Determine the total power in fm signal

Assignment Help Electrical Engineering
Reference no: EM13229552

An FM signal being transmitted is represented by eFM(t) = 50Sin((2)(95.1)(106)t+2Sin((2)(10)(103)t)). If the antenna impedance is 75 , determine: (a) total power in FM signal and (b) FM modulation index.

Reference no: EM13229552

Questions Cloud

What are earnings as a percentage of the final retail price : In the electronics business, mark-up is in the order of 100% to 130% at each level of middleman. Let's say that it is 100%. Let's further say that your product passes through three levels of middleman, that your product is produced in accordance
Explain how to recover the increased design cost : a cost to produce, P, of $4.00. If we were able to reduce this to $3.55 through greater attention in the design, and if the cost to improve the design (in NRE) is $35,000, how many units must we sell to recover the increased design cost
Examine the role of advertising and promotion management : Examine the role of advertising and promotion management in contemporary marketing and develop an understanding of integrated marketing communications, including the coordination of the various promotional mix elements
Find the reflection coefficient at the load : A 75- ohm lossless transmission line is interfaced to a load impedance that consists of a series connected resistor of 30 ohm and a capacitor of 10 pF. At an operating frequency of 2 GHz and for a wavelength of 10 cm.
Determine the total power in fm signal : An FM signal being transmitted is represented by eFM(t) = 50Sin((2)(95.1)(106)t+2Sin((2)(10)(103)t)). If the antenna impedance is 75 , determine: (a) total power in FM signal and (b) FM modulation index.
What is the adt output for a temperature of 81 degrees : A HCS12 ATD is set to 10-bit unsigned mode. The voltage references are set to ground and 1.0V What is the ADT output for a temperature of 81 degrees The temperature sensor measures 0 to 100 degrees with an output of 10 mV/degree.
Determine the 60-hz resistance of the line in ohms : A 60-Hz, 765-KV three-phase overhead transmission line has four ACSR 900 kcmil 54/3 conductors per phase. Determine the 60-Hz resistance of this line in ohms per kilometer per phase at 50 degrees Celsius.
Compute the molar solubility : The Ksp of AgCrO4 is 1.9 x 10^-12. Calculate the molar solubility (in mol/L) of Ag2CrO4 in 0.1 M AgNO3.
How the temperature switch turns on the white pilot light : PLC 2 In a motor control system, one master stop pushbutton (Stop) is available for stopping the operation at any time. If the temperature switch (TSW) is closed, pressing the red pushbutton (RedPB) will turn on both motors M1 and M2.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  What word length is required for an adc

What is the resolution of an ADC with a word length of 12-bits and an analogue signal input range of 100 V A sensor produces a maximum analogue output of 5V. What word length is required for an ADC if there is to be a resolution of 10mV

  Computing a dc current through the telephone handset

Calculating a DC Current through the telephone handset, A telephone handset has a resistance of 600 ohm. It is connected to the local telephone exchange at a distance of 5 km by a twisted pair that has a loop resistance of 200 ohm per km

  What is the minimum value of t for reliable data sample

A 10-bit unipolar ADC with a reference of 5.00 F and a 44 micro seconds conversion time will be used to collect data on time constant measurement. Thus, the input will be of the form V (t) = 4(1-e^t/T) . What is the minimum value of T

  Find real part of the network is a series rlc

Consider a network with a driving-impedance Z. (1) Find expression for P and Q. (2) Find p(t) in terms of P and Q. (3) Suppose that the network is a series RLC. Interpret the result in part (2).

  How far away can the cars radar detector receiver detect

A police K-band radar is operating, with transmit power of 1000 Watts and antenna gain of 300 in linear units. The radar unit is designed to detect a target with a radar cross-section (RCS) of 6 sq. meters and its receiver can detect a signal

  What should be the filter''s passband cut-off frequency

What should be the filter's passband cut-off frequency?(DSP Question).

  Calculate the sacrifice ratio

Inflation in years 1-5 equals 3.1 percent, 2.2 percent, 1.6 percent, 1.3 percent, and 1.1 percent, respectively.

  What is maximum possible power that could have been generate

The One river Hydroelectric Project generated power for BPA along the Two River from the early 1800s until 1900, when it was decommissioned due to environmental issues. The maximum flow rate through the system was 25 m3/s, and the hydraulic head w..

  Implementation of algorithm using vhdl under quartus

Implementation your algorithm using VHDL under Quartus. You are free to select the structural hierarchy of the implementation; the implementation could be behavioral, structural, or a mixed implementation. which the linear interpolation is to be e..

  What is the blocking probability of the system

What is the blocking probability of the system in (b) when the maximum number of users are available in the user pool?

  Calculate the gain and bandwidth after the feedback

Single pole amp. has an open loop gain 10^6 and open loop bandwidth of 10Hz. If the feedback factor =1, calculate the gain and bandwidth after the feedback

  What is the energy storage capacity of the battery

A certain 11 V dry-cell battery, completely discharged, requires a current of 100 mA for 1.2 hr to completely recharge. What is the energy storage capacity of the battery, assuming the voltage does not depend on its charge status?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd