Determine the true horizontal length of the recorded slope

Assignment Help Civil Engineering
Reference no: EM131146830

For the tape of Problems 6.8 through 6.11, determine the true horizontal length of the recorded slope distance BC for the conditions shown in Problems (Assume the tape was fully supported for all measurements.)

744_c6cb048a-905b-44b1-b334-52c14d01b0ad.png

Problem 6.8:

A 100-ft steel tape of cross-sectional area 0.0025 in.2, weight 2.3 lb, and standardized at 68°F is 99.992 ft between end marks when supported throughout under a 12-lb pull. What is the true horizontal length of a recorded distance AB for the conditions given in Problems (Assume horizontal taping and all full tape lengths except the last.)

Reference no: EM131146830

Questions Cloud

What distance corresponds to each nanosecond of time : Using the speed of electromagnetic energy given in Problem 6.23, what distance corresponds to each nanosecond of time?
What are at least three different sources of groceries : What are at least three different sources of groceries, and how do those sources vary economically from one community to another
What is the system measurement constant for this equipment : What is the system measurement constant for this equipment? Compute the length of each segment corrected for the constant.
Write a paper on given topic : Write a paper regarding the use of the Spearman rank correlation coefficient by Messina, "The Relationship between Patient Satisfaction and Inpatient Admissions Across Teaching and Nonteaching Hospitals."
Determine the true horizontal length of the recorded slope : A 100-ft steel tape of cross-sectional area 0.0025 in.2, weight 2.3 lb, and standardized at 68°F is 99.992 ft between end marks when supported throughout under a 12-lb pull. What is the true horizontal length of a recorded distance AB for the cond..
Construct ad sras and lras curves for an economy experience : Construct the AD, SRAS, and LRAS curves for an economy experiencing: (a) Full employment, -figure A (b) An economic boom,-figure B (c) A recession- figure C
Describe in detail all the modules included in the two tier : 1. Describe in detail all the modules included in the two-tiered selection system proposed by the team. 2. What is the critical analysis of the case study relevant to human resource management? 3. What is the vital ethical issue of the case study?
Compare positive and negative reinforcement : In your own words, compare positive and negative reinforcement. Include the basic types of reinforcers in your response, and give an example of each
Prepare the analyses and financial statements requested : Prepare the analyses and financial statements requested in the caseproblem 4B-4, Page 179 of your textbook using an Excel spreadsheet. Note the check figure provided (Net Income = $1,012).

Reviews

Write a Review

Civil Engineering Questions & Answers

  Calculate the speed of the car at the onset of skidding

A car collided with a telephone pole and left 20 ft skid marks on the dry pavement. Based on the damages sustained, an engineer estimated that the speed at collision was 15 mph. If the roadway had a +3% grade, calculate the speed of the car at the..

  Write a paper which discusses qualitative research designs

Choose two research papers-one quantitative and the other qualitative-from the construction management literature - Write a paper (not less than 3,000 words) which discusses in detail the extent to which the authors of your papers followed in their ..

  Explain what type of heat transfer mechanism is employed

A 40 oF breeze of 10 miles per hour blows over the top of a round open-top water cooling tank which has a bulk temperature of 100 oF. What is the rate of energy in kW that enters into the air What type of heat transfer mechanism is employed in thi..

  Compute required weight of coarse aggregate per cubic yard

A concrete mix with a 3-inch slump, w/c ratio of 0.50, and sand with a fineness modulus of 2.4 contains 1700 lb/yd^3 of coarse aggregate. Compute the required weight of coarse aggregate per cubic yard.

  Determine the maximum normal strain developed in the board

The man has a mass of 65kg and stands motionless at the end of the diving board. If the board has the cross section, determine the maximum normal strain developed in the board. The modulus of elasticity for the material is E = 117GPa

  Find the mass of the vehicle and the stiffness and damping

An automobile modeled as a single-degree-of-freedom system free to vibrate in the vertical direction. In a free vibration test the amplitude of oscillation is observed to decrease from 20mm to 2 mm in one cycle which takes 3 seconds.

  Is this a reasonable claim

A cooling tower with a cooling capacity of 100 tons (440 kW) is claimed to evaporate 15,800 kg of water per day. Is this a reasonable claim?

  Determine volume required for trickling filtration treatment

For a flow of 2 MGD, an influent BOD of 200 mg/l, a depth of 8 feet, and a desired effluent BOD concentration of 20 mg/l, determine the volume required for trickling filtration treatment as predicted for single-stage treatment by using NRC equatio..

  Determine the size of pipe for a water temperature

The difference in water level is 60ft. Determine the size of pipe for a water temperature of 60 degrees Fahrenheit. Apply The Darcy-Weisbach equation.

  Calculate how many assemblies the inspector may inspect per

A grievance has been filed by the union at Dorben Co. regarding the final inspection station, in which the operator slightly lifts a 20 lb assembly, examines all sides, and, if acceptable, sets it back down on the conveyor, where the assembly goes to..

  What is classification of soil using of agriculture textural

What is the classification of the following soil using the united states department of agriculture textural classification chart

  Determine maximum compression of spring mounted on car

The 30-Mg freight car A and 15-Mg freight car B are moving toward each other with the velocities VA= 20 km/h to the right and VB= 10 km/h to the left. the spring constant on car A is k= 3MN/m.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd