Determine the safety against the brittle fracture

Assignment Help Mechanical Engineering

Reference no: EM13718974

An engineering member is to be made of 18-Ni maraging steel (vacuum melted). The member is a plate loaded in tension, and it may have a crack in one edge. The dimensions are width b=35 and t=5.0mm, and the crack may be as long as a=7.0 mm. The member must resist a tension force of P=60KN. Determine

A) the safety against the brittle fracture.

B) the safety factor against fully plastic yielding.

C) the overall (controlling safety factor..

Reference no: EM13718974

Questions Cloud

Determine the air velocity at the exit when inlet velocity : The exhaust nozzle of a jet engine expands air at 388 kPa and 174 C adiabatically to 95 kPa. Determine the air velocity at the exit when the inlet velocity is low and the nozzle isentropic efficiency is 96 percent.

Suspended in a room filled with saturated steam : A 1.2-cm-diameter silver sphere initially at 25°C is suspended in a room filled with saturated steam at 100°C. Using the lumped system analysis, determine how long it will take for the temperature of the ball to rise to 50°C. Also, determine the amou..

How long will it take for the surface temperature : A long aluminium cylinder 50cm in diameter is initially at a uniform temperature of 200°C. It is suddenly subjected to a temperature of 70°C and h = 535W/m2K. How long will it take for the surface temperature to reach 100°C.?

Aerodynamics of a new prototype automobile a scale model : To test the aerodynamics of a new prototype automobile a scale model will be tested in a wind tunnel. For dynamic similarity, it will be required to match Reynolds number between model and prototype.

Determine the safety against the brittle fracture : An engineering member is to be made of 18-Ni maraging steel (vacuum melted). The member is a plate loaded in tension, and it may have a crack in one edge. The dimensions are width b=35 and t=5.0mm, and the crack may be as long as a=7.0 mm.

Use the approximation equation for contact stress : A gear set has a module of 5mm, a 20° pressure angle, and a 24-tooth case-iron spur pinion driving a 48-tooth case-iron gear. The pinion is to rotate at 50 rev/min. What horsepower input can be used with this gear set if the contact stress is limited..

Final equilibrium temperature and entropy generation : A container filled with 73 kg of liquid water at 99ºC is placed in a 60-m3 room that is initially at 12ºC and 1 atm. Thermal equilibrium is established after a while as a result of heat transfer between the water and the air in the room. Using consta..

Determine the final mass of the tank : An insulated rigid tank contains 5 kg of helium gas at 440 kPa and 31C. A valve is now opened, and helium is allowed to escape until the pressure inside drops to 200 kPa. Assuming the helium remaining inside the tank has undergone a reversible, adiab..

Pressure driven flow between stationary parallel plates : Consider the pressure driven flow between stationary parallel plates separated by distance b. Coordinate y is measured from the bottom plate. The velocity field is given by u=U(y/b)[1-(y/b)]. Obtain an expression for the circulation about a closed co..

User Account

All Pages