Determine the weight of the satellite in pounds when it

Assignment Help Civil Engineering
Reference no: EM13562645

1.A column has a mean capacity of 950 kip. The standard deviation for the column capacity is 50 kip. The average load is 700 kip with a standard deviation of 75 kip. What is the probability of failure, pf?

2.A satellite would have a mass of 200 kg on the surface of the moon. Determine the weight of the satellite in pounds when it is in orbit 10,000 mi. above the surface of the earth.

Reference no: EM13562645

Questions Cloud

What is the maximum amount of cargo : A small truck is to be driven down a 4% grade at 70mi/hr. The coefficient of road adhesion is 0.95, and it is known that the baking efficiency is 80% when the truck is empty and decreases by one percentage point for every 100 lb of cargo added. Ignor..
What is the maximum weight wmax of the crate that the system : Rope BCA passes through a pulley at point C and supports a crate at point A. Rope segment CD supports the pulley and is attached to an eye anchor embedded in a wall. Rope segment BC creates an angle of
Channel is designed to carry a discharge : A 10-feet trapezoidal channel is designed to carry a discharge of 1,000cfs with side slopes: Z1 = 4 and Z2 = 5.  The channel bed slope is 0.04 ff/ft and has Manning's N of 0.03. To protect the channel from erosion
Obtain the change in the entropy of the water : A freezer is used to freeze 3.0 Lof water completely into ice. The water and the freezer remain at aconstant temperature of T = 0°C. Determine the change in the entropy of the water
Determine the weight of the satellite in pounds when it : A satellite would have a mass of 200 kg on the surface of the moon. Determine the weight of the satellite in pounds when it is in orbit 10,000 mi. above the surface of the earth.
Determine how fast does the spot of laser light sweep : A turntable that turns 10 revolutions each second is locatedon top of a mountain. how fast does the spot of laser light sweep across cloudsthat are twice as far away
Determine the concentration of ubod in the effluent : If the length of the river connection between the two lakes is equal to 3km and the velocity in the river is equal to 0.4 m/s, determine the concentration of UBOD in the effluent from the second lake.
Calculate the angles most probable value : An angle is observed repeatedly using the same equipment and procedures. Calculate a) the angle's most probable value, b) the standard deviation, and c) the standard devaition of the mean
Determine how many years from now the consumption will reach : A community has a current population of 15,000. 10 years ago, the population was 12,500 and the community has a declining growth rate with a saturation population of 22,000. The total water consumption for the community at present is 2.25 million gal..

Reviews

Write a Review

Civil Engineering Questions & Answers

  An undisturbed soil sample has a dry unit weight of 112 pcf

1.an undisturbed soil sample has a dry unit weight of 112 pcf with a specific gravity of solids equals to 2.68.awhat is

  Calculate the heat transfer required to do quality in btu

A rigid 1ft^3 vessel contains R-134a originally at -20F and 27.7% quality. The refrigerant is then heated until its temperature is 100F. Calculate the heat transfer required to do this, in Btu.

  What is the significance of the splitting tensile strength

what is the significance of the (a) compressive strength of concrete, (b) splitting tensile strength, and (c) flexural strength of concrete

  Calculate the stress at failure of a concrete test cylinder

Calculate the stress at failure of a concrete test cylinder with a measured diameter of 152.4 mm and a recorded load of 371,426N. Units of ksi.

  Mass flow raw through the nozzle

Air enters an adiabatic nozzle steadily at 300 kPa, 200 o C, and 30 m/s and leaves at 100 kPa and 180 m/s. The inlet area of the nozzle is 80 cm 2 . Determine (a) the mass flow raw through the nozzle, (b) the exit temperature of the air, and (c) the ..

  Write a c program that calculates the factorial of numbers

Write a C program that calculates the factorial of the number from 0 to the integer N, which is not greater than 10

  Formulate and solve the minimum weight design

consider the cantilever beam-mass system. formulate and solve the minimum weight design.

  Is this a good settling sludge or this operator in trouble

A waster water treatment operator runs a sludge volumeindex test in a liter cylinder and finds at the end of 30 minutessettling, the solids occupy 200mL. He knows the suspendedsolids concentration in his aeration tank from which he got thesample is 4..

  How many grams of water are in the same solution

How many grams of perchloric acid, HClO4, are contained in 37.6 g of 70.5 wt% aqueous perchloric acid. How many grams of water are in the same solution.

  Determine the approximate dimensions of each carbon

A two-bed carbon adsorption system is to be designed to handle 8000 acfm of air containing 700 ppm of hexane. Laboratory studies indicate that carbon can adsorb 8lb hexane per 100 lb carbon under the conditions at which the system will be operated.

  What annual volume savings will wastewater achieve

The Pomdeterra wastewater treatment plant produces thickened sludge that has a suspended solids concentration of 3.8 percent. They are investigating a filter press that will yield a solids concentration of 24 percent.

  Find what would be the minimum number of truckloads

Soil is excavated from a borrow to construct an embankment with a net volume of 50,000 cy with 95% of Modified Proctor maximum dry density of 110 pcf with a Modified Proctor optimum water content of 8%.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd