  Draw the influence line for the shear in panel cd of girnder

Draw the influence line for the shear in panel CD of the girder. Determine the maximum negative live shear in panel CD due to a uniform live load of 500 lb/ft action on the top beams.

  Find velocity of bullet immediately after passing through b

A 30 g bullet is fired with a horizontal velocity of 450 m/s through 3-kg block B and becomes embedded in carrier C which has a mass of 30 kg. After the impact, block B slides 0.3m on C before coming to rest relative to the carrier.

  Determine the quantity of sludge wasted daily

An activated sludge system operates at a flow rate (Q) of 400 m3/day with an incoming BOD (So) of 300 mg/L. Throughout pilot plant work, the kinetic constants for this system are determined to be Y = 0.5 kg SS/kg

  How high can students climb just before the pole buckles

Assuming the center of gravity of the student aligns with the axis of the pole and the pole has an elastic behabior, how high can they climb (in meters, m) just before the pole buckles

  Find the piles axial capacity if k is assumed to be 7

A 12-in. square concrete pile is driven into loose sand to a depth of 30 feet. Unit weight is 118 pcf, internal friction is 30 degrees. Find the pile's axial capacity if K is assumed to be 0.7 and the factor of safety is 2.

  Determine estimated unknown speed if the data were obtained

In an attempt to estimate the speed of a vehicle just before it hit a traffic signal pole, a traffic engineer measured the length of the skid marks made by the vehicle and performed trial runs at the site to obtain estimate if the coefficient of f..

  How to solve for the deficit concentration as function of x

Develop the mass balance equation and solve for the deficit concentration as a function of x, u, Lo, Do, ka, kd,and ks in the stream. Lo ans Do are the initial concentrations of BOD and DO deficit in the stream at x

  Were the rumble strips effective in reducing average speeds

A before-and after speed study was conducted to determine the effectiveness of a series of rumble strips installed approaching a toll plaza to reduce approach speeds to 40 mi/h.

  Estimate particle size that will be collected with 50percent

The inlet gas velocity is 16m/s and the particle density is 1.6 gm/cc. The working temperature of the process is 400K. Estimate the particle size that will be collected with 50 percent collection efficiency.

  Determine the density of the traffic stream in the lane

you measure the average headway and average spacing of passing vehicles as 3.2 seconds and 165 ft, repsectively. calculate the flow, average speed, and density of the traffic stream in this lane.

  Find the velocity at which shuttle hits the player bs racket

In Singles badminton game, shuttle is smashed by Player A from close to base line, which is 6 m from the net. Height of the net to be cleared by a smash is 1.55 m. The shuttle is hit by player A at a speed of 250 km/h.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd