Determine the velocity as a function of position

Assignment Help Civil Engineering
Reference no: EM13557063

1.A particle travels along a straight line with a constant acceleration. When s=4ft, v=3ft/s and when s=10ft, v=8ft/s. Determine the velocity as a function of position.

2.Atmospheric air is at 101 kPa (abs) and 25 degrees C. Determine (a) the density of the air (b) the molar specific volume of the air. Work out problem completely please. I already have the answers a) 1.18 kg/m^3 b) 24.5 m^3/kmol

3.A spherical pressure vessel has an outer diameter of 10 ft and a wall thickness of 0.5 in. knowing that for the steel used ?all= 12 ski, E= 29 x 10^6 psi, and v= 0.29, determine

(a) the allowable gage pressure,

(b) the corresponding increase in the diameter of the vessel.

Reference no: EM13557063

Questions Cloud

What is the concentration of particles in the air : A hi-vol clean filter weighs 18.00 g. After a 24 hour sampling period the filter is removed and weighs 18.65 g. The initial flow rate through the filter was 2.5 m3/min. When the filter was removed the flow rate through the filter was 1 m3/min. What i..
Determine the magnitude of the force of the rod on the : Using a forked rod, a smooth cylinder C having a mass of 0.5 kg is forced to move along the vertical slotted path r = 0.5? m, where ? is in radians. If the angular position of the arm is ?
Determine the maximum force p that can be applied without : Determine the maximum force P that can be applied without causing the two 50-kg crates to move. The coefficient of static friction between each crate and the ground is 0.25 The crates are next to each other connected
Find the required energy input ep and p to be supplied by : Find the required energy input Ep and ?p to be supplied by the pump. Assume the electric motors are set to turn the centrifugal pump impeller at ? = 4000 rpm
Determine the velocity as a function of position : A spherical pressure vessel has an outer diameter of 10 ft and a wall thickness of 0.5 in. knowing that for the steel used ?all= 12 ski, E= 29 x 10^6 psi, and v= 0.29, determine (a) the allowable gage pressure, (b) the corresponding increase in the d..
Obtain estimates of the pressure using the vander waals : Consider high pressure steam at 400 degrees C and v =0.01567 m^3/kg. Obtain estimates of the pressure using
Find the maximum load p that can be applied as shown : The 4-mm diameter cable BC is made of a steel with E= 200 GPa. Knowing that the maximum stress in the cable must not exceed 190 MPa and that the elongation of the cable must not exceed 6mm, find the maximum load P that can be applied as shown.
What is the displacement and acceleration of the automobile : What is the displacement and acceleration of the automobile at t-15, 45, and 50 seconds. Construct a v--t graph from 0 to 50 seconds.
What is the minimum radius of curvature for a curve such : The coefficient of friction between a car’s tires and the road is such that the car can generate a maximum deceleration of 1.1g without experiencing slip. What is the minimum radius of curvature

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the change inside diameter when the gun is fired

a navel gun (E= 30,000 ksi and G = 11,600 ksi) with a bore of 16 in. develops a maximum internal pressure of 20,000 psi. Determine a. the minimum outside diameter required if the maximum tensile stress permitted in the gun barrel is 36,000 psi.

  How to formulate a set of constraints that will enforce

Given the binary variables x1,x2,x3,x4 and x5, formulate a set of constraints that will enforce x3,x4, and x5 to equal one if x1=1 and x2=0.

  Determine the corresponding flood peak of the runoff using

The vertical effective stress at a certain point in a loose sand is 1000lb/ft^2. If an earth quake were to occur, how much excess pore water pressure would need to develop at this point for liquefaction to occur? Show a numerical rationale for your a..

  Determine how many tons of aggregate will be needed

Base course aggregate has a target dry density of 119.7 lb/cu ft in place. It will be laid down and compacted in a rectangular street repair area of 2000 ft*48ft*6in.

  Determine point of application from the base of wall

he top of the soil is level with the top of the wall, and the soil carries a uniformly distributed load of 500 psf. Calculate the total active earth force of the wall per linear foot and determine its point of application

  Determine what is ow rate of sea water through the tunnel

Google budgets for an energy consumption of the pump for this system of 2MW. If the pump 1 has an efciency of n= 87%, what is the ow rate of sea water through this tunnel

  What are the annual runoff coefficient for the sub areas

What are the annual runoff coefficient (Runoff /Rainfall ratio) for the sub areas and for the total watershed taken as whole Sub-area Area (m2)/ Annual Precipitation (mm)/ Annual Evaporation (mm) A 10.7 1030 530 B 3.0 830 438 C 8.2 900 430 D 17...

  The quality of the working fluid as it exists the 2 turbine

A 60 MW Rankine steam power cycle in Iceland uses reheat. The system is comprised of a single adiabatic pump, a boiler using geothermal energy, two adiabatic turbine stages and a condenser. Water as the working fluid, which enters the 1st turbine sta..

  What were the magnitude and the direction of the velecity

If friction between the cars and the rails is neglected, what were the magnitude and the direction of the velecity of the cars after the collision?

  Determine what would be the flow rate in gpm

Suppose that a water treatment plant has a Parshall Flume with a 4 ft wide throat. a) If the upstream depth of the water (ha) is 1 ft and the depth of the water in the throat section (hb) is 0.65 ft, what is the flow rate in gpm

  Which reactor should be preferred for the treatment plant

Chemical ‘A' is regulated by EPA and the maximum allowable concentration in water is 5 ?g/L. Design a reactor for a water treatment plant where 1000 ppm of chemical ‘A' is introduced at a flow rate of 100 m3/min.

  Compute the sorbed concentration in equilibrium with the

If the pH of the water is raised to 8.5, what is the equilibrium concentration of the chromium (III) in moles/L? (d) What weight (in pounds) of precipitate is formed if groundwater containing 19,000 mg/L chromium is treated as described in part (c) a..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd