Determine the tension in the support cable

Assignment Help Civil Engineering
Reference no: EM13532271

A sailor is being rescued using a boatswain's chair that issuspended from a pulley that can roll freely on the support cableACB amd is pulled at a constant speed by cablle CD. Knowing thatα=30degrees and β=10 degrees and that combined weight of the boatswain's chair and the sailor is 900N, determine the tension(a) in the support cable ACB, (b) in the traction cable CD.

Reference no: EM13532271

Questions Cloud

Determine the percent reduction in the required force when : A 50 cm by 20 cm block weighing 150 N is to be moved at aconstant velocity of .8m/s on an inclined surface of 20 degreesfrom horizontal with a friction coefficient of .25.
Determine the reduction of capillary rise if the contact : Determine the reduction of capillary rise if the contact angle representing the adhesion between water and soilmaterial is increased from 30 degrees to 60degrees.
Determine the magnitudes of the other forces : A welded connection is in equilibrium under the action of thefour forces shown. Knowing that Fa=8kn and Fb= 16kN, determine the magnitudes of the other forces.
Determine whatpressure head is needed from the pump : A WTP Operator is trying to size a pump that takes water from a WTPholding tank and sends it to a house on a hill above theplant. The operator's goal is to have 60 psi of waterpressure entering the house. The operator knows that the head loss (major+..
Determine the tension in the support cable : A sailor is being rescued using a boatswain's chair that issuspended from a pulley that can roll freely on the support cableACB amd is pulled at a constant speed by cablle CD
Determine the intensity w of the maximum distributed load : 1.102 Determine the intensity w of the maximum distributed load that can be supported by the hanger assembly so that an allowable shear stress of τallow = 13.5 ksi is not exceeded in the 0.40-in.-diameter bolts at A and B
Find the load bearing strength of a support beam : Looking a wood (pine) deck material.  It's a simple 8' by 8' deck.  There's a support beam holding up this deck. Other end is connected to building.
Concrete pier is loaded on top with a uniformly : Concrete pier is loaded on top with a uniformly distributed load of600 lbs per square foot.  Investigate the state of stressat a level of 4 ft. above the base.
Relevant materials properties : Whisker filaments of SiC that are 5 μm thick are coated withan aluminum alloy using a chemical bonding process. The coating process is carried out at 650 oC before the sample iscooled to room temperature

Reviews

Write a Review

 

Civil Engineering Questions & Answers

  Calculating the force in a punch press

Calculate the force (in Kn) a punch press must exert if it is to punch out a large washer from a strip of 5-mm thick sheet steel with an ultimate shear strength of 400 MPa.

  Estimate the force on the chimney at the bottom of chimney

The wind blows horizontally in a direction which is parallel to one of the diagonals of the cross section. Careful measurement shows that, at height y from the ground, the magnitude of the wind velocity is given

  Determine what is the outlet air temperature

A total of 13,610 kg/h of air at 1 atm abs pressure and 15.6C is to be heated by passing over a bank of tubes in which steam at 100C is condensing. The tubes are 12.7mm OD, 0.61 m long, and arranged in-line in a square pattern with Sp=Sn= 19.05mm.

  How to compute the final lengths and azimuths of lines

calculate departures and latitudes, misclosures in departures and latitude, and traverse relative precision. Balance the departures and latitude using the compass rule, and calculate coordinates of points B, C, and D.

  What is the maximum annual equivalent amount for the device

An electronic device is available that will reduce year'slabor cost by $10,000. the equipment is expected to last for eightyears. If labor is cost increase at an average rate of 7% per year and the interest rate is 12% per year

  Estimate how much carbon must be purcahsed

Estimate how much carbon (in pounds) must be purcahsed for a typical 2-bed carbon adsorption system to treat 5000 cfm of air at 95 degrees F and 1 atm. The air contains 600 ppm of styrene.

  How many acres should the detention pond be to store

a rainstrom lasts for 90 min at a constant intensity of 3.2 in/hr over a five acre parking lot. a detention pond is used to store all of the runoff from the parking lot and cannot be deeper than 2 ft.

  Explain how and why the rotational restraint at top of wall

The design of a masonry wall to support vertical compression loading is influenced by the same factors that affect the design of all compression elements. One of these factors is the extent of rotational restraint at the top of the wall.

  Calculating coefficient of permeability

The temperature was 200C, and the void ratio (e) of the soil was 0.43. Calculate the "Coefficient of Permeability" in "centimeters per second" (Given, k = (QL)÷(A Δh t)).

  Latent heat of fusion problem

What mass (in grams) of steam at 100°C must be mixed with 387 g of ice at its melting point, in a thermally insulated container, to produce liquid water at 26.0°C? The specific heat of water is 4186 J/kg·K. The latent heat of fusion is 333 kJ/kg, ..

  What annual volume savings will plant have achieve

The Pomdeterra wastewater treatment plant produces a thick sludge that has a suspended solids concentration of 3.8%. They are investigating a filter press that will yield a solids concentration of 24%.

  How many pounds of copper sulfate should be dissolved

You have determined that a 0.5 ppm concentration of copper sulfate should be applied to a lake to control the growth. The lake volume is 50 ac-ft. How many pounds of copper sulfate should be dissolved in the lake

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd