Determine the stresses in the steel and concrete

Assignment Help Civil Engineering
Reference no: EM13211080

For the beam shown, make the following computations:

a) determine the stresses in the steel and concrete under the service loads
b) compute the immediate deflection produced by the total load
c) estimate the additional long-term deflection if the live load acts continuously

use f'_c = 4 kips/in^2, and f_y = 50 kips/in^2

 

Reference no: EM13211080

Questions Cloud

What are the concentrations of cl- and br- : AGNO3 is added to a solution containing 0.001 mol Cl- amd 0.001 mol Br- per liter. What are the concentrations of Cl- and Br- remaining when AgCl just begins to precipitate?
How long ago did the dumping stop : the flow rate into the lake is 10 m3/s, the surface area of the lake is 1 x 107 m2, and the rate of evaporation from the lake is 6 cm/wk, how long ago did the dumping stop?
Explain 2-butanol and t-butyl alcohol : Show reasonable function group test to distinguish between the following compounds and write down their characteristic observation. A) 2-butanol and t-butyl alcohol
Compute the maximum acceptable tensile service load : Compute the maximum acceptable tensile service load T that may act on a single angle L6x4x3/4 that is welded along only one leg to a gusset plate; thus, there are no holes. The service load is three times the dead load. Solve for a0 A36 steel.
Determine the stresses in the steel and concrete : determine the stresses in the steel and concrete under the service loads
What is the station of the pt : a horizontal curve on a single-lane highway has its PC at station 124 + 10 and its PI at station 131 + 40. The curve has a superelvation of 0.06 ft/ft and is designed for 70 mi/h. What is the station of the PT?
Explain the chloroform would remain as liquid in the flask : the chloroform would remain as liquid in the flask after equilibrium is established between liquid and vapor chloroform? (the vapor pressure of chloroform at 20 degrees C is 0.208 atm)
What is the net force acting on the body : Starting from rest, a 4.0-kg body reaches a speed of 8.0 m/s in 2.0 s. What is the net force acting on the body?
Determine the new reading along the inclined leg : If the pressure in pipe B is decreased 10 kPa and the pressure in pipe A remains unchanged, determine the new reading along the inclined leg of the mercury manometer.

Reviews

Write a Review

 

Civil Engineering Questions & Answers

  Elevation of the curve turning point

Set up a table showing curve elevations at the PVC, at the PVT, and at the half-station points along the curve. Compute the station and elevation of the curve turning point.

  Average shearing stress

Two strips of a plastics material are bonded together as shown. The average shearing stress in the glue must be limited to 1000 kpa.

  Long-term average precipitation in the colorado river basin

The long-term average January precipitation in the Colorado River basin is 1.11 inches, with a standard deviation of 0.60 inches. Assuming a normal distribution, what is the probability that less than 0.5 inches of precipitation will occur in any ..

  Determine the maximum service load

Determine the maximum service load W (kips) at the mid-height of the beam-column shown in the accompanying figure 2.1. Assume the member is hinged with respect to bending in both x and y directions at the top and bottom.

  Determine the height of the wake region h

You may assume that the total pressure at the downstream station is uniform across the tunnel and given by the value at the wall. Neglecting gravitational effects.

  Atual discharge of a water pipeline

If the elevation difference between the water surfaces is y = 25 + x/11 metres, what minimum pipeline diameter will be required to convey the design discharge? Once your design is complete, determine the actual discharge. The value of x equals 23.

  Sketch a streamline pathline and streakline

Sketch a streamline, pathline, and streakline, For a given flow the velocity from time t=0 to t=5s was u=2 m/s, v=0. Then from t=5s to t=10s the velocity was u=+3 m/s, v=-4 m/s. A dye streak was started at t=0

  Ehermal conductivity of the radioactive wastes

The outer surface of the tank is cooled by air at 300 K with a heat transfer coefficient of 100 W/m2K. Determine the maximum temperature in the tank. Take the thermal conductivity of the wastes as 2.0 W/mK.

  Darcy-weisbach equation for flow in a pressure conduit

In using the Darcy-Weisbach equation for flow in a pressure conduit, what percentage error is introduced in Q when f is misjudged by 20 percent?

  Depreciation using straight line-double declining balance

Calculate the depreciation using straight-line, double-declining-balance (DBB), and MACRS (current IRS regulation) methods; and tabulate the depreciation schedule.

  Load that a boat can carry without sinking in a lake

The hull of a boat has a volme of 150m and the total mass of the boat when empty is 8560kg. determine how much load this boat can carry without sinking in a lake.

  What superelevation rate would you recommend

What superelevation rate would you recommend for a roadway with a design speed of 100 km/hr and a radius of curvature of 500 m? Assume f = 0.11.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd