Determine the time rate of change of pressure at x

Assignment Help Civil Engineering
Reference no: EM13317287

A gas flows along the x axis with a speed of v = 5x m/s and a presure of p = 10x^2 N/m^2, where x is in meters.

a) Determine the time rate of change of pressure at the fixed location x = 1.

b) Determine the time rate of change of pressure for a fluid particle flowing past x = 1.

c) Explain without using any equations why the answers to parts a and b are different.

Reference no: EM13317287

Questions Cloud

Find the net electric flux through the hull of the submarine : The following charges are located inside a submarine: 4.00, -8.00, 25.0, and -60.0. find the net electric flux through the hull of the submarine
Find the probability that the drawn marble is blue or red : A marble is drawn at random from a box containing 10 red, 30 white, 20 blue, and 15 orange marbles. Find the probability that is: (a) orange or red (b) not red or blue (c) not blue (d) white (e) red, white, or blue
Find how high above the ground was the package : A package is dropped from a helicopter moving upward at 15 m/s. If it takes 24 s before the package strikes the ground, how high above the ground was the package
What is the instantaneous velocity of the object : The position of an object as a function of time is given by x = bt2 - ct, where b = 2.0 m/s2 and c = 6.7 m/s, What is the instantaneous velocity of the object
Determine the time rate of change of pressure at x : A gas flows along the x axis with a speed of v = 5x m/s and a presure of p = 10x^2 N/m^2, where x is in meters. a) Determine the time rate of change of pressure at the fixed location x = 1.
Determine the internal resistance of the battery : Assume a load resistor RLoad is placed in parallel with a 12 volt battery and you measure the voltage across this resistor to be 6 volts
Find the electrical potential in the center of the cube : A cube is constructed of six copper plates joined at the edges by an insulating material. find the electrical potential in the center of the cube
What is the required diameter of the shaft : The solid shaft in is made from brass that has an allowable shear stress = 100 MPa and a shear modulus of elasticity G = 39 GPa. what is the required diameter of the shaft
How much does the point move down : A walkway suspended across a hotel lobby is supported at numerous points along its edges by a vertical cable above each point and a vertical column underneath. how much does the point move down

Reviews

Write a Review

 

Civil Engineering Questions & Answers

  Determine what velocity would be expected to parking lot

A 200 foot long, 2.5 feet in diameter, straight, corrugated metal storm drain pipe, is used to drain a parking lot. The elevation difference between the pipe ends is 8 feet. What velocity would be expected

  Determine the cod

Determine the COD, carbonaceous BOD, and nitrogenous oxygen demand of a 100 mg/L solution of urea (N2H4CO)

  Tightening of bolt in the friction grip

What difference does the tightening of bolt in the friction grip joint make to the load at first slip and the failure load.

  Net rate of flow of linear momentum via control surface

Measurements indicate that to cause this flow the force acting on the contents of the control volume is 40i lb. Determine the net rate of flow of linear momentum through the control surface.

  Write a c code for two classes one being automobile

write a c++ code for two classes one being automobile and one being motorcycle both being the base class then at least one derived class from each

  What is the width of the second floor

A cross section of a cottage, 20 ft wide, is an isosceles triangle. If the slope of a side is 1.75 and there is a second floor 8 ft above the ground floor, what is the width of the second floor?

  Determine the most economical alternative of return analysis

Using Rate of Return Analysis, determine the most economical alternative below. Assume a minimum attractive rate of return of 6%, and a 5-year life with no salvage value for each. The alternatives are mutually exclusive

  Determine what is the value of degree for the sand

A square footing 0.3 m by 0.3 m is placed on the surface of a dense cohesionless sand (unit weight = 18.2 KN/m^3) and subjected to a load test. If the footing fails at a load of 13.8 KN, what is the value of (degree) for the sand

  What is the corresponding amplitude of the acceleration

calculate the amplitude F0 of the sinusoidal excitation force that is necessary to produce a steady-state vibration with a velocity amplitude of 10 m/s at resonance. what is the corresponding amplitude of the acceleration

  Find water depth just upstream of high broad-crested weir

Find the water depth just upstream of a 1.5 ft high broad-crested weir in a channel 6ft wide when the flow is 18 cfs

  Determine the degree of saturation after compaction

After compaction the void ratio is reduced to 0.60. Determine: (a) Dry and moist unit weights before and after compaction (b) Degree of saturation after compaction.

  Determine what is the maximum daily mass of chloride

The pipe has a flow of 5 m3/s. The stream's chloride concentration just upstream of the pipe's dischage is 12 mg/L, and the runoff pipe's discharge has a chloride concentration of 40 mg/L. Chloride is a conservative substance.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd